SAE AMS 6400-2007 Forgings Steel For Aircraft Aerospace Equipment《航空器 航空航天设备用钢锻件》.pdf

1、_ SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising there

2、from, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions. Copyright 2011 SAE International All rights reserved. No part of this p

3、ublication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-497

4、0 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedback on this Technical Report, please visit http:/www.sae.org/technical/standards/AMS6400 AEROSPACE MATERIAL SPECIFICATION AMS 6400 Issued 2007-02 Reaffirmed 2011-

5、11 Forgings, Steel For Aircraft/Aerospace Equipment RATIONALE This document has been reaffirmed to comply with the SAE five-year review policy. 1. SCOPE This specification establishes requirements for steel forgings of any shape or form from which finished parts are to be made (See 8.2, 8.3, dimensi

6、ons and properties in SI units and the Celsius temperatures are shown as the approximate equivalents of the primary units and are presented only for information. 8.6 Purchase documents should specify not less than the following: AMS 6400 Material specification for the forging stock Forging Part Number and Alloy Designation Quantity Design data from 8.2. PREPARED BY AMS COMMITTEES “E” AND “AMEC”