IEC 60794-3-60-2008 Optical fibre cables - Part 3-60 Outdoor cables - Family specification for drinking water pipe cables and subducts for installation by blowing and or pulling dr.pdf

1、 IEC 60794-3-60 Edition 1.0 2008-10 INTERNATIONAL STANDARD NORME INTERNATIONALE Optical fibre cables Part 3-60: Outdoor cables Family specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes Cbles fibres optiques P

2、artie 3-60: Cbles extrieurs Spcification de famille pour les cbles de canalisations deau potable et les sous-conduites destins tre installs par soufflage et/ou tirage/tranage/flottaison dans les canalisations deau potable IEC 60794-3-60:2008 colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copy

3、right 2008 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member Nat

4、ional Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs

5、. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si

6、 vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 91

7、9 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The tec

8、hnical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publications search - www.iec.ch/searchpub The advanced search enables you to find IEC publication

9、s by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released.

10、 Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the Int

11、ernational Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de la CEI La Commission Electrotechnique Internatio

12、nale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer

13、que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle d

14、onne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois pa

15、r email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrot

16、echnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 60794-3-60 Edition 1.0 2008-10 INTERNATIONAL STANDARD NORME INTERNATIONALE Optical fibre cables

17、Part 3-60: Outdoor cables Family specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes Cbles fibres optiques Partie 3-60: Cbles extrieurs Spcification de famille pour les cbles de canalisations deau potable et l

18、es sous-conduites destins tre installs par soufflage et/ou tirage/tranage/flottaison dans les canalisations deau potable INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE V ICS 33.180.10 PRICE CODE CODE PRIX ISBN 978-2-88912-910-2 Registered trademark of the Intern

19、ational Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside 2 607

20、94-3-60 IEC:2008 CONTENTS FOREWORD . 4 1 Scope . 6 2 Normative references . 6 3 Symbols and abbreviations . 7 4 Family specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes (blank detail specification and minimu

21、m requirements) . 8 4.1 Construction 8 4.1.1 General . 8 4.1.2 Subducts . 8 4.1.3 Drinking water pipe cables . 8 4.2 Optical fibres . 9 4.2.1 Single-mode dispersion unshifted (B1.1) optical fibre 9 4.2.2 Single-mode dispersion shifted (B2) optical fibre . 9 4.2.3 Single-mode non-zero dispersion (B4)

22、 optical fibre 10 4.2.4 Single-mode (B6) optical fibre . 10 4.2.5 Multimode fibres 10 4.3 Drinking water pipe cable constructions . 11 4.3.1 Cable for installation within subducts (previously installed within the drinking water pipe) . 11 4.3.2 Cable for direct installation into the drinking water p

23、ipes . 12 4.3.3 Subduct construction . 13 4.4 Installation and operating conditions . 13 4.4.1 Tests applicable to cables/cable elements . 13 4.4.2 Installation conditions 13 4.5 Mechanical and environmental tests 14 4.5.1 Subducts . 14 4.5.2 Cable for installation within subducts (previously instal

24、led into the drinking water pipes) . 17 4.5.3 Cables for direct installation into the drinking water pipe . 21 Annex A (informative) Blank detail specification . 25 Annex B (informative) OF cables for drinking water pipes 28 Annex C (informative) Examples of subducts and drinking water pipe cables .

25、 29 Annex D (informative) Example for installation schemes of optical fibre cables in drinking water pipes (fibre in drinking water pipes) 31 Figure C.1 Examples of constructions of cables for installation in subducts within drinking water pipes 29 Figure C.2 Examples of constructions for drinking w

26、ater pipe cables . 30 Figure D.1 Schematic drawing I/O-port for OF cables into drinking water lines 31 Figure D.2 Schematic drawing Installation of OF cables in drinking water lines . 32 Figure D.3 Installation of I/O-ports on high pressure PE drinking water pipe 32 Table 1 Single-mode dispersion un

27、shifted (B1.1) optical fibre 9 Table 2 Single-mode dispersion shifted (B2) optical fibre . 9 60794-3-60 IEC:2008 3 Table 3 Single-mode non-zero dispersion (B4) optical fibre 10 Table 4 Single-mode (B6) optical fibre . 10 Table 5 Characteristics Cable for installation within subducts . 11 Table 6 Cha

28、racteristics Cable for direct installation within the high pressure gas pipe 12 Table 7 Characteristics Subduct construction 13 Table 8 Tests applicable to cables/cable elements . 13 Table 9 Subducts tests applicable . 14 Table 10 Tests applicable to the cable for installation within subducts . 17 T

29、able 11 Tests applicable to the cables for direct installation into the drinking water pipe 21 Table A.1 Cable for installation within subducts . 25 Table A.2 Cables for direct installation into the drinking water pipes 26 Table A.3 Subduct description . 27 Table B.1 OF cables for drinking water pip

30、es . 28 4 60794-3-60 IEC:2008 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ OPTICAL FIBRE CABLES Part 3-60: Outdoor cables Family specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes FOREWORD 1) The International

31、 Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fi

32、elds. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any I

33、EC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardiz

34、ation (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has represe

35、ntation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC c

36、annot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publicat

37、ions. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IE

38、C Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injur

39、y, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references ci

40、ted in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identify

41、ing any or all such patent rights. International Standard IEC 60794-3-60 has been prepared by subcommittee 86A: Fibres and cables, of IEC technical committee 86: Fibre optics. This standard is to be used in conjunction with IEC 60794-1-1, IEC 60794-1-2 and IEC 60794-3. This bilingual version (2012-0

42、2) corresponds to the monolingual English version published in 2008-10. 60794-3-60 IEC:2008 5 The text of this standard is based on the following documents: FDIS Report on voting 86A/1232/FDIS 86A/1243/RVD Full information on the voting for the approval of this standard can be found in the report on

43、 voting indicated in the above table. The French version of this standard has not been voted upon. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of all parts of IEC 60794 series, under the general title Optical fibre cables, can be found on the IEC websi

44、te. The committee has decided that the contents of this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, repla

45、ced by a revised edition, or amended. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer. 6 60794-

46、3-60 IEC:2008 OPTICAL FIBRE CABLES Part 3-60: Outdoor cables Family specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes 1 Scope This part of IEC 60794 is a family specification that covers drinking water pipe

47、cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes. Systems built with components covered by this standard are subject to the requirements of sectional specification IEC 60794-3. Drinking water pipe cable and subduct constructions have to meet th

48、e different requirements of the drinking water companies and/or associations regarding chemical, environmental, operational interactions and in general maintenance conditions. A table of preferential applications, describing drinking water pipe cable characteristics versus methods of installation is

49、 reported in Annex A for drinking water pipe cables. Clause 4 describes a blank detail specification for drinking water pipe cables and subducts for installation by blowing and/or pulling/dragging/floating in drinking water pipes. It incorporates some minimum requirements. Detail specifications may be prepared on the basis of this family specification. The parame