SAE AS 3491A-2013 GASKET - TYPE X OR XV ENGINE ACCESSORY DRIVE《垫圈 X 或XV型发动机附件传动装置》.pdf

1、AEROSPACE STANDARD GASKET - TYPE X OR XV ENGINE ACCESSORY DRIVEAS3491Copyright 2013 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or othe

2、rwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1993-03REAFFIRMED 2004-07 STABILIZED 2013-12 THIRD ANG

3、LE PROJECTION CUSTODIAN: E-25 REV.AFEDERAL SUPPLY CLASS 5330 AS3491REV. ASAE Technical Standards Board Rules provide that: “This report ispublishedby SAE toadvance thestate of technicalandengineering sciences. Theuse ofthis report is entirely voluntary, andits applicability and suitability forany pa

4、rticular use,including any patent infringement arising therefrom, isthe soleresponsibilityofthe user.”SAE reviews eachtechnicalreport at least every five years at which time itmay berevised, reaffirmed, stabilized, orcancelled. SAE invites yourwrittencomments andsuggestions. SAE values your input. T

5、o provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS3491ARATIONALE THIS DOCUMENT HAS BEEN DETERMINED TO CONTAIN BASIC AND STABLE TECHNOLOGY WHICH IS NOT DYNAMIC IN NATURE. THIS STANDARD HAS BEEN STABILIZED. STABILIZED NOTICE THIS DOCUMENT HAS BEEN DECLARE

6、D “STABILIZED“ BY THE SAE E-25 GENERAL STANDARDS FOR AEROSPACE AND PROPULSION SYSTEMS COMMITTEE AND WILL NO LONGER BE SUBJECTED TO PERIODIC REVIEWS FOR CURRENCY. USERS ARE RESPONSIBLE FOR VERIFYING REFERENCES AND CONTINUED SUITABILITY OF TECHNICAL REQUIREMENTS. NEWER TECHNOLOGY MAY EXIST. Copyright

7、SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD AS3491 SHEET 1 OF 2 REV. A GASKET - TYPE X OR XV ENGINE ACCESSORY DRIVE FIGURE 1 Copyright SAE International Provided by IHS under license wit

8、h SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD AS3491 SHEET 2 OF 2 REV. A GASKET - TYPE X OR XV ENGINE ACCESSORY DRIVE NOTES:1. PROCUREMENT SPECIFICATION AND MATERIAL: NONASBESTOS FIBER AND NBR RUBBER SHEET, AMS 3275./2/ COMPRESSIBILITY OF

9、MATERIAL IS BASED ON .016 BASIC THICKNESS.3. EDGES SHALL BE CLEAN CUT.4. DIMENSIONING AND TOLERANCING: ANSI Y14.5M.5. DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, LINEAR DIMENSIONS .010.6. PART NUMBER: AS3491-01.7. AS AND AMS ARE SAE PUBLICATIONS.8. ANSI IS AMERICAN NATIONAL STANDARDS INSTITUTE PUBLICATION.Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-