SAE AMS 3756C-2011 Moldings Glass Fiber Filled Polytetrafluoroethylene 75% PTFE Resin 25 Glass As Sintered《烧结的25级75%聚四氟乙烯树脂，填充聚四氟乙烯的玻璃纤维模制品》.pdf

1、_ SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising there

2、from, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2011 SAE International All rights reserved. No part of this publication m

3、ay be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside U

4、SA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedback on this Technical Report, please visit http:/www.sae.org/technical/standards/AMS3756CAEROSPACEMATERIALSPECIFICATIONAMS3756 REV. C Issued 1983-10 Revised 2008-06Stabilized

5、 2011-08 Superseding AMS3756B Moldings, Glass Fiber Filled Polytetrafluoroethylene (PTFE) 75% PTFE Resin, 25% Glass Fibers, As Sintered RATIONALE This document has been determined to contain basic and stable technology which is not dynamic in nature. STABILIZED NOTICE This document has been declared

6、 “Stabilized“ by SAE AMS P, Polymeric Materials Committee, and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability of technical requirements. Newer technology may exist. Copyright SAE International Provided by IHS und

7、er license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3756C Page 2 of 7 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3756C Page 3 of 7

8、 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3756C Page 4 of 7 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted witho

9、ut license from IHS-,-,-SAE AMS3756C Page 5 of 7 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3756C Page 6 of 7 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3756C Page 7 of 7 STABILIZED BY AMS COMMITTEE “P“ Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-