1、NFPA 3 Recommended Practice for Commissioning of Fire Protection and Life Safety Systems 2015 Edition NFPA, 1 Batterymarch Park, Quincy, MA 02169-7471 An International Codes and Standards Organization 1/14ISBN: 978-145590885-1 (Print)ISBN: 978-145590918-6 (PDF)IMPORTANT NOTICES AND DISCLAIMERS CONCE
2、RNING NFPASTANDARDS NOTICE AND DISCLAIMER OF LIABILITY CONCERNING THE USE OF NFPA STANDARDSNFPAcodes, standards, recommended practices, and guides (“NFPA Standards”), of which the document contained herein is one, are developed through a consensus standards development process approved by the Americ
3、an National Standards Institute. This process brings together volunteers representing varied viewpoints and interests to achieve consensus on fire and other safety issues. While the NFPA administers the process and establishes rules to promote fairness in the development of consensus, it does not in
4、dependently test, evaluate, or verify the accuracy of any information or the soundness of any judgments contained in NFPA Standards.The NFPA disclaims liability for any personal injury, property or other damages of any nature whatsoever, whether special, indirect, consequential or compensatory, dire
5、ctly or indirectly resulting from the publication, use of, or reliance on NFPA Standards. The NFPA also makes no guaranty or warranty as to the accuracy or completeness of any information published herein.In issuing and making NFPA Standards available, the NFPA is not undertaking to render professio
6、nal or other services for or on behalf of any person or entity. Nor is the NFPA undertaking to perform any duty owed by any person or entity to someone else. Anyone using this document should rely on his or her own independent judgment or, as appropriate, seek the advice of a competent professional
7、in determining the exercise of reasonable care in any given circumstances.The NFPA has no power, nor does it undertake, to police or enforce compliance with the contents of NFPA Standards. Nor does the NFPA list, certify, test, or inspect products, designs, or installations for compliance with this
8、document. Any certification or other statement of compliance with the requirements of this document shall not be attributable to the NFPA and is solely the responsibility of the certifier or maker of the statement.REMINDER: UPDATING OF NFPA STANDARDSUsers of NFPA codes, standards, recommended practi
9、ces, and guides (“NFPA Standards”) should be aware that NFPA Standards may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An official NFPA Standard at any point in time consists of the current edition of the document together with any Tentat
10、ive Interim Amendment and any Errata then in effect.In order to determine whether an NFPA Standard has been amended through the issuance of Tentative Interim Amendments or corrected by Errata, visit the Document Information Pages on NFPAs website. The Document Information Pages provide up-to-date, d
11、ocument specific information including any issued Tentative Interim Amendments and Errata.To access the Document Information Page for a specific NFPA Standard, go to http:/www.nfpa.org/docinfo to choose from the list of NFPA Standards or use the search feature on the right to select the NFPA Standar
12、d number (e.g., NFPA 101). In addition to posting all existing Tentative Interim Amendments and Errata, the Document Information Page also includes the option to sign-up for an “Alert” feature to receive an email notification when new updates and other information are posted regarding the document.1
13、/14IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPASTANDARDS ADDITIONAL NOTICES AND DISCLAIMERSUpdating of NFPA Standards Users of NFPA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that these documents may be superseded at any time by the issuance of new ed
14、itions or may be amended from time to time through the issuance of Tentative Interim Amendments or corrected by Errata. An official NFPA Standard at any point in time consists of the current edition of the document together with any Tentative Interim Amendments and any Errata then in effect. In orde
15、r to determine whether a given document is the current edition and whether it has been amended through the issuance of Tentative Interim Amendments or corrected through the issuance of Errata, consult appropriate NFPA publications such as the National Fire CodesSubscription Service, visit the NFPA w
16、ebsite at www.nfpa.org, or contact the NFPA at the address listed below.Interpretations of NFPA StandardsA statement, written or oral, that is not processed in accordance with Section 6 of the Regulations Governing the Development of NFPA Standards shall not be considered the official position of NF
17、PA or any of its Committees and shall not be considered to be, nor be relied upon as, a Formal Interpretation.PatentsThe NFPA does not take any position with respect to the validity of any patent rights referenced in, related to, or asserted in connection with an NFPA Standard. The users of NFPA Sta
