NFPA 87-2018 Standard for Fluid Heaters (Effective Date 08 21 2017).pdf

1、 NFPA 87 Standard for Fluid Heaters 2018IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPA STANDARDS NOTICE AND DISCLAIMER OF LIABILITY CONCERNING THE USE OF NFPA STANDARDS NFPA codes, standards, recommended practices, and guides (“NFPA Standards”), of which the document contained herein is one, are

2、developed through a consensus standards development process approved by the American National Standards Institute. This process brings together volunteers representing varied viewpoints and interests to achieve consensus on re and other safety issues. While the NFPA administers the process and estab

3、lishes rules to promote fairness in the development of consensus, it does not independently test, evaluate, or verify the accuracy of any information or the soundness of any judgments contained in NFPA Standards. The NFPA disclaims liability for any personal injury, property, or other damages of any

4、 nature whatsoever, whether special, indirect, consequential or compensatory, directly or indirectly resulting from the publication, use of, or reliance on NFPA Standards. The NFPA also makes no guaranty or warranty as to the accuracy or completeness of any information published herein. In issuing a

5、nd making NFPA Standards available, the NFPA is not undertaking to render professional or other services for or on behalf of any person or entity. Nor is the NFPA undertaking to perform any duty owed by any person or entity to someone else. Anyone using this document should rely on his or her own in

6、dependent judgment or, as appropriate, seek the advice of a competent professional in determining the exercise of reasonable care in any given circumstances. The NFPA has no power, nor does it undertake, to police or enforce compliance with the contents of NFPA Standards. Nor does the NFPA list, cer

7、tify, test, or inspect products, designs, or installations for compliance with this document. Any certication or other statement of compliance with the requirements of this document shall not be attributable to the NFPA and is solely the responsibility of the certier or maker of the statement. REVIS

8、ION SYMBOLS IDENTIFYING CHANGES FROM THE PREVIOUS EDITION Text revisions are shaded. A before a section number indicates that words within that section were deleted and a to the left of a table or gure number indicates a revision to an existing table or gure. When a chapter was heavily revised, the

9、entire chapter is marked throughout with the symbol. Where one or more sections were deleted, a is placed between the remaining sections. Chapters, annexes, sections, gures, and tables that are new are indicated with an N. Note that these indicators are a guide. Rearrangement of sections may not be

10、captured in the markup, but users can view complete revision details in the First and Second Draft Reports located in the archived revision information section of each code at www.nfpa.org/docinfo. Any subsequent changes from the NFPA Technical Meeting, Tentative Interim Amendments, and Errata are a

11、lso located there. REMINDER: UPDATING OF NFPA STANDARDS Users of NFPA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that NFPA Standards may be amended from time to time through the issuance of a Tentative Interim Amendment (TIA) or corrected by Errata. An ofc

12、ial NFPA Standard at any point in time consists of the current edition of the document together with any TIAs and Errata then in effect. To determine whether an NFPA Standard has been amended through the issuance of Tentative Interim Amendments or corrected by Errata, go to www.nfpa.org/docinfo to c

13、hoose from the list of NFPA Standards or use the search feature to select the NFPA Standard number (e.g., NFPA 13). The document information page provides up-to-date document-specic information as well as postings of all existing TIAs and Errata. It also includes the option to register for an “Alert

14、” feature to receive an automatic email notication when new updates and other information are posted regarding the document. ISBN: 978-145591673-3 (Print) ISBN: 978-145591674-0 (PDF) ISBN: 978-145591758-7 (eBook)IMPORTANT NOTICES AND DISCLAIMERS CONCERNING NFPA STANDARDS ADDITIONAL NOTICES AND DISCL

15、AIMERS Updating of NFPA Standards Users of NFPA codes, standards, recommended practices, and guides (“NFPA Standards”) should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of Tentative Interim Amen

16、dments or corrected by Errata. An ofcial NFPA Standard at any point in time consists of the current edition of the document together with any Tentative Interim Amendments and any Errata then in effect. In order to determine whether a given document is the current edition and whether it has been amen

17、ded through the issuance of Tentative Interim Amendments or corrected through the issuance of Errata, consult appropriate NFPA publications such as the National Fire Codes Subscription Service, visit the NFPA website at www.nfpa.org, or contact the NFPA at the address listed below. Interpretations o

18、f NFPA Standards A statement, written or oral, that is not processed in accordance with Section 6 of the Regulations Governing the Development of NFPA Standards shall not be considered the ofcial position of NFPA or any of its Committees and shall not be considered to be, nor be relied upon as, a Fo

19、rmal Interpretation. Patents The NFPA does not take any position with respect to the validity of any patent rights referenced in, related to, or asserted in connection with an NFPA Standard. The users of NFPA Standards bear the sole responsibility for determining the validity of any such patent righ

20、ts, as well as the risk of infringement of such rights, and the NFPA disclaims liability for the infringement of any patent resulting from the use of or reliance on NFPA Standards. NFPA adheres to the policy of the American National Standards Institute (ANSI) regarding the inclusion of patents in Am

21、erican National Standards (“the ANSI Patent Policy”), and hereby gives the following notice pursuant to that policy: NOTICE: The users attention is called to the possibility that compliance with an NFPA Standard may require use of an invention covered by patent rights. NFPA takes no position as to t

22、he validity of any such patent rights or as to whether such patent rights constitute or include essential patent claims under the ANSI Patent Policy. If, in connection with the ANSI Patent Policy, a patent holder has led a statement of willingness to grant licenses under these rights on reasonable a

23、nd nondiscriminatory terms and conditions to applicants desiring to obtain such a license, copies of such led statements can be obtained, on request, from NFPA. For further information, contact the NFPA at the address listed below. Law and Regulations Users of NFPA Standards should consult applicabl

24、e federal, state, and local laws and regulations. NFPA does not, by the publication of its codes, standards, recommended practices, and guides, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights NFPA Standards are co

25、pyrighted. They are made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of safe practices and methods. By making these documents available for use and

26、adoption by public authorities and private users, the NFPA does not waive any rights in copyright to these documents. Use of NFPA Standards for regulatory purposes should be accomplished through adoption by reference. The term “adoption by reference” means the citing of title, edition, and publishin

27、g information only. Any deletions, additions, and changes desired by the adopting authority should be noted separately in the adopting instrument. In order to assist NFPA in following the uses made of its documents, adopting authorities are requested to notify the NFPA (Attention: Secretary, Standar

28、ds Council) in writing of such use. For technical assistance and questions concerning adoption of NFPA Standards, contact NFPA at the address below. For Further Information All questions or other communications relating to NFPA Standards and all requests for information on NFPA procedures governing

29、its codes and standards development process, including information on the procedures for requesting Formal Interpretations, for proposing Tentative Interim Amendments, and for proposing revisions to NFPA standards during regular revision cycles, should be sent to NFPA headquarters, addressed to the

30、attention of the Secretary, Standards Council, NFPA, 1 Batterymarch Park, P.O. Box 9101, Quincy, MA 02269-9101; email: stds_adminnfpa.org. For more information about NFPA, visit the NFPA website at www.nfpa.org. All NFPA codes and standards can be viewed at no cost at www.nfpa.org/docinfo.87-1 NFPA

31、and National Fire Protection Association are registered trademarks of the National Fire Protection Association, Quincy, Massachusetts 02169. Copyright 2017 National Fire Protection Association . All Rights Reserved. NFPA 87 Standard for Fluid Heaters 2018 Edition This edition of NFPA 87, Standard fo

32、r Fluid Heaters, was prepared by the Technical Committee on Fluid Heaters. It was issued by the Standards Council on August 1, 2017, with an effective date of August 21, 2017, and supersedes all previous editions. This edition of NFPA 87 was approved as an American National Standard on August 21, 20

33、17. Origin and Development of NFPA 87 The 2011 edition of NFPA 87 was the rst edition of the document. In 2006, the Standards Council authorized the Technical Committee on Ovens and Furnaces to begin work on a new recommended practice on process heaters. The task force formed by the committee to dev

34、elop the recommended practice comprised members of the Technical Committee on Ovens and Furnaces (NFPA 86, Standard for Ovens and Furnaces) and re safety professionals from the community of uid heater users and manufacturers. The need for NFPA to develop a document on uid heaters became apparent ove

