IEC 60068-2-39-2015 Environmental testing - Part 2-39 Tests - Tests and guidance Combined temperature or temperature and humidity with low air pressure tests《环境试验 第2-39部分 试验 试验和指南 通过低气压试验获得的结合温度或者.pdf

1、 IEC 60068-2-39 Edition 2.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Environmental testing Part 2-39: Tests Tests and guidance: Combined temperature or temperature and humidity with low air pressure tests Essais denvironnement Partie 2-39: Essais Essais et lignes directrices: Essais combi

2、ns de temprature ou de temprature et dhumidit basse pression atmosphrique IEC 60068-2-39:2015-09(en-fr) THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2015 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any fo

3、rm or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to t

4、his publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lec

5、tronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions sur le copyright de lIEC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs

6、 ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization

7、 that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment mig

8、ht have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technical Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC

9、 publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Sta

10、y up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitio

11、ns in English and French, with equivalent terms in 15 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary More than 60 000 electrotechnical terminology entries in English and French extracted from the Terms and Definition

12、s clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Custome

13、r Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le co

14、ntenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les No

15、rmes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de publications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numr

16、o de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible e

17、n ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans 15 langues additionnelles. Egalement

18、 appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 60 000 entres terminologiques lectrotechniques, en anglais et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieure

19、s extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 60068-2-39 Edition 2.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIO

20、NALE Environmental testing Part 2-39: Tests Tests and guidance: Combined temperature or temperature and humidity with low air pressure tests Essais denvironnement Partie 2-39: Essais Essais et lignes directrices: Essais combins de temprature ou de temprature et dhumidit basse pression atmosphrique I

21、NTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE ICS 19.040 ISBN 978-2-8322-2897-5 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publicat

22、ion from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. 2 IEC 60068-2-39:2015 IEC 2015 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope and object . 6 2 Normative references 6 3 Terms and definitions 6 4 Testing 6 4.1 General

23、 . 6 4.2 Preferred combinations . 6 4.3 Initial measurement and functional performance test . 7 4.4 Test procedure 7 4.4.1 Preconditioning 7 4.4.2 Test with temperature and low air pressure 7 4.4.3 Test with temperature, humidity and low air pressure . 9 5 Final measurements 12 6 Information to be g

24、iven in the relevant specification . 12 7 Information to be given in the test report 12 Annex A (informative) Guidance on combined temperature or temperature and humidity with low air pressure testing 14 A.1 General . 14 A.2 Environmental effects . 14 A.3 Measurement of temperature 14 Bibliography 1

25、6 Figure 1 Example of test sequence with cold temperature and low air pressure . 8 Figure 2 Example of test sequence with dry heat and low air pressure . 9 Figure 3 Example of test sequence of temperature and humidity with low air pressure . 11 Table 1 Test severities . 7 IEC 60068-2-39:2015 IEC 201

26、5 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ENVIRONMENTAL TESTING Part 2-39: Tests Tests and guidance: Combined temperature or temperature and humidity with low air pressure tests FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comp

27、rising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Stan

28、dards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this prep

29、aratory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organ

30、izations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form

31、of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretati

32、on by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regi

33、onal publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out

34、by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees

35、for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the N

36、ormative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held re

37、sponsible for identifying any or all such patent rights. International Standard IEC 60068-2-39 has been prepared by IEC technical committee 104: Environmental conditions, classification and methods of test. This second edition cancels and replaces the first edition published in 1976 and constitutes

38、a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) preferred severities of the IEC 60068 series; b) combined temperature, humidity and low air pressure 4 IEC 60068-2-39:2015 IEC 2015 The text of this standard is based on t

39、he following documents: FDIS Report on voting 104/657/FDIS 104/661/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of al

40、l parts in the IEC 60068 series, published under the general title Environmental testing, can be found on the IEC website. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in the

41、 data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IEC 60068-2-39:2015 IEC 2015 5 INTRODUCTION Equipment and components are required to function without significant reduction in performance when subjecte

42、d to different environmental parameters. The combination of temperature, humidity and low air pressure may have certain effects on components and gaskets, for example. The type and severity of the environmental parameters depend on the operational, transport and storage environments to which the equ

43、ipment and components are subjected. The environmental effects on the performance of equipment in the tropics and subtropics are totally different from those in arctic regions. Individual environmental parameters cause a variety of different and overlapping effects on the equipment and components. T

44、he manufacturer attempts to ensure, and the user expects, that equipment and components will survive the environments to which they will be subjected throughout their useful life. This expectation can be assessed by exposure of the specimen to a range of simulated environmental parameters controlled

45、 in the laboratory. The severity of the environmental parameters is often increased to obtain meaningful results in a relatively short period of time. This allows assessment of the likely effects of applied environmental conditions. 6 IEC 60068-2-39:2015 IEC 2015 ENVIRONMENTAL TESTING Part 2-39: Tes

46、ts Tests and guidance: Combined temperature or temperature and humidity with low air pressure tests 1 Scope and object This part of IEC 60068 provides a description of test methods and guidance for testing of equipment or components under combined temperature or temperature and humidity with low air

47、 pressure tests. The object of combined testing is to investigate to what extent the equipment or components are affected by combined temperature or temperature and humidity with low air pressure tests. The method of combined tests detects electrical, mechanical or other physical variations. 2 Norma

48、tive references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments)

49、applies. IEC 60068-1, Environmental testing Part 1: General and guidance IEC 60068-2-78, Environmental testing Part 2-78: Tests Test Cab: Damp heat, steady state 3 Terms and definitions None. 4 Testing 4.1 General All values of test parameters such as cold, dry heat, low air pressure, humidity, exposure time and conditions such as state of operation and so on, should be selected from the IEC 60068-2 s