SAE AMS 3898 4B-1994 Interleaf Carrier Material Composite Tape Paper 0 04 inch (0 10 mm) Perforated《无孔的0 004 in(0 10 mm)复合带纸插页载体材料》.pdf

1、AEROSPACE MATERIAL SPECIFICATIONAMS3898/4 REV. BIssued 1975-06Revised 1994-02Reaffirmed 2014-08Superseding AMS3898/4AInterleaf Carrier Material, Composite TapePaper, 0.04 inch (0.10 mm), PerforatedRATIONALEAMS3898/4B has been reaffirmed to comply with the SAE five year review policy._SAE Technical S

2、tandards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole

3、 responsibility of the user.”SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions.Copyright 2014 SAE InternationalAll rights reserved. No part of this publication may be re

4、produced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE.TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada)Tel: +1 724-776-4970 (outside USA)Fax: 72

5、4-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.orgSAE values your input. To provide feedbackon this Technical Report, please visithttp:/www.sae.org/technical/standards/AMS3898/4B1. SCOPE:1.1 Form:This specification covers one type of paper in the form of perforated tape ofthe

6、width specified herein.2 APPLICABLE DOCUMENTSee AMS 3898.3 TECHNICAL REQUIREMENT3.1 Basic Specification:The complete requirements for procuring the product described herein shallconsist of this document and the latest issue of the basic specification,AMS 3898.3.2 Material:The carrier material shall

7、be a paper which has been coated with a siliconerelease agent, slit to the width specified, and perforated for sprocketalignment as shown in Figure 1 of AMS 3898.3.2.1 Thickness: Shall be 0.0040 inch 0.0005 (0.102 mm 0.013).3.2.2 Width: Shall be 4.000 inches (101.60 mm).SAE INTERNATIONAL AMS3898/4B

8、Page 2 of 2 3.3 Properties:Shall be as shown in Table 1.TABLE 1 - PropertiesParagraph Property3.3.1 Tensile Strength, minimumRequirement25 pounds forceper inch(4.38 kN/m) of widthTest Method3.3.2 Tear Strength, minimum 2.8 ounces force(778 mN)ASTM D 827-714 QUALITY ASSURANCE PROVISIONSee AMS 3898.5 PREPARATION FOR DELIVERSee AMS 3898.6 ACKNOWLEDGMENSee AMS 3898.7 REJECTIONSee AMS 3898.8 NOTESee AMS 3898.ASTM D 882,Method A