BS EN 1176-7-1997 游乐场器材.安装指南,检验,维护和操作.pdf

1、| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | BRITISH STANDARD BS EN 1176-7 : 1997 The European Standard E

2、N 1176-7 : 1997 has the status of a British Standard ICS 97.190; 97.200.40 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW Playground equipment Part 7: Guidance on installation, inspection, maintenance and operation Licensed Copy: London South Bank University, London South Ban

3、k University, Fri Nov 17 06:16:55 GMT+00:00 2006, Uncontrolled Copy, (c) BSIThis British Standard, having been prepared under the direction of the Consumer Products and Services Sector Board, was published under the authority of the Standards Board and comes into effect on 15 December 1997 BSI 1997

4、ISBN 0 580 28939 7 BS EN 1176-7 : 1997 Amendments issued since publication Amd. No. Date Text affected National foreword This British Standard is the English language version of EN 1176-7 : 1997. It will supersede BS 5696 : Part 3 : 1979 which will be withdrawn on 31 December 1998. Until the other s

5、ix parts of EN 1176 are published, BS 5696 should still be used as the national standard. The UK participation in its preparation was entrusted to Technical Committee SW/65, Childrens playground equipment, which has the responsibility to: aid enquirers to understand the text; present to the responsi

6、ble European committee any enquiries on the interpretation, or proposals for change, and keep the UK interests informed; monitor related international and European developments and promulgate them in the UK. A list of organizations represented on this committee can be obtained on request to its secr

7、etary. Cross-references The British Standards which implement international or European publications referred to in this document may be found in the BSI Standards Catalogue under the section entitled International Standards Correspondence Index, or by using the Find facility of the BSI Standards El

8、ectronic Catalogue. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, the EN title page, pages 2 to 6, an inside back cover and a back cover. Licensed Copy: London South Bank Un

9、iversity, London South Bank University, Fri Nov 17 06:16:55 GMT+00:00 2006, Uncontrolled Copy, (c) BSICEN European Committee for Standardization Comite Europe en de Normalisation Europa isches Komitee fu r Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1997 CEN All rights of exploi

10、tation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 1176-7 : 1997 E EUROPEAN STANDARD EN 1176-7 NORME EUROPE ENNE EUROPA ISCHE NORM September 1997 ICS 97.190; 97.200.40 Descriptors: Playground, recreation facilities, toys, communal equipment, safety requireme

11、nts, accident prevention, installation, inspection, maintenance, utilization English version Playground equipment Part 7: Guidance on installation, inspection, maintenance and operation Equipements daires de jeux Partie 7: Guide dinstallation, contro le, maintenance et utilisation Spielplatzgera te

12、Teil 7: Anleitung fu r Installation, Inspektion, Wartung und Betrieb This European Standard was approved by CEN on 1997-08-25. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard

13、without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other langua

14、ge made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Ic

15、eland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. Licensed Copy: London South Bank University, London South Bank University, Fri Nov 17 06:16:55 GMT+00:00 2006, Uncontrolled Copy, (c) BSIPage 2 EN 1176-7 : 1997 BSI 1997 Foreword This Eur

16、opean Standard has been prepared by Technical Committee CEN/TC 136, Sports, playground and other recreational equipment, the secretariat of which is held by DIN. BT has decided to package EN 1176-1, EN 1176-7 and EN 1177. In accordance with the CEN/CENELEC Internal Regulations, the latest date by wh

17、ich national standards conflicting with this European Standard have to be withdrawn is 1998-12-31. This standard consists of a number of parts as follows: prEN 1176-1 Playground equipment Part 1: General safety requirements and test methods prEN 1176-2 Playground equipment Part 2: Additional specifi

18、c safety requirements and test methods for swings prEN 1176-3 Playground equipment Part 3: Additional specific safety requirements and test methods for slides prEN 1176-4 Playground equipment Part 4: Additional specific safety requirements and test methods for runways prEN 1176-5 Playground equipmen

19、t Part 5: Additional specific safety requirements and test methods for carousels prEN 1176-6 Playground equipment Part 6: Additional specific safety requirements and test methods for rocking equipment EN 1176-7 Playground equipment Part 7: Guidance on installation, inspection, maintenance and operat

20、ion. and should be read in conjunction with prEN 1176-1 to 6 and EN 1177, Impact absorbing playground surfacing Safety requirements and test methods. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest b

21、y March 1998, and conflicting national standards shall be withdrawn at the latest by December 1998. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denm

22、ark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. Contents Page Foreword 2 1 Scope 3 2 Normative references 3 3 Definitions 3 4 General 3 5 Installation 3 6 Inspection and maintenance 3 7 Insp

23、ection schedule 4 8 Operation 4 Licensed Copy: London South Bank University, London South Bank University, Fri Nov 17 06:16:55 GMT+00:00 2006, Uncontrolled Copy, (c) BSIPage 3 EN 1176-7 : 1997 BSI 1997 1 Scope This Part of EN 1176 gives guidance for the installation, inspection, maintenance and oper

24、ation of playground equipment. NOTE. For the purpose of this standard, the term equipment includes surfacing. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places i

25、n the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred

26、to applies. prEN 1176-1 : 1996 Playground equipment Part 1: General safety requirements and test methods 3 Definitions For the purposes of this part of EN 1176, the definitions given in prEN 1176-1 apply. 4 General 4.1 If equipment is not safe, access by the public should be prevented. NOTE. Example

27、s of situations where the equipment is not safe are as follows: safe installation of equipment is not complete; impact absorbing surface is not yet installed; where maintenance cannot ensure a continuing level of safety. 4.2 A book or inspection and servicing sheets should be kept by the owner/opera