18、ndards bear the sole responsibility for determining the validity of any such patent rights, as well as the risk of infringement of such rights, and the NFPA disclaims liability for the infringement of any patent resulting from the use of or reliance on NFPA Standards.NFPA adheres to the policy of th
19、e American National Standards Institute (ANSI) regarding the inclusion of patents in American National Standards (“the ANSI Patent Policy”), and hereby gives the following notice pursuant to that policy:NOTICE: The users attention is called to the possibility that compliance with an NFPA Standard ma
20、y require use of an invention covered by patent rights. NFPA takes no position as to the validity of any such patent rights or as to whether such patent rights constitute or include essential patent claims under the ANSI Patent Policy. If, in connection with the ANSI Patent Policy, a patent holder h
21、as filed a statement of willingness to grant licenses under these rights on reasonable and nondiscriminatory terms and conditions to applicants desiring to obtain such a license, copies of such filed statements can be obtained, on request, from NFPA. For further information, contact the NFPA at the
22、address listed below.Law and RegulationsUsers of NFPA Standards should consult applicable federal, state, and local laws and regulations. NFPA does not, by the publication of its codes, standards, recommended practices, and guides, intend to urge action that is not in compliance with applicable laws
23、 and these documents may not be construed as doing so.CopyrightsNFPA Standards are copyrighted. They are made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the pro
24、motion of safe practices and methods. By making these documents available for use and adoption by public authorities and private users, the NFPA does not waive any rights in copyright to these documents.Use of NFPA Standards for regulatory purposes should be accomplished through adoption by referenc
25、e. The term “adoption by reference” means the citing of title, edition, and publishing information only. Any deletions, additions, and changes desired by the adopting authority should be noted separately in the adopting instrument. In order to assist NFPA in following the uses made of its documents,
26、 adopting authorities are requested to notify the NFPA (Attention: Secretary, Standards Council) in writing of such use. For technical assistance and questions concerning adoption of NFPA Standards, contact NFPA at the address below.For Further InformationAll questions or other communications relati
27、ng to NFPA Standards and all requests for information on NFPA procedures governing its codes and standards development process, including information on the procedures for requesting Formal Interpretations, for proposing Tentative Interim Amendments, and for proposing revisions to NFPA standards dur
28、ing regular revision cycles, should be sent to NFPA headquarters, addressed to the attention of the Secretary, Standards Council, NFPA, 1 Batterymarch Park, P.O. Box 9101, Quincy, MA 02269-9101; email: stds_adminnfpa.orgFor more information about NFPA, visit the NFPA website at www.nfpa.org. All NFP
29、A codes and standards can be viewed at no cost at www.nfpa.org/freeaccess.Copyright 2014 National Fire Protection Association. All Rights Reserved.NFPA3Recommended Practice forCommissioning of Fire Protection and Life Safety Systems2015 EditionThis edition of NFPA 3, Recommended Practice for Commiss
30、ioning of Fire Protection and Life SafetySystems, was prepared by the Technical Committee on Commissioning and Integrated Testing. Itwas issued by the Standards Council on April 29, 2014, with an effective date of May 19, 2014, andsupersedes all previous editions.This edition of NFPA 3 was approved
31、as an American National Standard on May 19, 2014.Origin and Development of NFPA 3The 2012 edition of NFPA 3, Recommended Practice for Commissioning and Integrated Testing ofFire Protection and Life Safety Systems, represented NFPAs first document outlining a systematicapproach to provide documented
32、confirmation that fire protection and life safety systemsfunction as intended by the owner and the design team. The genesis of this document was arequest from the National Institute of Building Sciences (NIBS) to provide a commissioningdocument for fire protection systems that would be part of a con
33、glomeration of commission-ing documents that could be used to create a total building commissioning program.NFPA 3 addresses the administrative and procedural concepts of fire protection and lifesafety system commissioning and also provides direction on the integrated system tests.The document is de
34、signed to identify the commissioning team members, their qualifica-tions, and their roles and responsibilities throughout the commissioning process. Chapter 5addresses the concept of commissioning from the incipient stages of a project through theoccupancy and operation of the facility. Throughout t
