CIE 46-1979 A Review of Publications on Properties and Reflection Values of Material Reflection Standards (E)《材料反射标准性能值和反射值出版物的回顾(E)》.pdf
《CIE 46-1979 A Review of Publications on Properties and Reflection Values of Material Reflection Standards (E)《材料反射标准性能值和反射值出版物的回顾(E)》.pdf》由会员分享,可在线阅读,更多相关《CIE 46-1979 A Review of Publications on Properties and Reflection Values of Material Reflection Standards (E)《材料反射标准性能值和反射值出版物的回顾(E)》.pdf(100页珍藏版)》请在麦多课文档分享上搜索。
1、- CIE 46 79 I 900b145 OOOL53 280 COMMISSION INTERNATIONALE DE LCLAIRAGE INTERNATIONAL COMMISSION ON ILLUMINATION INTERNATIONALE BELEUCHTUNGSKOMMISSION A REVIEW OF PUBLICATIONS QN PROPERTIES AND REFLECTION VALUES OF MATERIAL REFLECTION STANDARDS PUBLICATION CIE No 46 (TC-2.3) 1979 Photocopy by CENTRA
2、L BUREAU OF THE CIE A - 1030 VIENNA, Kegelgasse 27 - AUSTRIA COPYRIGHT International Commission on IlluminationLicensed by Information Handling Services CIE 4b 79 II 7006145 OOOL854 117 *This report has been prepared by CIE Technical Committee TC-2.3 ttMaterials.lt It has been approved by the majori
3、ty of the Committee and is recommended for study and application. This report is not an Officially Agreed CIE Recommendation approved by the National Committees of the Member Countries. It should be noted that any recommendations in this report are advisory and not mandatory.“ “Ce Rapport a t prpar
4、par le Comit Technique C.I.E. TC-2.3 t1Mat6riaux.1t du Comit, et il est recommand pour tude et application. Ce rapport nest pas une Recommandation officielle de la C. I. E. approuve par les Comits. Nationaux des Pays Membres. Il doit tre not que toute recommandation y figurant est donne a titre de c
5、onseil et non dobligation.t1 I1 a recu lapprobation de la majorit “Dieser Bericht wurde vom Technischen CIE-Komitee TC-2.3 “Leuchtenbaus tof fe“. ausgearbeit der Mitgli.eder des Komitees, angenommen und wird zu reflection factor (45-20-040) Ratio of the reflected radiant or luminous flux to the inci
6、dent flux. synbol: p Radiance luminance factor (45-20-200) (at a point on the surface of a.non-self radiating body, in a given direction, under specified conditions of irradiation illumination) body to that of the perfect reflecting diffuser identically irradiated illuminated. Ratio of the radiance
7、luminance of the symbol: Reflectance factor (45-20-201) (at a point of a surface, for the part of the reflected radiation contained in a given cone with apex at the point of the surface, and for incident radiatiotl of given spectral composition and georneirical distribution) Ratio of the radiant lum
8、inous flux reflected in the direc- tions delimited by the cone to that reflected in the same directions by the perfect reflecting diffuser identically irradiated illuminated. symbol: R (accor6ing to the CIE TC-2.3 publication “Radiometric ad Photcimetric Characteristics COPYRIGHT International Commi
9、ssion on IlluminationLicensed by Information Handling ServicesCIE 46 79 W 9006345 0003867 875 of :!atzrials 3rd Their *?easurenent“; Publication CIS Nr. 38 (TC-3.3) 1977) Note: If the solid mgle of the cope approaches zero or 2 A sr, the reflectaxe factor approaches radiance luminance factor, or ref
10、lectance, respectively. When the three quantities defined above are considered for monochromatic radiation, they are designated by writing the name of the quantity preceded by the adjective I1spectral“, and by writing its symbol followed by A in parentheses (e.g., (A). These quantities are functions
11、 of wavelength A. In this report the angles of irradiation (illumination) and viewing are denoted by two subscripts, separated by a slash (e.c., 45/0). The first subscript indicates the angle between the direction of irradiation. illumination and the noma1 to the surface. The second subscript indica
12、tes the anGle between the direction of viewing and the normal to the s:i:-lface. It is assme2 that the directions of irradiation il lumination and viewing, and the normal to the surface a-Il lie in one plane. Th? symbol d is used as a subscript to indicate hemispherical irradiation (illumination or
13、viewing by means of an inte- grating sphere. COPYRIGHT International Commission on IlluminationLicensed by Information Handling ServicesA. SMOKED IvP.GNESiUPi OXIDE I. Properties ref. review A2 Coatings of smoked MgO obtained on polished copper have a higher reflection factor than those obtained on
14、two coats of a hard mat white enamel. Efforts to increase the thickness of the oxide coating by prolonged smoking showed that there is still room for considerable error due to unevenness in the coating. Coatings on silver-plated copper were easily reproducible provided that a thickness of roughly 0.
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- CIE461979AREVIEWOFPUBLICATIONSONPROPERTIESANDREFLECTIONVALUESOFMATERIALREFLECTIONSTANDARDSE 材料 反射 标准

链接地址:http://www.mydoc123.com/p-594263.html