SAE ARP 1178B-2010 Aircraft Evacuation Signal System《飞行人员疏散信号系统》.pdf

1、_SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising theref

2、rom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2010 SAE International All rights reserved. No part of this publication ma

3、y be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside US

4、A) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.orgSAE values your input. To provide feedback on this Technical Report, please visit http:/www.sae.org/technical/standards/ARP1178BAEROSPACERECOMMENDEDPRACTICEARP1178 REV. B Issued 1971-07 Revised 2010-05Superseding AR

5、P1178A (R) Aircraft Evacuation Signal System RATIONALEThis document is being revised to clarify some of the design and performance recommendations for aircraft evacuation signal systems and clarify the use of the words should and shall within the document. Copyright SAE International Provided by IHS

6、 under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE ARP1178B Page 2 of 31. SCOPE This Aerospace Recommended Practice recommends general criteria for the development and installation of an aircraft emergency signal system to permit any crew me

7、mber (flight or cabin) to inform all other crew members that an emergency evacuation situation exists and that an evacuation has been or should be immediately started. 1.1 PURPOSE The purpose of this document is to assure functionality, usability and performance of emergency evacuation signal system

8、s installed on transport category aircraft. NOTE: It is not the purpose of this document to specify the design method, mechanism, or equipment to be used in the accomplishment of the objective set forth herein. 2. REFERENCES 2.1 Applicable Documents The following publications form a part of this doc

9、ument to the extent specified herein. The latest issue of SAE publications shall apply. The applicable issue of other publications shall be the issue in effect on the date of the purchase order. In the event of conflict between the text of this document and references cited herein, the text of this

10、document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 2.1.1 SAE Publications Available from SAE International, 400 Commonwealth Drive, Warrendale, PA 15096-0001, Tel: 877-606-7323 (inside USA and Canada

11、) or 724-776-4970 (outside USA), www.sae.org.ARP577 Emergency Placarding - Internal and External ARP583 Flight Attendant Stations ARP4102/4 Flight Deck Alerting System (FAS) 2.2 Definitions 2.2.1 AIRCRAFT EVACUATION SIGNAL SYSTEM: An integrated system of audible and visible signals used by crew memb

12、ers to initiate transport aircraft emergency evacuations.2.3 Mandating and Recommending Words 2.3.1 SHALL: Indicates a mandatory criterion. 2.3.2 SHOULD: Indicates a criterion for which an alternative, including non-compliance, may be applied if it is documented and justified. 3. DETAIL RECOMMENDATI

13、ONS 3.1 Evacuation signal system controls shall be located at each cabin crew members station, near the door operating mechanism, and in the flight deck (see ARP583). 3.2 The system shall contain the following features: 3.2.1 Flashing signal light. 3.2.2 Audible signal. Copyright SAE International P

14、rovided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE ARP1178B Page 3 of 33.3 A guarded actuation switch, if not integral to the door opening mechanism, and an audible signal cancel means should be located at the cabin crew member

15、s station near the door. If the actuation switch is integral to the door opening mechanism, it shall be designed not to activate the system if the door is opened from the outside.3.4 Actuation of the system at any station shall automatically actuate the signals at all locations. 3.5 The placarding o

16、f the control switch functions shall be in accordance with ARP577. 3.6 The system should be designed primarily to alert crew members that an emergency evacuation has been or should be immediately started. 3.7 It should be possible to cancel the audible signal at any individual station by a cancel bu

17、tton at that location. The cancel button may also be designed to serve as a test feature. Locally cancelled audible signals shall automatically rearm after the evacuation signal is cancelled. 3.8 The primary evacuation signal control switch shall be located in the flight deck and it shall be accessi

18、ble to the flight crewmembers (captain and first officer) in their seated positions. Regardless of where the system is activated, the system shall automatically rearm itself when the evacuation signal is cancelled using the flight deck controls.3.9 The location of the signal lights should permit the

19、 viewing of the lights in the flight deck and at each cabin crew member station. 3.10 The signal lights should have a raised cover and use an LED, or dual filament bulb to provide visibility at any angle and to reduce probability of an inoperative signal. 3.11 The visible and audible signals should

20、be in accordance with ARP4102/4. The audible signal should be easily distinguishable from any other flight deck signal, cabin warning, or call signal, and should not be alarming to passengers. The audible signal shall not interfere with a crew members ability to communicate with passengers and other

21、 crew members. This may be accomplished by having an intermittent audible signal, an audible signal with a time-out function or by crew member procedure to cancel the audible signal once the emergency evacuation has been initiated (audible signal cancellation means are addressed in section 3.7). 3.1

22、2 The power for the signal system shall be supplied from an aircraft battery or individual emergency batteries to prevent the loss of system function as the result of a malfunction or intentional shut down of the aircrafts primary electrical system. PREPARED BY SAE COMMITTEE S-9,CABIN SAFETY PROVISIONS Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-