35、he commissioning process there areseveral key documents that are identified in the recommended practice such as the OwnersProject Requirements (OPR) and the Basis of Design (BOD), which provide direction to thecommissioning team members as they are executing the commissioning plan. These docu-ments,
36、 which are generated during the design phase, are implemented during construction.NFPA 3 also addresses retro-commissioning and re-commissioning of existing buildings.For existing buildings that have never been commissioned, a retro-commissioning plan isdeveloped and executed to establish a benchmar
37、k for the facility. Existing buildings that havebeen previously commissioned are periodically re-commissioned and compared to the com-pliance benchmarks established in the original commissioning plan.NFPA 3 contains many forms that are available to assist in project documentation and theimplementati
38、on of the commissioning program.The largest modification to NFPA 3 for the 2015 edition was the removal of Chapter 7 fromthe 2012 edition. This chapter addressed integrated system testing as part of the overall fireprotection and life safety system commissioning concept. The Technical Committee on C
39、om-missioning and Integrated Testing determined that while commissioning fire protection sys-tems was not ready for standardization, there was an imminent need to create a standard fortesting integrated fire protection and life safety systems. The technical committee requestedto separate the concept
40、s of commissioning and integrated system testing into two documents:the first, a recommended practice on commissioning; and the second, a new standard,NFPA 4, Standard for Integrated Fire Protection and Life Safety System Testing, addressing the inte-grated system testing portion. This restructuring
41、 and request for a new project was approvedby the Standards Council in October 2011 and resulted in Chapter 7 of the 2012 edition ofNFPA 3 being removed for the 2015 edition and using it as the basis for NFPA 4.In addition to the document split, the technical committee focused on updating the rec-om
42、mendations for existing building commissioning. Additional detail was added to the sec-tions on re-commissioning and retro-commissioning to assist fire commissioning agents incarrying out commissioning projects on existing buildings.31NFPA and National Fire Protection Association are registered trad
43、emarks of the National Fire Protection Association, Quincy, Massachusetts 02169.Technical Committee on Commissioning and Integrated TestingMaurice M. Pilette, ChairMechanical Designs Ltd., MA SECecil Bilbo, Jr., Academy of Fire Sprinkler Technology,Inc., IL SEArt Black, Carmel Fire Protection Associ
44、ates, CA EBruce G. Campbell, Hughes Associates, Inc., CO SERobert G. Caputo, Fire communication systems; andany other utility system deemed essential for the supportof project operations(3) On-site combined heat and power generation systems,electric power generation plants or systems, fuel gas stor-
45、age facilities, water supply and storage facilities, and envi-ronmental or waste management systemsA.1.3.1(6) Emergency power supply systems to be commis-sioned include, but are not limited to, those powering thefollowing:(1) Smoke control systems(2) Stair pressurization systems(3) Smoke-proof enclo
46、sure ventilation systems(4) Electrically driven fire pumps(5) Fire service access elevators(6) Fire suppression system controllersIt should also be considered that an emergency power sup-ply system in large occupancies, health care facilities, andhigh-rise buildings supply life safety electrical sys
47、tems re-quired for life safety. They also require commissioning andevaluation for their ability to provide illumination and criticalpower for those who can physically evacuate a building, andthey also sustain life for those who cannot, whether or notthere is a fire event in the building.The emergenc
48、y power supply and emergency power supplysystems serving emergency systems, legally required standbysystems, and critical operations systems should be evaluated bythe FCxA as a stand-alone life safety system, whether or not afire or smoke event is occurring in the building.A.1.3.1(8) Examples includ
49、e, but are not limited to, floorceilings and roof decks, doors, windows, barriers, and wallsprotected by a firestop system or device for through-penetrations and membrane penetrations, and other fire andsmoke control assemblies.A.1.3.1(9) Examples include, but are not limited to, fire andsmoke resistantrated assemblies protected by a firestop systemor device for through-penetrations and membrane penetrations.A.1.3.1(10) This can include, but is not limited to:(1) Hoods(2) Ductwork(3) Active fire protection systemsA.1.3.1(12) Egress system and egress components should in
copyright@ 2008-2019 麦多课文库（www.mydoc123.com）网站版权所有
备案/许可证编号：苏ICP备17064731号-1