SANS 11040-1-2007 Prefilled syringes Part 1 Glass cylinders for dental local anaesthetic cartridges《带药注射器 第1部分 牙科局部麻醉药筒用玻璃筒》.pdf

1、 Collection of SANS standards in electronic format (PDF) 1. Copyright This standard is available to staff members of companies that have subscribed to the complete collection of SANS standards in accordance with a formal copyright agreement. This document may reside on a CENTRAL FILE SERVER or INTRA

2、NET SYSTEM only. Unless specific permission has been granted, this document MAY NOT be sent or given to staff members from other companies or organizations. Doing so would constitute a VIOLATION of SABS copyright rules. 2. Indemnity The South African Bureau of Standards accepts no liability for any

3、damage whatsoever than may result from the use of this material or the information contain therein, irrespective of the cause and quantum thereof. ISBN 978-0-626-20088-6 SANS 11040-1:2007Edition 1ISO 11040-1:1992Edition 1SOUTH AFRICAN NATIONAL STANDARD Prefilled syringes Part 1: Glass cylinders for

4、dental local anaesthetic cartridges This national standard is the identical implementation of ISO 11040-1:1992 and is adopted with the permission of the International Organization for Standardization. Published by Standards South Africa 1 dr lategan road groenkloof private bag x191 pretoria 0001 tel

5、: 012 428 7911 fax: 012 344 1568 international code + 27 12 www.stansa.co.za Standards South Africa SANS 11040-1:2007 Edition 1 ISO 11040-1:1992 Edition 1 Table of changes Change No. Date Scope National foreword This South African standard was approved by National Committee StanSA TC 5140.35, Dental

6、 equipment and materials, in accordance with procedures of Standards South Africa, in compliance with annex 3 of the WTO/TBT agreement. This SANS document was published in September 2007. INTERNATIONAL STANDARD L ISO 11040-1 First edition 1992-1 I-1 5 Prefilled syringes - Part 1: Glass cylinders for

7、 dental local anaesthetic cartridges Seringues pr - the stated tolerantes of the neck opening are maintained; - the diameter of the neck opening at the inner end and at the cone may be a maximum of 0,3 mm smaller than the top (3,15 mm b) the designation of the cylinders; c) the name or Symbol of the manufacturer; d) the lot number (only if the cylinder is printed) or date of production. Standards South AfricaSANS 11040-1:2007 Standards South AfricaThis s tandard may only be used and printed by approved subscription and freemailing clients of the SABS .