IEC 61000-4-16-2015 Electromagnetic compatibility (EMC) - Part 4-16 Testing and measurement techniques - Test for immunity to conducted common mode disturbances.pdf

1、 IEC 61000-4-16 Edition 2.0 2015-12 INTERNATIONAL STANDARD NORME INTERNATIONALE Electromagnetic compatibility (EMC) Part 4-16: Testing and measurement techniques Test for immunity to conducted, common mode disturbances in the frequency range 0 Hz to 150 kHz Compatibilit lectromagntique (CEM) Partie

2、4-16: Techniques dessai et de mesure Essai dimmunit aux perturbations conduites en mode commun dans la plage de frquences de 0 Hz 150 kHz IEC 61000-4-16:2015-12(en-fr) BASIC EMC PUBLICATION PUBLICATION FONDAMENTALE EN CEM colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2015 IEC, Gene

3、va, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in t

4、he country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication co

5、ntraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions

6、 sur le copyright de lIEC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 in

7、foiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC public

8、ations is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International

9、 Standards, Technical Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,)

10、. It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.elec

11、tropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in 15 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std

12、.iec.ch/glossary More than 60 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre -

13、 webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes i

14、nternationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publ

15、i. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de pub

16、lications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/ju

17、stpublished Restez inform sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient plu

18、s de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans 15 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 60 000 entres terminologiques lectrotechniques, en anglais

19、 et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication

20、 ou si vous avez des questions contactez-nous: csciec.ch. IEC 61000-4-16 Edition 2.0 2015-12 INTERNATIONAL STANDARD NORME INTERNATIONALE Electromagnetic compatibility (EMC) Part 4-16: Testing and measurement techniques Test for immunity to conducted, common mode disturbances in the frequency range 0

21、 Hz to 150 kHz Compatibilit lectromagntique (CEM) Partie 4-16: Techniques dessai et de mesure Essai dimmunit aux perturbations conduites en mode commun dans la plage de frquences de 0 Hz 150 kHz INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE ICS 33.100.20 ISBN 9

22、78-2-8322-3036-7 BASIC EMC PUBLICATION PUBLICATION FONDAMENTALE EN CEM Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention!

23、Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside 2 IEC 61000-4-16:2015 IEC 2015 CONTENTS FOREWORD . 4 INTRODUCTION . 6 1 Scope 7 2 Normative references . 8 3 Terms and definitions. 8 4 General . 9 5 Test levels . 9 5.1 General . 9 5.2 Test levels at

24、 mains frequency 10 5.3 Test levels in the frequency range 15 Hz-150 kHz 10 6 Test equipment 11 6.1 Test generators . 11 6.1.1 General . 11 6.1.2 Characteristics and performance of the generator for d.c. tests 11 6.1.3 Characteristics and performance of the generator for tests at mains frequency: 16

25、 2/3Hz, 50 Hz and 60 Hz 12 6.1.4 Characteristics and performance of the generator for tests in the frequency range 15 Hz to 150 kHz 12 6.2 Verification of the characteristics of the test generators . 13 6.3 Coupling/decoupling networks . 13 6.3.1 General . 13 6.3.2 Coupling networks . 13 6.3.3 Decou

26、pling devices 14 7 Test set-up 14 7.1 General . 14 7.2 Earthing connections . 15 7.3 Equipment under test 15 7.4 Test generators . 15 7.5 Decoupling/isolation devices 15 8 Test procedure 15 8.1 General . 15 8.2 Laboratory reference conditions. 16 8.2.1 General . 16 8.2.2 Climatic conditions . 16 8.2

27、.3 Electromagnetic conditions 16 8.3 Execution of the test 16 9 Evaluation of test results 17 10 Test report . 18 Annex A (informative) Sources of disturbances and coupling mechanisms 23 A.1 Sources of disturbances 23 A.2 Coupling mechanisms . 23 Annex B (informative) Selection of test levels . 25 B

28、ibliography 26 Figure 1 Example of equipment ports and configuration 19 IEC 61000-4-16:2015 IEC 2015 3 Figure 2 Profile of the test voltage 19 Figure 3 Example of the generator for d.c. and frequency voltage tests 15 Hz up to 150 kHz 20 Figure 4 Example of the generator for tests at mains frequency

29、(16 Hz, 50 Hz and 60 Hz) . 20 Figure 5 Schematic circuit of the coupling T network for communication ports and other ports intended for connection to highly balanced pairs 21 Figure 6 Schematic circuit for type tests . 22 Table 1 Levels for continuous disturbance 10 Table 2 Levels for short duration

30、 disturbance 10 Table 3 Test levels in the frequency range 15 Hz to 150 kHz. 11 4 IEC 61000-4-16:2015 IEC 2015 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ELECTROMAGNETIC COMPATIBILITY (EMC) Part 4-16: Testing and measurement techniques Test for immunity to conducted, common mode disturbances in the

31、 frequency range 0 Hz to 150 kHz FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions

32、concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”).

33、 Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collabora

34、tes closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on th

35、e relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure tha

36、t the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the m

37、aximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodi

38、es provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to

39、IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and

40、expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9)

41、Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 61000-4-16 has been prepared by subcommittee 77A: Low- frequency ph

42、enomena, of IEC technical committee 77: Electromagnetic compatibility. It forms part 4-16 of IEC 61000. It has the status of a basic EMC publication in accordance with IEC Guide 107. This second edition cancels and replaces the first edition published in 1998, Amendment 1:2001 and Amendment 2:2009.

43、This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) clarification and complement of test generators specifications and performances. IEC 61000-4-16:2015 IEC 2015 5 The text of this standard is based

44、 on the following documents: FDIS Report on voting 77A/905/FDIS 77A/917/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list

45、of all parts in the IEC 61000 series, published under the general title Electromagnetic compatibility (EMC), can be found on the IEC website. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC website under “http:/webst

46、ore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The “colour inside” logo on the cover page of this publication indicates that it contains colours which are considered to be

47、 useful for the correct understanding of its contents. Users should therefore print this publication using a colour printer. 6 IEC 61000-4-16:2015 IEC 2015 INTRODUCTION This standard is part of the IEC 61000 series, according to the following structure: Part 1: General General considerations (introd

48、uction, fundamental principles) Definitions, terminology Part 2: Environment Description of the environment Classification of the environment Compatibility levels Part 3: Limits Emission limits Immunity limits (in so far as they do not fall under the responsibility of the product committees) Part 4:

49、 Testing and measurement techniques Measurement techniques Testing techniques Part 5: Installation and mitigation guidelines Installation guidelines Mitigation methods and devices Part 6: Generic standards Part 9: Miscellaneous Each part is further subdivided into several parts, published either as international standards or as technical specifications or technical reports, some of which have alre