NFPA 1003-2015 Standard for Airport Fire Fighter Professional Qualifications (Effective Date 12 1 2014).pdf

1、NFPA 1003 Standard for Airport Fire Fighter Professional Qualifications 2015 Edition NFPA , 1 Batterymarch Park, Quincy, MA 02169-7471, USA An International Codes and Standards Organization 1/14 ISBN: 978-145591062-5 (Print) ISBN: 978-145591108-0 (PDF) IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NF

2、PA STANDARDS NOTICE AND DISCLAIMER OF LIABILITY CONCERNING THE USE OF NFPA STANDARDS NFPA codes, standards, recommended practices, and guides (“NFPA Standards”), of which the document contained herein is one, are developed through a consensus standards development process approved by the American Na

3、tional Standards Institute. This process brings together volunteers representing varied viewpoints and interests to achieve consensus on fire and other safety issues. While the NFPA administers the process and establishes rules to promote fairness in the development of consensus, it does not indepen

4、dently test, evaluate, or verify the accuracy of any information or the soundness of any judgments contained in NFPA Standards. The NFPA disclaims liability for any personal injury, property or other damages of any nature whatsoever, whether special, indirect, consequential or compensatory, directly

5、 or indirectly resulting from the publication, use of, or reliance on NFPA Standards. The NFPA also makes no guaranty or warranty as to the accuracy or completeness of any information published herein. In issuing and making NFPA Standards available, the NFPA is not undertaking to render professional

6、 or other services for or on behalf of any person or entity. Nor is the NFPA undertaking to perform any duty owed by any person or entity to someone else. Anyone using this document should rely on his or her own independent judgment or, as appropriate, seek the advice of a competent professional in

7、determining the exercise of reasonable care in any given circumstances. The NFPA has no power, nor does it undertake, to police or enforce compliance with the contents of NFPA Standards. Nor does the NFPA list, certify, test, or inspect products, designs, or installations for compliance with this do

8、cument. Any certification or other statement of compliance with the requirements of this document shall not be attributable to the NFPA and is solely the responsibility of the certifier or maker of the statement. REMINDER: UPDATING OF NFPA STANDARDS Users of NFPA codes, standards, recommended practi

9、ces, and guides (“NFPA Standards”) should be aware that NFPA Standards may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An official NFPA Standard at any point in time consists of the current edition of the document together with any Tentat

10、ive Interim Amendment and any Errata then in effect. In order to determine whether an NFPA Standard has been amended through the issuance of Tentative Interim Amendments or corrected by Errata, visit the Document Information Pages on NFPAs website. The Document Information Pages provide up-to-date,

11、document specific information including any issued Tentative Interim Amendments and Errata. To access the Document Information Page for a specific NFPA Standard, go to http:/www.nfpa.org/docinfo to choose from the list of NFPA Standards or use the search feature on the right to select the NFPA Stand

12、ard number (e.g., NFPA 101). In addition to posting all existing Tentative Interim Amendments and Errata, the Document Information Page also includes the option to sign-up for an “Alert” feature to receive an email notification when new updates and other information are posted regarding the document

13、.1/14 IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPA STANDARDS ADDITIONAL NOTICES AND DISCLAIMERS Updating of NFPA Standards Users of NFPA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that these documents may be superseded at any time by the issuance of n

14、ew editions or may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An official NFPA Standard at any point in time consists of the current edition of the document together with any Tentative Interim Amendments and any Errata then in effect. In

15、 order to determine whether a given document is the current edition and whether it has been amended through the issuance of Tentative Interim Amendments or corrected through the issuance of Errata, consult appropriate NFPA publications such as the National Fire Codes Subscription Service, visit the

16、NFPA website at www.nfpa.org, or contact the NFPA at the address listed below. Interpretations of NFPA Standards A statement, written or oral, that is not processed in accordance with Section 6 of the Regulations Governing the Development of NFPA Standards shall not be considered the official positi

17、on of NFPA or any of its Committees and shall not be considered to be, nor be relied upon as, a Formal Interpretation. Patents The NFPA does not take any position with respect to the validity of any patent rights referenced in, related to, or asserted in connection with an NFPA Standard. The users o

