IEC 61557-10-2013 Electrical safety in low voltage distribution systems up to 1000 V a.c and 1500 V d.c equipment for testing measuring or monitoring of protective measures - Part .pdf

1、 IEC 61557-10 Edition 2.0 2013-04 INTERNATIONAL STANDARD NORME INTERNATIONALE Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 10: Combined measuring equipment for testing, measuring o

2、r monitoring of protective measures Scurit lectrique dans les rseaux de distribution basse tension de 1 000 V c.a. et 1 500 V c.c. Dispositifs de contrle, de mesure ou de surveillance de mesures de protection Partie 10: Appareils combins de contrle, de mesure ou de surveillance de mesures de protect

3、ion IEC 61557-10:2013 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2013 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm

4、, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member Nationa

5、l Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit

6、 de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Cen

7、tral Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, e

8、lectronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publications search - www.iec.ch

9、/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC p

10、ublications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, wi

11、th equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: cscie

12、c.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des p

13、ublications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en utilisant

14、diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelles publ

15、ications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dan

16、s les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 61557-10 Edition 2.0 2013-04 I

17、NTERNATIONAL STANDARD NORME INTERNATIONALE Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 10: Combined measuring equipment for testing, measuring or monitoring of protective measures

18、 Scurit lectrique dans les rseaux de distribution basse tension de 1 000 V c.a. et 1 500 V c.c. Dispositifs de contrle, de mesure ou de surveillance de mesures de protection Partie 10: Appareils combins de contrle, de mesure ou de surveillance de mesures de protection INTERNATIONAL ELECTROTECHNICAL

19、COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE J ICS 17.220.20; 29.080.01; 29.240.01 PRICE CODE CODE PRIX ISBN 978-2-83220-757-4 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obta

20、ined this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. 2 61557-10 IEC:2013 CONTENTS FOREWORD . 3 1 Scope . 5 2 Normative references . 5 3 Terms and definitions . 6 4 Requirements . 6 4.1 General . 6 4.2 M

21、arking and pictogram 7 5 Marking and operating instructions . 7 6 Tests 8 Bibliography 9 Table 1 Extraneous overvoltage withstand capability . 6 61557-10 IEC:2013 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ELECTRICAL SAFETY IN LOW VOLTAGE DISTRIBUTION SYSTEMS UP TO 1 000 V a.c. AND 1 500 V d.c. E

22、QUIPMENT FOR TESTING, MEASURING OR MONITORING OF PROTECTIVE MEASURES Part 10: Combined measuring equipment for testing, measuring or monitoring of protective measures FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all nation

23、al electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical

24、Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. Int

25、ernational, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The

26、formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendation

27、s for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end use

28、r. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication

29、shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent ce

30、rtification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal

31、injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative referenc

32、es cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for ide

33、ntifying any or all such patent rights. International Standard IEC 61557-10 has been prepared by IEC technical committee 85: Measuring equipment for electrical and electromagnetic quantities. This second edition cancels and replaces the first edition published in 2000. This edition constitutes a tec

34、hnical revision. 4 61557-10 IEC:2013 The text of this standard is based on the following documents: FDIS Report on voting 85/442/FDIS 85/451/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has be

35、en drafted in accordance with the ISO/IEC Directives, Part 2. This part of IEC 61557 is to be used in conjunction with Part 1. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in

36、 the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. 61557-10 IEC:2013 5 ELECTRICAL SAFETY IN LOW VOLTAGE DISTRIBUTION SYSTEMS UP TO 1 000 V a.c. AND 1 500 V d.c. EQUIPMENT FOR TESTING, MEASURING OR MO

37、NITORING OF PROTECTIVE MEASURES Part 10: Combined measuring equipment for testing, measuring or monitoring of protective measures 1 Scope This part of IEC 61557 specifies the requirements for combined measuring equipment which combines into one piece of apparatus, several measuring functions or meth

38、ods of testing, measuring or monitoring according to the respective parts of IEC 61557. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. Fo

39、r undated references, the latest edition of the referenced document (including any amendments) applies. IEC 61557-1, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 1: General require

40、ments IEC 61557-2, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 2: Insulation resistance IEC 61557-3, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1

41、 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 3: Loop impedance IEC 61557-4, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 4: Resistance of

42、earth connection and equipotential bonding IEC 61557-5, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 5: Resistance to earth IEC 61557-6, Electrical safety in low voltage distributi

43、on systems up to 1 000 V a.c. and 1 500 V d.c. Equipment for testing, measuring or monitoring of protective measures Part 6: Effectiveness of residual current devices (RCD) in TT, TN and IT systems IEC 61557-7, Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c.

44、 Equipment for testing, measuring or monitoring of protective measures Part 7: Phase sequence IEC 61010-2-030:2010, Safety requirements for electrical equipment for measurement, control, and laboratory use Part 2-030: Particular requirements for testing and measuring circuits 6 61557-10 IEC:2013 3 T

45、erms and definitions For the purposes of this document, the terms and definitions given in IEC 61557-1, IEC 61557-2, IEC 61557-3, IEC 61557-4, IEC 61557-5, IEC 61557-6 and IEC 61557-7 as well as the following terms and definitions apply. 3.1 combined measuring equipment equipment that combines, into

46、 one piece of apparatus, several measuring functions or methods of testing, measuring or monitoring, some or all of which are in accordance with other parts of IEC 61557 3.2 extraneous overvoltage voltage applied to the terminals of the combined measuring equipment to test the overvoltage withstand

47、capability 4 Requirements 4.1 General 4.1.1 The following requirements in addition to those given in all relevant parts of IEC 61557 shall apply. 4.1.2 No hazard shall arise for the user when the highest extraneous overvoltage according to the respective parts of this document (see Table 1) is accid

48、entally applied to each combination of tests and measurement terminals with every combination of function and range settings, even though some of these functions are not themselves covered by IEC 61557 Parts 2 to Parts 7. 4.1.3 Terminals that are clearly identifiable as not test or measurement termi

49、nals and that will not retain the terminals of specified probes or accessories need not be tested. The duration time shall be the longest possible indicated in the respective parts of IEC 61557. Table 1 Extraneous overvoltage withstand capability Part of IEC 61557 2 Insulation 3 Loop 4 Protective bonding 5 Earth resistance 6 RCD 7 Phase sequence Extraneous overvoltage and duration time 1,2 U N10 s