ASTM F1816-2018 Standard Safety Specification for Drawstrings on Children&apos s Upper Outerwear.pdf

1、Designation: F1816 18Standard Safety Specification forDrawstrings on Childrens Upper Outerwear1This standard is issued under the fixed designation F1816; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A

2、number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.INTRODUCTIONKnots, toggles, and other decorative or functional attachments on the ends of long, loosedrawstrings can catch and snag on other object

3、s. Two hazards associated with such drawstrings onchildrens upper outerwear have been identified: the potential strangulation hazard associatedprimarily with hood and neck area drawstrings of upper outerwear; the potential vehicular dragginghazard associated primarily with waist and bottom drawstrin

4、gs of upper outerwear. This consumersafety specification is intended to reduce the risk of drawstrings on childrens upper outwear accessingand getting snagged in various entrapment areas.1. Scope1.1 This specification covers and is intended to reducestrangulation and vehicular dragging hazards assoc

5、iated withdrawstrings on childrens upper outerwear.1.2 The type of clothing covered by this specification isgirls and boys clothing, such as jackets and sweatshirts,generally intended to be worn on the exterior of other clothing.1.3 The sizes covered by this specification are sizes 2T to 12for neck/

6、hood drawstrings and sizes 2T to 16 for waist/bottomdrawstrings.1.4 Upper outerwear with fully retractable drawstrings areexempt.1.5 The values stated in inch-pound units are to be regardedas standard. The values given in parentheses are mathematicalconversions to SI units that are provided for info

7、rmation onlyand are not considered standard.1.6 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recom-mendations issued by the W

8、orld Trade Organization TechnicalBarriers to Trade (TBT) Committee.2. Referenced Documents2.1 ASTM Standards:2D5219 Terminology Relating to Body Dimensions for Ap-parel Sizing3. Terminology3.1 Definitions of Terms Specific to This Standard:3.1.1 bartack, nthe stitching through the drawstring andchan

9、nel usually at the back center of the channel to prevent thedrawstrings being pulled through its channel.3.1.2 bottom of upper outerwear, nthe edge that circum-scribes the lowest part of the garment (most distant from theneck area).3.1.3 drawstring, na non-retractable cord, ribbon, or tapeof any mat

10、erial to pull together parts of upper outerwear toprovide for closure.3.1.4 hood, na loose, pliable covering for the head, eitherdetachable or permanently attached to upper outerwear.3.1.5 neck area, nthe area 1 in. (25 mm) above or belowthe neck opening.3.1.6 neck opening, nthe opening is defined b

11、y the seambetween the body of the upper outerwear and the collar orhood.1This specification is under the jurisdiction of ASTM Committee F15 onConsumer Products and is the direct responsibility of Subcommittee F15.37 onDrawstrings for Childrens Clothing.Current edition approved Nov. 1, 2018. Publishe

12、d December 2018. Originallyapproved in 1997. Last previous edition approved in 2009 as F1816 97 (2009)which was withdrawn in July 2018 and reinstated in November 2018. DOI:10.1520/F1816-18.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at servic

13、eastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United StatesThis international standard was developed in accordance wit

14、h internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.13.1.7 toggle, nthe wooden, plastic, metal

15、 or otherwise-composed piece attached to the loose end of the drawstring fordecorative purposes or to prevent the drawstrings being drawnthrough its channel.3.1.8 upper outerwear, nclothing, such as jackets andsweatshirts, generally intended to be worn on the exterior ofother garments.3.1.9 waist, n

16、the narrowed part of the body between thechest and hips (see Terminology D5219).4. Performance Requirements4.1 There shall be no drawstrings in the hood and neck areaof childrens upper outerwear sizes 2T to 12.4.2 Drawstrings at the waist and bottom of childrens upperoutwear sizes 2T to 16 shall:4.2

17、.1 Not exceed 3 in. (75 mm) in length outside thedrawstring channel when the garment is expanded to its fullestwidth,4.2.2 Have no toggles, knots, or other attachments at thefree ends, and4.2.3 Be bartacked, if the drawstring is one continuousstring (see 3.1.6).5. Keywords5.1 childrens clothing; dra

18、wstringsAPPENDIX(Nonmandatory Information)X1. RATIONALEX1.1 Potential Strangulation HazardFrom January 1985to June 1995, the U.S. Consumer Product Safety Commissionreceived 42 reports, including 12 deaths, in which primarilyhood and neck drawstrings caught on playground equipment,cribs, a fence, an

19、escalator, or farm machinery, resulting inactual or near strangulation. Victims ranged in age from 14months to 8 years. The majority of the cases involved play-ground slides. Typically, as the child descended the slide, adrawstring dropped into a gap between slide components, forexample, between the

20、 slide and platform, between the slide andtunnel cover, between segments of a spiral slide, and so forth.The drawstring pulled through the gap to the point where thetoggle or knot on the end caused it to snag.As a result, the childwas suspended part way down the slide, with the garment anddrawstring

21、 taut at the neck, strangling the child.X1.2 Vehicular Dragging HazardFrom 1991 to 1996, theU.S. Consumer Product Safety Commission received report of12 incidents, including 4 deaths, in which waist and bottomdrawstrings snagged on school bus handrails or in schoolbusdoors. Typically, as the child d

22、escended the steps to get off thebus, the drawstring dropped into a gap in the handrail. Beforethe child or driver realized that the drawstring was snagged, thebus door had closed and the bus was driving away, draggingthe child. Fatalities usually involved the childs being run overby the bus. Victim

23、s ranged in age from 7 to 14 years.ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk

24、of infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this

25、 standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake y

26、our views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by c

27、ontacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ 182