IEC 80601-2-59-2017 Medical electrical equipment - Part 2-59 Particular requirements for the basic safety and essential performance of screening thermographs fo.pdf

1、 IEC 80601-2-59 Edition 2.0 2017-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Medical electrical equipment Part 2-59: Particular requirements for the basic safety and essential performance of screening thermographs for human febrile temperature screening Appareils lectromdicaux Partie 2-59: Exigen

2、ces particulires pour la scurit de base et les performances essentielles des imageurs thermiques pour le dpistage des humains fbriles IEC 80601-2-59:2017-09(en-fr) colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2017 IEC, Geneva, Switzerland All rights reserved. Unless otherwise spec

3、ified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions abo

4、ut IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre re

5、produite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions sur le copyright de lIEC ou si vous dsirez obtenir des dr

6、oits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The Internat

7、ional Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please ma

8、ke sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technical Specifications, Technical Reports an

9、d other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and with

10、drawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of elect

11、ronic and electrical terms containing 20 000 terms and definitions in English and French, with equivalent terms in 16 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary 65 000 electrotechnical terminology entries in Engl

12、ish and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication

13、or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux techno

14、logies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consult

15、er tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de publications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des

16、 publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications IEC. Just Published d

17、taille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient 20 000 termes et dfinitions en anglais et en franais, ainsi que les termes quival

18、ents dans 16 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary 65 000 entres terminologiques lectrotechniques, en anglais et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis

19、 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 80601-2-59 Edition 2.0 2017-09 I

20、NTERNATIONAL STANDARD NORME INTERNATIONALE Medical electrical equipment Part 2-59: Particular requirements for the basic safety and essential performance of screening thermographs for human febrile temperature screening Appareils lectromdicaux Partie 2-59: Exigences particulires pour la scurit de ba

21、se et les performances essentielles des imageurs thermiques pour le dpistage des humains fbriles INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE ICS 11.040.55 ISBN 978-2-8322-4815-7 Warning! Make sure that you obtained this publication from an authorized distribu

22、tor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside 2 IEC 80601-2-59:2017 IEC 2017 CONTENTS FOREWORD . 4 INTRODUCTION . 7 201.1 Scope, object and related standards . 8 201.2 Normative references 9 201.3 Terms and definitions 10 201.4 Ge

23、neral requirements . 12 201.5 General requirements for testing ME EQUIPMENT 13 201.6 Classification of ME EQUIPMENT and ME SYSTEMS 13 201.7 ME EQUIPMENT identification, marking and documents . 13 201.8 Protection against electrical HAZARDS from ME EQUIPMENT . 14 201.9 Protection against mechanical H

24、AZARDS of ME EQUIPMENT and ME SYSTEMS 14 201.10 Protection against unwanted and excessive radiation HAZARDS . 15 201.11 Protection against excessive temperatures and other HAZARDS . 15 201.12 Accuracy of controls and instruments and protection against hazardous outputs . 15 201.13 HAZARDOUS SITUATIO

25、NS and fault conditions for ME EQUIPMENT . 16 201.14 PROGRAMMABLE ELECTRICAL MEDICAL SYSTEMS (PEMS) . 16 201.15 Construction of ME EQUIPMENT . 16 201.16 ME SYSTEMS 16 201.17 Electromagnetic compatibility of ME EQUIPMENT and ME SYSTEMS . 16 201.101 LABORATORY ACCURACY of a SCREENING THERMOGRAPH . 17

26、201.102 SCREENING THERMOGRAPH ALARM CONDITIONS . 20 202 Electromagnetic disturbances Requirements and tests . 21 206 USABILITY 21 Annexes . 23 Annex C (informative) Guide to marking and labelling requirements for ME EQUIPMENT and ME SYSTEMS 23 Annex AA (informative) Particular guidance and rationale

27、 25 Annex BB (normative) CALIBRATION SOURCE . 32 Annex CC (informative) Reference to the essential principles 33 Bibliography 36 Index of defined terms used in this document . 40 Figure AA.1 Illustration of TARGET in the visible spectrum . 27 Figure AA.2 Illustration of TARGET in the infrared spectr

28、um 27 Figure AA.3 Relative drift of 4 DETECTORS as a function of time 30 Table 201.101 Distributed ESSENTIAL PERFORMANCE requirements 13 Table 201.C.101 Marking on the outside of a SCREENING THERMOGRAPH or its parts 23 Table 201.C.102 ACCOMPANYING DOCUMENTS, general of a SCREENING THERMOGRAPH 23 Tab

29、le 201.C.103 ACCOMPANYING DOCUMENTS, instructions for use of a SCREENING THERMOGRAPH . 24 IEC 80601-2-59:2017 IEC 2017 3 Table 201.C.104 ACCOMPANYING DOCUMENTS, technical description of a SCREENING THERMOGRAPH . 24 Table AA.1 Example of relevant uncertainty terms for a SCREENING THERMOGRAPH . 28 Tab

30、le CC.1 Correspondence between this document and the essential principles . 33 4 IEC 80601-2-59:2017 IEC 2017 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ MEDICAL ELECTRICAL EQUIPMENT Part 2-59: Particular requirements for the basic safety and essential performance of screening thermographs for human

31、 febrile temperature screening FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions co

32、ncerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). T

33、heir preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborate

34、s closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the

35、relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that

36、the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the max

37、imum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies

38、 provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IE

39、C or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and ex

40、penses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) At

41、tention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International standard IEC 80601-2-59 has been prepared by a Joint Working Group of IEC subcommi

42、ttee 62D: Electromedical equipment, of IEC technical committee 62: Electrical equipment in medical practice, and of ISO subcommittee SC3: Lung ventilators and related equipment, of ISO technical committee 121: Anaesthetic and respiratory equipment. This second edition cancels and replaces the first

43、edition published in 2008. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) updates of the normative references and the bibliography; b) expansion of the applicability to pandemic infectious dise

44、ases in general. IEC 80601-2-59:2017 IEC 2017 5 The text of this document is based on the following documents: FDIS Report on voting 62D/1501/FDIS 62D/1515/RVD Full information on the voting for the approval of this document can be found in the report on voting indicated in the above table. This pub

45、lication has been drafted in accordance with the ISO/IEC Directives, Part 2. In this document, the following print types are used: requirements and definitions: roman type; test specifications: italic type; informative material appearing outside of tables, such as notes, examples and references: in

46、smaller type. Normative text of tables is also in a smaller type; TERMS DEFINED IN CLAUSE 3 OF THE GENERAL STANDARD, IN THIS PARTICULAR DOCUMENT OR AS NOTED: SMALL CAPITALS. In referring to the structure of this document, the term: “clause” means one of the seventeen numbered divisions within the ta

47、ble of contents, inclusive of all subdivisions (e.g. Clause 7 includes subclauses 7.1, 7.2, etc.); “subclause” means a numbered subdivision of a clause (e.g. 7.1, 7.2 and 7.2.1 are all subclauses of Clause 7). References to clauses within this document are preceded by the term “Clause” followed by t

48、he clause number. References to subclauses within this particular document are by number only. In this document, the conjunctive “or” is used as an “inclusive or” so a statement is true if any combination of the conditions is true. The verbal forms used in this document conform to usage described in

49、 Clause 7 of the ISO/IEC Directives, Part 2. For the purposes of this document, the auxiliary verb: “shall” means that compliance with a requirement or a test is mandatory for compliance with this document ; “should” means that compliance with a requirement or a test is recommended but is not mandatory for compliance with this document ; “may” is used to describe a permissible way to achieve compliance with a requir