IEC 61000-3-3-2013 Electromagnetic compatibility (EMC) - Part 3-3 Limits - Limitation of voltage changes voltage fluctuations and flicker in public low-voltage supply systems for e.pdf

1、 S+ IEC 61000-3-3 Edition 3.0 2013-05 IEC STANDARDS+ Electromagnetic compatibility (EMC) Part 3-3: Limits Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current 16 A per phase and not subject to conditional connection Co

2、mpatibilit lectromagntique (CEM) Partie 3-3: Limites Limitation des variations de tension, des fluctuations de tension et du papillotement dans les rseaux publics dalimentation basse tension, pour les matriels ayant un courant assign 16 A par phase et non soumis un raccordement conditionnel S+ IEC 6

3、1000-3-3:2013 colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2013 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and mic

4、rofilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member N

5、ational Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccor

6、d crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. I

7、EC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electri

8、cal, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publications search - www.

9、iec.ch/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new

10、 IEC publications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and Fren

11、ch, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre:

12、 csciec.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique

13、 des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en util

14、isant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelle

15、s publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalen

16、ts dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. S+ IEC 61000-3-3 Edition 3.0

17、 2013-05 IEC STANDARDS+ Electromagnetic compatibility (EMC) Part 3-3: Limits Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current 16 A per phase and not subject to conditional connection Compatibilit lectromagntique (C

18、EM) Partie 3-3: Limites Limitation des variations de tension, des fluctuations de tension et du papillotement dans les rseaux publics dalimentation basse tension, pour les matriels ayant un courant assign 16 A par phase et non soumis un raccordement conditionnel INTERNATIONAL ELECTROTECHNICAL COMMIS

19、SION COMMISSION ELECTROTECHNIQUE INTERNATIONALE RC ICS 33.100.10 PRICE CODE CODE PRIX ISBN 978-2-83220-781-9 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from

20、an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside IEC 61000-3-3 Edition 3.0 2013-05 INTERNATIONAL STANDARD NORME INTERNATIONALE Electromagnetic compatibility (EMC) Part 3-3: Limits Limitation of voltage changes,

21、voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current 16 A per phase and not subject to conditional connection Compatibilit lectromagntique (CEM) Partie 3-3: Limites Limitation des variations de tension, des fluctuations de tension et du papillotemen

22、t dans les rseaux publics dalimentation basse tension, pour les matriels ayant un courant assign 16 A par phase et non soumis un raccordement conditionnel IEC 61000-3-3:2013 2 61000-3-3 IEC:2013 CONTENTS FOREWORD . 4 INTRODUCTION . 6 1 Scope . 7 2 Normative references . 7 3 Terms and definitions . 8

23、 4 Assessment of voltage changes, voltage fluctuations and flicker 10 4.1 Assessment of a relative voltage change, d(t) 10 4.2 Assessment of the short-term flicker value, P st. 10 4.2.1 General . 10 4.2.2 Flickermeter 11 4.2.3 Simulation method . 11 4.2.4 Analytical method 11 4.2.5 Use of P st = 1 c

24、urve 12 4.3 Assessment of long-term flicker value, P lt. 12 5 Limits . 12 6 Test conditions . 13 6.1 General . 13 6.2 Measurement uncertainty 14 6.3 Test supply voltage . 14 6.4 Reference impedance 14 6.5 Observation period 14 6.6 General test conditions 15 Annex A (normative) Application of limits

25、and type test conditions for specific equipment . 19 Annex B (normative) Test conditions and procedures for measuring d maxvoltage changes caused by manual switching . 27 Annex C (informative) Determination of steady state voltage and voltage change characteristics, as defined in IEC 61000-4-15:2010

26、 28 Annex D (informative) Input relative voltage fluctuation V/V for P st= 1,0 at output IEC/TR 61000-3-7:2008 33 Bibliography 34 Figure 1 Reference network for single-phase and three-phase supplies derived from a three-phase, four-wire supply . 16 Figure 2 Curve for P st= 1 for rectangular equidist

27、ant voltage changes 17 Figure 3 Shape factors F for double-step and ramp-voltage characteristics 17 Figure 4 Shape factors F for rectangular and triangular voltage characteristics 18 Figure 5 Shape factor F for motor-start voltage characteristics having various front times. 18 Figure C.1 Evaluation

28、of U hp (t) 32 Table 1 Assessment method 11 Table A.1 Test conditions for hotplates 19 Table A.2 Electrode parameters . 24 Table A.3 Frequency factor R related to repetition rate “r“ 25 61000-3-3 IEC:2013 3 Table C.1 Test specification for d c d max t d(t) 3,3 % (from Table 12 of IEC 61000-4-15: 201

29、0) 31 Table C.2 Test specification for d c d max t d(t) 3,3 %(from Table 13 of IEC 61000-4-15: 2010) 31 Table D.1 Input relative voltage fluctuation V/V for P st= 1,0 at output . 33 4 61000-3-3 IEC:2013 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ELECTROMAGNETIC COMPATIBILITY (EMC) Part 3-3: Limits

30、Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current 16 A per phase and not subject to conditional connection FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardizat

31、ion comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes Internatio

32、nal Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in t

33、his preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the t

34、wo organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have t

35、he form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinte

36、rpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national

37、 or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carr

38、ied out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Com

39、mittees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn

40、to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be

41、 held responsible for identifying any or all such patent rights. International Standard IEC 61000-3-3 has been prepared by subcommittee 77A: EMC Low frequency phenomena, of IEC technical committee 77: Electromagnetic compatibility. This standard forms part 3-3 of IEC 61000 series of standards. It ha

42、s the status of a product family standard. This third edition cancels and replaces the second edition published in 2008. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) This edition takes accoun

43、t of the changes made in IEC 61000-4-15:2010. 61000-3-3 IEC:2013 5 The text of this standard is based on the following documents: FDIS Report on voting 77A/809/FDIS 77A/816/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the abov

44、e table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of all parts in the IEC 61000 series, published under the general title Electromagnetic compatibility (EMC), can be found on the IEC website. The committee has decided that the contents of this publi

45、cation will remain unchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. 6 61000-3-3 IEC:2013 INTRODUCTIO

46、N IEC 61000 is published in separate parts according to the following structure: Part 1: General General considerations (introduction, fundamental principles) Definitions, terminology Part 2: Environment Description of the environment Classification of the environment Compatibility levels Part 3: Li

47、mits Emission limits Immunity limits (in so far as they do not fall under the responsibility of product committees) Part 4: Testing and measurement techniques Measurement techniques Testing techniques Part 5: Installation and mitigation guidelines Installation guidelines Mitigation methods and devic

48、es Part 9: Miscellaneous Each part is further subdivided into sections which are to be published either as International Standards or as Technical Reports. These standards and reports will be published in chronological order and numbered accordingly. 61000-3-3 IEC:2013 7 ELECTROMAGNETIC COMPATIBILIT

49、Y (EMC) Part 3-3: Limits Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current 16 A per phase and not subject to conditional connection 1 Scope This part of IEC 61000 is concerned with the limitation of voltage fluctuations and flicker impressed on the public low-voltage sy