28、tor in charge of the equipment maintenance and inspection. 5 Installation 5.1 Equipment should be installed in a safe way. 5.2 Equipment should be installed according to the manufacturers instructions (see clause 6 of prEN 1176-1 : 1996 and EN 1177). 6 Inspection and maintenance 6.1 Equipment and it

29、s components should be inspected and maintained according to the manufacturers instructions at a frequency not less than that given by the manufacturer (see clause 6 of prEN 1176-1 : 1996). 6.2 Equipment and its components should be inspected as follows. a) Routine visual inspection The routine visu

30、al inspection enables the identification of obvious hazards that can result from vandalism, use or weather conditions, e.g. the hazards can take the form of broken parts or broken bottles. For playgrounds subject to heavy use or vandalism, daily inspection of this type can be necessary. NOTE. Exampl

31、es of visual and operational inspection points are cleanliness, equipment ground clearances, ground surface finishes, exposed foundations, sharp edges, missing parts, excessive wear (of moving parts) and structural integrity. b) Operational inspection The operational inspection is a more detailed in

32、spection to check the operation and stability of the equipment, especially for any wear. This should be carried out every 1 to 3 months, or as indicated by the manufacturers instructions. Special attention should be given to sealed-for-life parts. c) Annual main inspection The annual main inspection

33、 is done to establish, at intervals not exceeding 12 months, the overall level of safety of equipment, foundations and surfaces, e.g. effects of weather, evidence of rotting or corrosion, and any change in the level of safety of the equipment as a result of repairs made, or of added or replaced comp

34、onents. Special attention should be given to sealed-for-life parts. NOTE 1. The annual main inspection can require excavation or dismantling of certain parts. This inspection of the equipment should be carried out by competent persons in strict accordance with the manufacturers instructions. NOTE 2.

35、 The level of competence required will vary with the task. Licensed Copy: London South Bank University, London South Bank University, Fri Nov 17 06:16:55 GMT+00:00 2006, Uncontrolled Copy, (c) BSIPage 4 EN 1176-7 : 1997 BSI 1997 7 Inspection schedule 7.1 In order to prevent accidents, the owner or o

36、perator should ensure that an appropriate inspection schedule is established and maintained for each playground. This should take into account local conditions and the manufacturers instructions that can affect the necessary inspection frequency. The schedule should list the components to be inspect

37、ed at the various inspections and the methods of carrying out the inspections, in accordance with 6.2. 7.2 If serious defects that put safety at risk are discovered during inspection, these should be corrected without delay. If this is not possible, the equipment should be secured against use, e.g.

38、immobilization or removal. Where a piece of equipment is to be removed from the site, for example for maintenance, any anchorages or foundations left in the ground should be removed or safeguarded and the site made safe. 8 Operation 8.1 General recommendations 8.1.1 The operator or owner should take

39、 into account in all steps of design, installation, inspection, maintenance and operation, the manufacturers information e.g. pre-information/catalogue, installation instructions and maintenance instructions. 8.1.2 The operator should set up an appropriate system for the safety management of the pla

40、yground. NOTE. For the purposes of this standard the term safety management is defined as the organization set up by the operator of the playground to assess, maintain and, if necessary to improve the safety of the playground as a whole, including the equipment and the surfaces. 8.2 Specific recomme

41、ndations 8.2.1 Assessment of safety measures The operator of a playground should periodically, at least once a year, and systematically assess the effectiveness of all the safety measures used (including the recommendations given in this standard) and alter them if it is found necessary on the basis

42、 of experience, or if circumstances have changed. 8.2.2 Personnel Personnel performing tasks as a part of safety management, such as inspection, repair and maintenance, should be competent. The level of competence will vary with the task and training can be necessary. The personnel should have adequ

43、ate information about their tasks and adequate information about their responsibilities and authority. Particular work, such as welding parts of a structure, that is deemed to affect the safety of the equipment should only be carried out by qualified personnel. 8.2.3 Documentation Records should be

44、kept of all actions taken as part of safety management. The documents relating to a playground should include: a) the certificate of inspection and testing, if applicable; b) inspection and maintenance instructions; c) operating instructions, if applicable; d) operators records, e.g. log book; and e

45、) specific design and tender documents. These documents should be kept so as to be accessible when needed in connection with maintenance, inspection and repair. 8.2.4 General safety measures On the playground there should be a sign (pictogram) indicating the nearest facility, e.g. telephone, for con

46、tacting emergency services and a contact number to report serious damage. The entry, exit and emergency paths to and from a playground, intended for use by the public and emergency services, should be accessible and free of obstacles at all times. NOTE. Attention is drawn to local regulations concer

47、ning such facilities. 8.2.5 Procedures Defects that occur during operation and which put safety at risk should be corrected without delay. If this is not possible, the equipment should be secured against use e.g. by immobilization or removal. Written procedures covering the measures to be taken in t

48、he event of accidents, fire and the like should be available. Until unsafe equipment is repaired and released for use access by the public should be prevented. Information about accidents brought to the attention of the manager should be recorded on a form that includes the following details: a) dat

49、e and time of accident; b) age and sex of victim and clothing worn, including footwear; c) equipment involved; d) number of children on site at the time of the accident; e) description of accident; f) injury sustained including part(s) of body affected; g) action taken; h) witness statements; and i) any subsequent equipment modification. This information should be used to improve the safety of the playground. Licensed Copy: London South Bank University, London South Bank University, Fri Nov 17 06:16:55 GMT+0