IEC 60454-3-12-2006 Pressure-sensitive adhesive tapes for electrical purposes - Part 3 Specifications for individual materials - Sheet 12 Polyethylene film tape.pdf

1、 IEC 60454-3-12 Edition 2.0 2006-01 INTERNATIONAL STANDARD NORME INTERNATIONALE Pressure-sensitive adhesive tapes for electrical purposes Part 3: Specifications for individual materials Sheet 12: Requirements for polyethylene and polypropylene film tapes with pressure sensitive adhesive Rubans adhsi

2、fs sensibles la pression pour usages lectriques Partie 3: Spcifications pour matriaux particuliers Feuille 12: Exigences relatives aux rubans en polythylne et en polypropylne avec un adhsif sensible la pression IEC 60454-3-12:2006-01(en-fr) THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2006 IEC,

3、 Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee

4、 in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indicati

5、on contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des ques

6、tions sur le copyright de lIEC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva

7、20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC p

8、ublications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC Internat

9、ional Standards, Technical Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical commit

10、tee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www

11、.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in 14 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary

12、- std.iec.ch/glossary More than 55 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Cen

13、tre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Nor

14、mes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t

15、 publi. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche d

16、e publications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.

17、ch/justpublished Restez inform sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contien

18、t plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans 14 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 55 000 entres terminologiques lectrotechniques, en an

19、glais et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette public

20、ation ou si vous avez des questions contactez-nous: csciec.ch. IEC 60454-3-12 Edition 2.0 2006-01 INTERNATIONAL STANDARD NORME INTERNATIONALE Pressure-sensitive adhesive tapes for electrical purposes Part 3: Specifications for individual materials Sheet 12: Requirements for polyethylene and polyprop

21、ylene film tapes with pressure sensitive adhesive Rubans adhsifs sensibles la pression pour usages lectriques Partie 3: Spcifications pour matriaux particuliers Feuille 12: Exigences relatives aux rubans en polythylne et en polypropylne avec un adhsif sensible la pression INTERNATIONAL ELECTROTECHNI

22、CAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE J ICS 29.035.20 PRICE CODE CODE PRIX ISBN 978-2-8322-1593-7 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publicat

23、ion from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. 2 IEC 60454-3-12:2006 IEC 2006 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ PRESSURE-SENSITIVE ADHESIVE TAPES FOR ELECTRICAL PURPOSES Part 3: Specifications for individ

24、ual materials Sheet 12: Requirements for polyethylene and polypropylene film tapes with pressure sensitive adhesive FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Commit

25、tees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Availab

26、le Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental orga

27、nizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical

28、matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC Nat

29、ional Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity,

30、 IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC pr

31、ovides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, empl

32、oyees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of th

33、e publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the

34、possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 60454-3-12 has been prepared by IEC technical committee 15: Insulating materials. This biling

35、ual version (2014-05) corresponds to the English version, published in 2006-01. This second edition of IEC 60454-3-12 replaces the first edition, published in 1998, as well as IEC 60454-3-18, published in 2003. It constitutes a technical revision. This edition replaces the previous second edition an

36、d includes its consolidation with the texts of IEC 60464-3-18 (2003). IEC 60454-3-12:2006 IEC 2006 3 The text of this standard is based on the following documents: FDIS Report on voting 15/261/FDIS 15/288/RVD Full information on the voting for the approval of this standard can be found in the report

37、 on voting indicated in the above table. The French version of this standard has not been voted upon. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. The committee has decided that the contents of this publication will remain unchanged until the maintenance resul

38、t date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed; withdrawn; replaced by a revised edition, or amended. 4 IEC 60454-3-12:2006 IEC 2006 INTRODUCTION This International Standard is one

39、of a series, which deals with pressure-sensitive adhesive tapes, intended primarily for electrical purposes. The series consists of three parts: Part 1: General requirements (IEC 60454-1) Part 2: Methods of test (IEC 60454-2) Part 3: Specifications for individual materials (IEC 60454-3) This standar

40、d contains one of the sheets comprising part 3 as follows: Sheet 12: Polyethylene and polypropylene film tapes pressure sensitive adhesives. SAFETY WARNING It is the responsibility of the user of the methods contained or referred to in this standard to ensure that they are used in a safe manner. IEC

41、 60454-3-12:2006 IEC 2006 5 PRESSURE-SENSITIVE ADHESIVE TAPES FOR ELECTRICAL PURPOSES Part 3: Specifications for individual materials Sheet 12: Requirements for polyethylene and polypropylene film tapes with pressure sensitive adhesive 1 Scope This sheet of IEC 60454-3 contains requirements for poly

42、ethylene and polypropylene film tapes with pressure sensitive adhesives Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate pe

43、rformance in that application, and not based on this specification alone. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenc

44、ed document (including any amendments) applies. IEC 60426:1973, Test methods for determining electrolytic corrosion with insulating materials IEC 60454-1:1992, Specifications for pressure-sensitive adhesive tapes for electrical purposes Part 1: General requirements IEC 60454-2:1994, Specifications f

45、or pressure-sensitive adhesive tapes for electrical purposes Part 2: Methods of test 3 Terms and definitions For the purposes of this document, the definitions of IEC 60454-1 apply. 4 Classification and designation 4.1 Polyethylene film tapes with pressure sensitive adhesive 4.1.1 The products suppl

46、ied according to this specification shall be classified as follows: Type 1: Products having a thermal index of 90 and a minimum temperature rating of 10 C. Type 2: Products having a thermal index of 90 and a minimum temperature rating of 18 C. Type 3: Products having a thermal index of 90 and a mini

47、mum temperature rating of 33 C. Type 4: Products having a thermal index of 75 and a minimum temperature rating of 10 C. Type 5: Products having a thermal index of 75 and a minimum temperature rating of 18 C. Type 6: Products having a thermal index of 75 and a minimum temperature rating of 33 C. 6 IE

48、C 60454-3-12:2006 IEC 2006 4.1.2 The products shall be designated for ordering purposes as follows: Type 1: IEC 60454-3-12-1/F-PE/90 Type 2: IEC 60454-3-12-2/F-PE/90 Type 3: IEC 60454-3-12-3/F-PE/90 Type 4: IEC 60454-3-12-4/F-PE/75 Type 5: IEC 60454-3-12-5/F-PE/75 Type 6: IEC 60454-3-12-6/F-PE/75 NO

49、TE The nature of the adhesive is not classified, since several classes of adhesive may satisfy the performance requirements of this specification. Adhesive types may be based on agreement between purchaser and supplier. 4.2 Polypropylene film tapes with pressure sensitive adhesive 4.2.1 The products supplied according to this specification shall be classified as follows: Type 1: Products having