18、f NFPA Standards bear the sole responsibility for determining the validity of any such patent rights, as well as the risk of infringement of such rights, and the NFPA disclaims liability for the infringement of any patent resulting from the use of or reliance on NFPA Standards. NFPA adheres to the p

19、olicy of the American National Standards Institute (ANSI) regarding the inclusion of patents in American National Standards (“the ANSI Patent Policy”), and hereby gives the following notice pursuant to that policy: NOTICE: The users attention is called to the possibility that compliance with an NFPA

20、 Standard may require use of an invention covered by patent rights. NFPA takes no position as to the validity of any such patent rights or as to whether such patent rights constitute or include essential patent claims under the ANSI Patent Policy. If, in connection with the ANSI Patent Policy, a pat

21、ent holder has filed a statement of willingness to grant licenses under these rights on reasonable and nondiscriminatory terms and conditions to applicants desiring to obtain such a license, copies of such filed statements can be obtained, on request, from NFPA. For further information, contact the

22、NFPA at the address listed below. Law and Regulations Users of NFPA Standards should consult applicable federal, state, and local laws and regulations. NFPA does not, by the publication of its codes, standards, recommended practices, and guides, intend to urge action that is not in compliance with a

23、pplicable laws, and these documents may not be construed as doing so. Copyrights NFPA Standards are copyrighted. They are made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardizat

24、ion, and the promotion of safe practices and methods. By making these documents available for use and adoption by public authorities and private users, the NFPA does not waive any rights in copyright to these documents. Use of NFPA Standards for regulatory purposes should be accomplished through ado

25、ption by reference. The term “adoption by reference” means the citing of title, edition, and publishing information only. Any deletions, additions, and changes desired by the adopting authority should be noted separately in the adopting instrument. In order to assist NFPA in following the uses made

26、of its documents, adopting authorities are requested to notify the NFPA (Attention: Secretary, Standards Council) in writing of such use. For technical assistance and questions concerning adoption of NFPA Standards, contact NFPA at the address below. For Further Information All questions or other co

27、mmunications relating to NFPA Standards and all requests for information on NFPA procedures governing its codes and standards development process, including information on the procedures for requesting Formal Interpretations, for proposing Tentative Interim Amendments, and for proposing revisions to

28、 NFPA standards during regular revision cycles, should be sent to NFPA headquarters, addressed to the attention of the Secretary, Standards Council, NFPA, 1 Batterymarch Park, P.O. Box 9101, Quincy, MA 02269-9101; email: stds_adminnfpa.org For more information about NFPA, visit the NFPA website at w

29、ww.nfpa.org. All NFPA codes and standards can be viewed at no cost at www.nfpa.org/freeaccess.Copyright 2014 National Fire Protection Association . All Rights Reserved. NFPA 1003 Standardfor AirportFireFighterProfessionalQualifications 2015Edition This edition of NFPA 1003,AirportFireFighterProfessi

30、onalQualifications, was prepared by the Technical Committee on Fire Fighter Professional Qualifications, and released by the Corre- lating Committee on Professional Qualifications. It was issued by the Standards Council on November 11, 2014, with an effective date of December 1, 2014, and supersedes

31、 all previous editions. This edition of NFPA 1003 was approved as an American National Standard on December 1, 2014. OriginandDevelopmentofNFPA1003 In 1972, the Joint Council of National Fire Service Organizations (JCNFSO) created the National Professional Qualifications Board for the Fire Service (

32、NPQB) to facilitate the devel- opment of nationally applicable performance standards for uniformed fire service personnel. On December 14, 1972, the Board established four technical committees to develop those standards using the National Fire Protection Association (NFPA) standards-making system. T

33、he initial committees addressed the following career areas: fire fighter, fire officer, fire service instructor, and fire inspector and investigator. The Committee on Fire Fighter Professional Qualifications met from 1976 to 1978 to produce the first edition of this document. Adopted by the Associat

34、ion in 1978, NFPA 1003 was the third in the series of fire fighter professional qualifications standards. The original concept of the professional qualification standards, as directed by the JCN- FSO and the NPQB, was to develop an interrelated set of performance standards specifically for the fire

35、service. The various levels of achievement in the standards were to build upon each other within a strictly defined career ladder. In the late 1980s, revisions of the standards recognized that the documents should stand on their own merit in terms of job performance requirements for a given field. A

