SMPTE RP 94-2000 Gain Determination of Front Projection Screens《前投影屏幕的增益测定》.pdf

1、STD-SMPTE RP 94-ENGL 2000 83574011 0004376 954 ei SMPTE RECOMMENDED PRACTICE Gain Determination of Front Projection Screens RP 94-2000 Revision of RP 94-1993 Introduction Screen gain is the ratio of the test luminance to the luminance of a lambert diffuser under the same viewing conditions and angle

2、 Screen gain varies with the angle of view, because of the laws of reflection and the nature of the screen surface. Screen gain is basically directional and, thus, the maximum screen gain number is misleading be- cause it is an incomplete description as it relates to an entire screen. The hot-spot

3、on a screen is the full screen gain in operation at that spot. 1 Scope This practice specifies a method for measurement of screen gain. 2 Formula Screen gain is a ratio: Luminance of test screen Luminance of lambert diffuser Gain = 3 Measurement 3.1 The test screen sample shall be illuminated with d

4、iscrete projection lamp light rays at or near perpendicular to the screen surface, in a dark- ened room area (see annex A.2). 3.2 The luminance of the screen sample shall be measured at 5-degree intervals. The measurements Page 1 of 2 pages shall be in the horizontal plane (and vertical, if differen

5、t) that pass through the perpendicular to the screen surface. 3.3 The maximum gain shall be labeled as such. The maximum gain advantage is assumed to have rolled off to below 1 .O at 30“ off axis unless otherwise noted. 3.4 In testing screens already installed in theaters, the methods specified in 3

6、1 and 3.2 may be altered to accept the existing projection angle and seating arrangements (see annex A.l). 4 Instruments 4.1 The goniophotometer shall measure only the luminance of the perpendicularly illuminated area on the screen. 4.2 The photometer (see 4.1) shall have a spectral response of a s

7、tandard observer with photopic vision (see annex A.6). 4.3 A diffuse reference standard similar to a lambert diffuser, which reflects all incident light so that the luminance is the same regard- less of the angle of view, shall be used and shall be specified with the screen gain. The standard could

8、be magnesium oxide (MgO), barium sulfate (BaS04), magnesium carbonate (MgCos), standardized matte white cardboard, or a matte white screen of calibrated reflec- tance. Copyright Q 2000 by THE SOCIETY OF MOTION PICTURE AND TELEVISION ENGINEERS 595 W. Hartsdaie Ave., White Plains, NY 10607 (914) 761-1

9、100 Approved June 9,2000 RP 94-2000 Annex A (informative) Additional data STDmSMPTE RP 74-ENGL 2000 H 8357403 0004377 870 A.l In order to obtain an estimated gain value for an in- stalled screen, one might measure the screen light at the screen center from the middle seat, and then repeat the screen

10、 center light reading from the end of the middle row (estimated to be 30“). The light ratio of center over side reading will approximate the estimated gain. Or a head-on light reading can be compared with a nongloss sheet of paper over the same spot. A.2 When a goniophotometer is used to measure lum

11、i- nance, the photometer may see all of the perpendicularly illuminated spot on the screen sample at all angles. There- fore, the luminance readings may have to be corrected by dividing by the cosine of the angle. If the photometer sees only the small center of the perpendiculariy illuminated area,

12、the correction is not required. provide more than one-half the maximum gain. In a situation where the gain is over 1.3, the gain screen should be curved to allow the sides to reflect best to the center seating area (see SMPTE AP 95). A.4 Some subjective gain errors may occur because a typical theate

13、r audience has a mesopic eye response, determined by how long the viewer is in the theater, the ambient light, the subtended screen size, film subject matter, and the projector lumen output. Therefore, some observers may not agree with the numerically calculated gain. A.5 Retroflective screens, such

14、 as glass-beaded screens, reflect maximum gain back to the projector, regardless of projection angle. A.3 Useful angles in achieving good audience coverage for a gain screen are the angles which provide the necessary recommended screen luminance (see ANSIISMPTE 196M). In most cases, the angles would

15、 be limited to those which A.6 References to instrument spectral response and required theater illumination are listed in ANSI/SMPTE 196M. Annex B (informative) Bib1 iog raphy ANSVSMPTE 196M-1995, Motion-Picture Film - Indoor SMPTE RP 95-1994, Installation of Gain Screens Theater and Review Room Projection -Screen Luminance and Viewing Conditions Page 2 of 2 pages