ETSI TS 186 006-2-2015 Core Network and Interoperability Testing (INT) Originating Identification Presentation (OIP) and Originating Identification Restriction (OIR) using IP Multi.pdf
《ETSI TS 186 006-2-2015 Core Network and Interoperability Testing (INT) Originating Identification Presentation (OIP) and Originating Identification Restriction (OIR) using IP Multi.pdf》由会员分享,可在线阅读,更多相关《ETSI TS 186 006-2-2015 Core Network and Interoperability Testing (INT) Originating Identification Presentation (OIP) and Originating Identification Restriction (OIR) using IP Multi.pdf(19页珍藏版)》请在麦多课文档分享上搜索。
1、 ETSI TS 186 006-2 V4.1.1 (2015-10) Core Network and Interoperability Testing (INT); Originating Identification Presentation (OIP) and Originating Identification Restriction (OIR) using IP Multimedia (IM) Core Network (CN) subsystem; Conformance test specification (3GPP Release 10); Part 2: Test Sui
2、te Structure and Test Purposes (TSS Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/ipr.etsi.org). Pursuant to the ETSI IPR Policy, no investigation, inc
3、luding IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Specification (TS)
4、has been produced by ETSI Technical Committee Core Network and Interoperability Testing (INT). The present document is part 2 of a multi-part deliverable covering the Conformance Test Specification of Originating Identification Presentation (OIP) supplementary service and the Originating Identificat
5、ion Restriction (OIR) supplementary services using IP Multimedia (IM) Core Network (CN) subsystem, as identified below: Part 1: “Protocol Implementation Conformance Statement (PICS)“; Part 2: “Test Suite Structure and Test Purposes (TSS Universal Mobile Telecommunications System (UMTS); LTE; Origina
6、ting Identification Presentation (OIP) and Originating Identification Restriction (OIR) using IP Multimedia (IM) Core Network (CN) subsystem; Protocol specification (3GPP TS 24.607 Release 10)“. 2 ETSI TS 186 006-1: “Core Network and Interoperability Testing (INT); Originating Identification Present
7、ation (OIP) and Originating Identification Restriction (OIR) using IP Multimedia (IM) Core Network (CN) subsystem; Conformance test specification (3GPP Release 10); Part 1: Protocol Implementation Conformance Statement (PICS)“. 3 IETF RFC 3323: “A Privacy Mechanism for the Session Initiation Protoco
8、l (SIP)“. 2.2 Informative references References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the reference document (includi
9、ng any amendments) applies. NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. The following referenced documents are not necessary for the application of the present document but they assist the user with regard
10、to a particular subject area. i.1 ISO/IEC 9646-1: “Information technology - Open Systems Interconnection - Conformance testing methodology and framework - Part 1: General concepts“. ETSI ETSI TS 186 006-2 V4.1.1 (2015-10)6 3 Definitions and abbreviations 3.1 Definitions For the purposes of the prese
11、nt document, the terms and definitions given in ETSI TS 124 607 1 and the following apply: Implementation Under Test (IUT): Refer to ISO/IEC 9646-1 i.1. PICS proforma: Refer to ISO/IEC 9646-1 i.1. Point of Control and Observation: Refer to ISO/IEC 9646-1 i.1. Protocol Implementation Conformance Stat
12、ement (PICS): Refer to ISO/IEC 9646-1 i.1. System Under Test (SUT): Refer to ISO/IEC 9646-1 i.1. Test Purpose (TP): Refer to ISO/IEC 9646-1 i.1. NOTE: This may contain additional information. 3.2 Abbreviations For the purposes of the present document, the abbreviations given in ETSI TS 124 607 1 and
13、 the following apply: CLIR Calling Line Identification Restriction IUT Implementation Under Test OIP Originating Identification Presentation OIR Originating Identification Restriction SUT System Under Test 4 Test Suite Structure (TSS) User CallingUser OIP_U01_xxx alledUser OIP_U02_xxxNetwork AS_Orig
14、User OIP_N01_xxx AS_TermUser OIP_N02_xxxFigure 4-1: Test suite structure 4.1 Configuration 4.1.0 Introduction The scope of the present specification is to test the signalling and procedural aspects of the stage 3 requirements as described in ETSI TS 124 607 1. The stage 3 description describes the r
15、equirements for several network entities and also the requirements regarding for terminal devices. Therefore several interfaces (reference points) are addressed to satisfy the test of the different entities. Therefore to test the appropriate entities the configurations below are applicable. 4.1.1 Te
16、sting of the AS The AS entity is responsible for performing and managing services. The ISC interface is the appropriate access point for testing. ETSI ETSI TS 186 006-2 V4.1.1 (2015-10)7 Figure 4.1.1-1: Applicable interface to test AS functionalities If the ISC interface is not accessible it is also
17、 possible to perform the test of the AS using any NNI (Mw, Mg, Mx) interface (see figure 4.1.1-2). In case only the Gm interface is accessible this interface can be used instead for testing, but the verification of all requirements may not be possible. Figure 4.1.1-2: Applicable interfaces for tests
18、 using a (generic) NNI interface 4.1.2 Testing of the UE There are special clauses in the protocol standard describing the procedures that apply at the originating and terminating user equipment. Therefore the test configuration in figure 4.1.2-1 has been chosen. Figure 4.1.2-1: Applicable configura
19、tion to test UE functionalities ETSI ETSI TS 186 006-2 V4.1.1 (2015-10)8 5 Test Purposes (TP) 5.1 Introduction 5.1.1 TP naming convention TPs are numbered, starting at 001, within each group. Groups are organized according to the TSS. Additional references are added to identify the actual test suite
20、 and whether it applies to the network or the user (see table 5.1.1-1). Table 5.1.1-1: TP identifier naming convention scheme Identifier: _ = supplementary service: e.g. “OIP“ = type of IUT: U User - equipment N Network = group 2 digit field representing group reference according to TSS = sequential
21、 number (001 to 999) 5.1.2 Test strategy As the base standard ETSI TS 124 607 1 contains no explicit requirements for testing, the TPs were generated as a result of an analysis of the base standard and the PICS specification ETSI TS 186 006-1 2. The criteria applied include the following: only the r
22、equirements from the point of view of the T or coincident S and T reference point are considered; whether or not a test case can be built from the TP is not considered. 5.2 User TPs for OIP and OIR 5.2.0 Introduction All PICS items referred to in this clause are as specified in ETSI TS 186 006-1 2 u
23、nless indicated otherwise by another numbered reference. 5.2.1 Calling user TSS User/Calling_User TP OIP_U01_001 OIP reference clause 4.5.2.1 Selection expression PICS 4.1/1 AND PICS 4.2/2 Test purpose: Originating user sends a P-Preferred Identity. Ensure that the IUT, in order to present a complet
24、e calling user identity with which is registered, sends an INVITE message containing a P-Preferred-Identity header with valid tel or SIP URI defined as USER_URI in table 5.2.1-1. Preconditions: The user registers the public user identity. Comments: User Equipment Test Equipment INVITE barb4right INV
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ETSITS18600622015CORENETWORKANDINTEROPERABILITYTESTINGINTORIGINATINGIDENTIFICATIONPRESENTATIONOIPANDORIGINATINGIDENTIFICATIONRESTRICTIONOIRUSINGIPMULTIPDF

链接地址:http://www.mydoc123.com/p-744305.html