36、ccordingly, the The strict career ladder concept was aban- doned, except for the progression from fire fighter to fire officer. The later revisions, there- fore, facilitated the use of the documents by other than the uniformed fire services. In the mid 1990s, all of the Pro-Qual standards were conve

37、rted to the JPR format to be consistent with each other. Each JPR consists of the task to be performed; the tools, equip- ment, or materials that must be provided to complete the task; evaluation parameters and performance outcomes; and lists of the requisite knowledge and skills one must have to be

38、 able to perform the tasks. The intent of the technical committee was to develop clear and concise JPRs that can be used to determine that an individual, when measured to the standard, possesses the skills and knowledge to perform as a job related to the particular standard. Changes in the standard

39、for the 2005 edition included the requirement that for certifica- tion as an airport fire fighter, the candidate meet the requirements for Fire Fighter II defined in NFPA 1001, Standard for Fire Fighter Professional Qualifications. Also included were changes bringing the standard into conformance wi

40、th the Manual of Style for NFPATechnical Committee Documents. For the 2010 edition, a job-task analysis was completed by the committee to ensure that all the requirements were still relevant given the ever-changing world of ARFF. In addition, the commit- tee, as directed by the Technical Correlating

41、 Committee, replaced the termcertified with the term qualified. The committee added a skills maintenance requirement for ARFF personnel. The most significant change in the 2010 was the elimination of proximity personal protective equipment (PrPPE) from the minimum requirements. By setting the minimu

42、m at PrPPE, the standard had eliminated the ability of the AHJ to decide, given varying situations, whether PPE was acceptable versus PrPPE. The committee also removed Annex B from the document. 10031 NFPA and National Fire Protection Association are registered trademarks of the National Fire Protec

43、tion Association, Quincy, Massachusetts 02169.For the 2015 edition, the technical committee performed a job task analysis in collaboration with the Technical Committee on Aircraft Rescue and Fire Fighting ensuring that the position of Aircraft Rescue Fire Fighter was consis- tent with recognized tre

44、nds within the industry. This analysis redefined the use of some airport apparatus to fire vehicles with handlines. The technical committee removed the job performance requirements for wheeled- extinguishers and mandatory response time, citing variables from airport to airport. Job performance requi

45、rements related to airport access were clarified. 10032 AIRPORT FIRE FIGHTER PROFESSIONAL QUALIFICATIONS 2015 EditionTechnicalCorrelatingCommitteeonProfessionalQualifications WilliamE.Peterson, Chair Kissimmee, FL M Rep. International Fire Service Training Association GreggA.Cleveland, La Crosse Fir

46、e Department, WI U Rep. NFPA Fire Service Section GordonDescutner, Alaska DPS Fire Standards Council, AK U Rep. Alaska Fire Standards Council DouglasP.Forsman, Fairfield Bay Fire Department, AR L ScottM.Gorgon, North Las Vegas Fire Department, NV L Rep. International Association of Fire Fighters R.K

47、irkHankins, Fire Consulting & Case Review International, Inc., MO U Rep. International Association of Arson Investigators, Inc. TonyaL.Hoover, CAL FIRE, Office of the State Fire Marshal, CA U Rep. International Association of Fire Chiefs JamesF.Jaracz, Fire Code Guy, IN SE AlanE.Joos, Louisiana Stat

48、e University, LA SE Rep. North American Fire Training Directors JerroldPrendergast, Springfield Fire Department, MA L WillieG.Shelton, Fredericksburg, VA E Rep. National Board on Fire Service Professional Qualifications PhilipC.Stittleburg, La Farge Fire Department, WI L Rep. National Volunteer Fire

49、 Council TracieM.Young-Brungard, Pennsylvania Office of the State Fire Commissioner, PA E Rep. International Fire Service Accreditation Congress Alternates ThomasW.Aurnhammer, Los Pinos Fire District, CO U (Alt. to R. K. Hankins) WayneBailey, North Carolina Fire & Rescue Commission, NC E (Alt. to T. M. Young-Brungard) DavidW.Lewis, Maryland Coordination and Analysis Center, MD L (Alt. to P. C. Stittleburg) FrederickW.Piechota,Jr., National Board on Fire Service Professional Qualifications, MA E (Alt. to W. G. Shelton) Nonvoting StephenP.Aus