SMPTE RP 54-1999 Edge Numbering on 16-mm Release Prints.pdf

1、STD=SMPTE RP 54-ENGL 1999 e 8357403 0003594 bob 111 SMPTE RECOMMENDED PRACTICE Edge Numbering on 16-mm Release Prints RP 54-1999 Revision of RP 54-1994 1 Scope This practice covers the size, type, and frequency of numbers placed on 16-mm release prints. The purpose of these numbers is usually to det

2、ermine specific locations on multiple-copy release prints of the same subjects. 2 Normative reference The following standard contains provisions which, through reference in this text, constitute provisions of this practice. At the time of publication, the edition indicated was valid. All standards a

3、re subject to revision, and parties to agreements based on this practice are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. ANSVSMPTE 83-1 996, Motion-Picture Film (1 6-mm) - Edge Numbers - Location and Spacing 3 Specifications 3.1 The

4、size, type, and location of the numbers shall be as specified in ANSVSMPTE 83. 3.2 The frequency of the numbers for release print use shall be 40 frames, with each number increasing one digit from a 0000 start at the head of the print consecutively to the end of the print. In this manner, the number

5、s represent a footage scale on the print. NOTE - Other numbers may appear on the release prints. These numbers may be at different intervals than 40 frames, may differ in sequence and magnitude, and have no relation to the function of footage numbers for release print footage purposes. Copyright O 1999 by the SOCIETY OF MOTION PICTURE AND TELEVISION ENGINEERS 595 W. Hartcdale Ave., White Plains, NY 10607 (914) 761-1 100 Approved April 22, 1999