TIA-2000 5-D-2004 Upper Layer (Layer 3) Signaling Standard for cdma2000 Spread Spectrum Systems《CDMA2000扩频系统的上层(层3)信令标准》.pdf

1、 TIA DOCUMENT Upper Layer (Layer 3) Signaling Standard for cdma2000 Spread Spectrum Systems TIA-2000.5-D (Revision of TIA/IS-2000.5-C) MARCH 2004 TELECOMMUNICATIONS INDUSTRY ASSOCIATION The Telecommunications Industry Association represents the communications sector of Copyright Telecommunications I

2、ndustry Association Provided by IHS under license with EIANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-NOTICE TIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and pur

3、chasers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for their particular need. The existence of such Publications shall not in any respect preclude any member or non-member of TIA from manu

4、facturing or selling products not conforming to such Publications. Neither shall the existence of such Documents preclude their voluntary use by non-TIA members, either domestically or internationally. TIA DOCUMENTS TIA Documents contain information deemed to be of technical value to the industry, a

5、nd are published at the request of the originating Committee without necessarily following the rigorous public review and resolution of comments which is a procedural part of the development of a American National Standard (ANS). Further details of the development process are available in the TIA En

6、gineering Manual, located at http:/www.tiaonline.org/standards/sfg/engineering_manual.cfm TIA Documents shall be reviewed on a five year cycle by the formulating Committee and a decision made on whether to reaffirm, revise, withdraw, or proceed to develop an American National Standard on this subjec

7、t. Suggestions for revision should be directed to: Standards MS request12 16 C-2.10 Reduced Slot Cycle Mode - MS initiated release; BS request 13 17 C-2.11 Reduced Slot Cycle Mode - BS initiated release; BS request.14 18 C-2.12 Reduced Slot Cycle Mode - BS initiated release; MS request 15 19 C-2.13

8、Reduced Slot Cycle Mode - MS initiated in Idle State .16 20 C-2.14 Reduced Slot Cycle Mode - BS initiated in Idle State17 21 C-2.15 Direct to Idle transition example 18 22 C-3 SYNC_ID enhancements 19 23 C-3.1 SYNC_ID in Origination/Page Response/Reconnect Message and BS 24 grants it via ECAM or SCM

9、19 25 C-3.2 SYNC_ID in Origination/Page Response/Reconnect Message and BS 26 assigns a different one in ECAM or SCM 20 27 C-3.3 Incremental restoration of stored service option connections with SYNC_ID 28 (OM + EOM example) .21 29 C-3.4 Initiate M of N service option connections from SYNC_ID .22 30 C-4 DV Control Hold 23 31 C-4.1 BS initiated transition from DV Control Hold Mode (F-PDCH without F-32 DCCH) .23 33 Copyright Telecommunications Industry Association Provided by IHS under license with EIANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-