IEC 61169-24-2009 Radio-frequency connectors - Part 24 Sectional specification - Radio frequency coaxial connectors with screw coupling typically for use in 75 .pdf

1、 IEC 61169-24 Edition 2.0 2009-02 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 24: Sectional specification Radio frequency coaxial connectors with screw coupling, typically for use in 75 cable networks (type F) Connecteurs pour frquences radiolectriques Partie 24: Spci

2、fication intermdiaire Connecteurs coaxiaux pour frquences radiolectriques avec couplage viss, typiquement utiliss dans des rseaux de distribution par cbles de 75 (type F) IEC 61169-24:2009-02(EN-FR) colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2009 IEC, Geneva, Switzerland All rig

3、hts reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the reque

4、ster. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie

5、de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions sur le copyright de lI

6、EC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland ww

7、w.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under co

8、nstant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technical S

9、pecifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives informa

10、tion on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The worlds

11、 leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in 14 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary More t

12、han 55 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If

13、 you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes internationales pour tou

14、t ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue IEC - webs

15、tore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de publications IEC - www.iec

16、.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/justpublished Restez info

17、rm sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient plus de 30 000 termes et d

18、finitions en anglais et en franais, ainsi que les termes quivalents dans 14 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 55 000 entres terminologiques lectrotechniques, en anglais et en franais, extrait

19、es des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des qu

20、estions contactez-nous: csciec.ch. IEC 61169-24 Edition 2.0 2009-02 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 24: Sectional specification Radio frequency coaxial connectors with screw coupling, typically for use in 75 cable networks (type F) Connecteurs pour frquenc

21、es radiolectriques Partie 24: Spcification intermdiaire Connecteurs coaxiaux pour frquences radiolectriques avec couplage viss, typiquement utiliss dans des rseaux de distribution par cbles de 75 (type F) INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE S ICS 31.2

22、20.10 PRICE CODE CODE PRIX ISBN 978-2-8322-1352-0 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer

23、 que vous avez obtenu cette publication via un distributeur agr. colour inside 2 61169-24 IEC:2009 CONTENTS FOREWORD . 4 1 Scope . 6 2 Normative references . 6 3 Interface dimensions 6 3.1 Dimensions . 6 3.1.1 Connector “F” type female socket (indoor) physical dimensions . 7 3.1.2 Connector “F” type

24、 male plug (indoor) physical dimensions . 8 3.2 Mechanical gauges 9 3.2.1 Mating socket centre conductor acceptance diameter test . 9 3.2.2 Mating port centre conductor acceptance electrical test . 10 3.2.3 Reference plane electrical contact . 10 4 Quality assessment procedures 10 4.1 General . 10 4

25、.2 Ratings and characteristics . 10 4.3 Environmental characteristics for outdoor sockets (see Annex A) 12 4.4 Test schedule and inspection requirements . 12 4.4.1 Acceptance tests . 12 4.4.2 Periodic tests 13 4.5 Procedures 14 4.5.1 Quality conformance inspection . 14 4.5.2 Qualification approval a

26、nd its maintenance 14 5 Instructions for preparation of detail specifications . 14 5.1 General . 14 5.2 Identification of the detail specification 15 5.3 Identification of the component 15 5.4 Performance 15 5.5 Marking, ordering information and related matters . 15 5.6 Selection of tests, test cond

27、itions and severities 15 5.7 Blank detail specification pro-forma for type F connector . 16 Annex A (informative) Recommended outdoor “F” type socket / Plug physical dimensions . 21 Figure 1 Connector “F” type female socket (indoor) (for dimensions, see Table 1) . 7 Figure 2 Connector “F” type male

28、plug (indoor) (for dimensions, see Table 2) 8 Figure 3 Gauge for the centre socket conductor . 9 Figure A.1 Outdoor female “F” socket (for dimensions, see Table A.1) 21 Figure A.2 Outdoor “F” type male plug (for dimensions, see Table A.2) 22 61169-24 IEC:2009 3 Table 1 Connector “F” type female sock

29、et (indoor) . 7 Table 2 Connector “F” type male plug (indoor) . 8 Table 3 Test sequence for the centre socket conductor 9 Table 4 Ratings and characteristics . 10 Table 5 Acceptance tests . 12 Table 6 Periodic tests 13 Table A.1 Outdoor female “F” socket dimensions . 21 Table A.2 Outdoor “F” type ma

30、le plug dimensions 22 4 61169-24 IEC:2009 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ RADIO-FREQUENCY CONNECTORS Part 24: Sectional specification Radio frequency coaxial connectors with screw coupling, typically for use in 75 cable networks (type F) FOREWORD 1) The International Electrotechnical Com

31、mission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and

32、 in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee

33、 interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accord

34、ance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all inte

35、rested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held respons

36、ible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence

37、between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All

38、 users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or

39、 other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publicati

40、on. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such p

41、atent rights. International Standard IEC 61169-24 has been prepared by subcommittee 46F: RF and microwave passive components, of IEC technical committee 46: Cables, wires, waveguides, R.F. connectors, R.F. and microwave passive components and accessories. This bilingual version (2014-01) corresponds

42、 to the monolingual English version, published in 2009-02. This second edition cancels and replaces the first edition published in 2001. It constitutes a technical revision. This second edition differs from the first edition in that all drawings have been reworked and improved to allow frequency ext

43、ension up to 3 GHz. 61169-24 IEC:2009 5 The text of this standard is based on the following documents: FDIS Report on voting 46F/108/FDIS 46F/128/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. The French version

44、 of this standard has not been voted upon. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of all parts of the IEC 61169 series, under the general title: Radio-frequency connectors, can be found on the IEC website. The committee has decided that the conten

45、ts of this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTA

46、NT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer. 6 61169-24 IEC:2009 RADIO-FREQUENCY CONNECTORS Part 2

47、4: Sectional specification Radio frequency coaxial connectors with screw coupling, typically for use in 75 cable networks (type F) 1 Scope This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for RF coaxial

48、connectors with screw coupling, typically for use in 75 cable networks (type F). It describes the interface dimensions with gauging information and the mandatory tests selected from IEC 61169-1, applicable to all DS relating to type F connectors. This specification indicates the recommended performa

49、nce characteristics to be considered when writing a DS and covers test schedules and inspection requirements. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments