SAE AMS 4467B-2017 Aluminum Alloy Sheet and Plate Alclad 4 4Cu 1 5Mg 0 60Mn (Alclad 2024 -T861 Sheet & Plate) Solution Heat Treated 6% Cold Worked and Artificially Aged (UNS A82024.pdf

1、_ SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising there

2、from, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions. Copyright 2017 SAE International All rights reserved. No part of this p

3、ublication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-497

4、0 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedback on this Technical Report, please visit http:/standards.sae.org/AMS4467B AEROSPACE MATERIAL SPECIFICATION AMS4467 REV. B Issued 2011-12 Revised 2017-10 Superse

5、ding AMS4467A Aluminum Alloy, Sheet and Plate, Alclad 4.4Cu 1.5Mg 0.60Mn (Alclad 2024, -T861 Sheet dimensions and properties in SI units and the Celsius temperatures are shown as the approximate equivalents of the primary units and are presented only for information. 7.4 The tensile properties in Ta

6、ble 3 was taken directly from QQ-A-250/5F Amendment 2 (AMS-QQ-A-250/5A) and have not been independently verified by AMS statistical procedures. 7.5 Purchase documents should specify not less than the following: AMS4467B Product form and size of product desired Property and acceptance requirements from the cognizant engineering organization applicable to sizes outside the range listed in 1.1.1 Ultrasonic testing (if required) (3.6) Quantity of product desired PREPARED BY AMS COMMITTEE “D“