35、r a number of years as NFPA received requests for interpretation as to whether uid heaters were covered by any existing NFPA codes and standards. The Technical Committee on Boiler and Combustion Systems specically excludes process heaters used in chemical and petroleum manufacture from coverage by N

36、FPA 85, Boiler and Combustion Systems Hazards Code. NFPA 86 does not exclude process heaters, but the Technical Committee on Ovens and Furnaces recommended the development of a new document that recognizes that process heaters are fundamentally different from ovens and furnaces. NFPA 87 incorporates

37、 many safety recommendations that are consistent with requirements in NFPA 86 and NFPA 85, especially those related to hazards associated with the combustion of gaseous and liquid fuels. Additional recommendations have been added to NFPA 87 that address unique hazards associated with the combustible

38、 uids being heated in these systems (e.g., pressure containment, ow and temperature monitoring, and mitigation of accidental uid releases). The 2015 edition of NFPA 87 included several changes to Chapter 3 due to the addition of denitions for burner management system (BMS) and emergency shutoff valv

39、e (ESOV) and other updates to denitions for consistency with NFPA 86. Changes to Chapter 6 intended to make the document consistent with NFPA 86 included ESOV requirements, emergency isolation valves, and overpressure protection. The Committee added procedures for placing equipment into service base

40、d on purging practices in NFPA 54 and the new NFPA 56. The committee added a requirement prohibiting manifolding vent lines from different pressure levels based on NFPA 85. As a result of introducing denitions for BMS and combustion safeguard, the committee modied requirements for logic systems for

41、both BMS logic and PLC systems. The committee completely revised requirements for Class F heaters in Chapter 9 and added new content for Chapters 10 and 11 on Class G and H heaters, respectively. For the 2018 edition, NFPA 87 has transitioned from a recommended practice to a standard. After developm

42、ent of the document for two revision cycles, the technical committee decided the document was prepared to move from recommendations to requirements. During this process, several changes have been made to facilitate its use as a standard. The committee added nine new denitions to Chapter 3, extracted

43、 from NFPA 86, including self-piloted burner, line pressure regulator, monitoring pressure regulator, series pressure regulator, service pressure regulator, ame rod, ame detector, supervised ame , and ame failure response time (FFRT). A denition for authorized personnel has been modied from NFPA 190

44、1, and qualied personnel has been modied from NFPA 70.FLUID HEATERS 87-2 2018 Edition In addition, the three types of heaters previously referenced in NFPA 87 (i.e., Class F, G, and H) have been combined into one chapter due to the similarity of the requirements for all three classes of heaters. Flu

45、id mixture changes now need to be in accordance with heater manufacturers recommendations, uid manufacturers recommendations, or third-party approved by the AHJ. Fluid type changes need to be in accordance with heater manufacturers recommendations or third-party approved by the AHJ. New provisions i

46、n 8.2.9 require the use of two manual hardwired emergency switches one located remotely and one located locally in reference to the uid heater. Requirements in 8.5.2.5 now address the issue of false ame signal for ame sensing technologies. The PLC software section has been altered to now refer to th

47、e PLC logic programming instead of the general term software. Finally, interlocks previously found in Chapter 9 have been moved to Chapter 8 with the other system interlocks. Chapter 9 now allows secondary catch/storage tanks, and safety PLC requirements have been aligned with NFPA 86. A new require

48、ment for blanket gas low-pressure proving devices also has been added.COMMITTEE PERSONNEL 87-3 2018 Edition Technical Committee on Fluid Heaters Algirdas Underys, Chair A. Finkl ovens and furnaces (which are covered by NFPA 86); red heaters in petroleum reneries and petrochemical facilities (which a

49、re covered by API Standards and Recommended Practices); units that heat air for occupiable space or comfort; and LP-Gas vaporizers designed and installed in accordance with NFPA 58 and NFPA 59.FLUID HEATERS 87-4 2018 Edition Contents Chapter 1 Administration 87 5 1.1 Scope. . 87 5 1.2 Purpose. . 87 5 1.3 Application. . 87 5 1.4 Retroactivity. 87 5 1.5 Equivalency. . 87 5 1.6 Units and Formulas. 87 5 Chapter 2 Referenced Publications 87 6 2.1 General. . 87 6 2.2 NFPA Publications. . 87 6 2.3 Other Publications. . 87 6