IEEE 1904 1-2017 en Service Interoperability in Ethernet Passive Optical Networks (SIEPON).pdf

1、IEEE Standard for Service Interoperability in Ethernet Passive Optical Networks (SIEPON) Sponsored by the Standards Development Board IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Communications Society IEEE Std 1904.1-2017 (Revision of IEEE Std 1904.1-2013) IEEE Std 1904.1-2017 (Revision of I

2、EEE Std 1904.1-2013) IEEE Standard for Service Interoperability in Ethernet Passive Optical Networks (SIEPON) Sponsor Standards Development Board of the IEEE Communications Society Approved 14 February 2017 IEEE-SA Standards Board Abstract: The system-level requirements needed to ensure service-leve

3、l, multi-vendor interoperability of Ethernet Passive Optical Network (EPON) equipment is described. The existing IEEE 802.3 and IEEE 802.1 standards, which ensure the interoperability at the Physical Layer (PHY) and Data Link Layer, are complemented by the specifications. Specifically included in th

4、is specification are EPON system-level interoperability specifications covering equipment functionality, traffic engineering, and service-level quality of service/class of service (QoS/CoS) mechanisms; Management specifications covering equipment management, service management, and EPON powersaving

5、mechanism. Keywords: 1G-EPON, 10G-EPON, EPON, Ethernet Passive Optical Network, IEEE 1904.1, interoperability, QoS, quality of service, service interoperability, SIEPONGrateful acknowledgment is made to The Broadband Forum for the permission to use the following source material: BBF TR-200, Using EP

6、ON in the Context of TR-101, L. D. Lamb and C. Shen, Eds., Copyright 2011, The Broadband Forum, Section 1.2, Figure 1, page 10. The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2017 by The Institute of Electrical and Electronics Engine

7、ers, Inc. All rights reserved. Published 24 July 2017. Printed in the United States of America. DPoE and DOCSIS standards or products referred to in this standard are trademarks of the Cable Television Laboratories, Inc. IEEE and IEEE 802 are registered trademarks in the U.S. Patent fitness for a pa

8、rticular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standa

9、rd is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved an

10、d issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity n

11、or is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a comp

12、etent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFI

13、TS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGA

14、RDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official

15、statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position

16、of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for re

17、vision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed c

18、hange of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies

19、 and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisio

20、ns to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicabl

21、e laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publicat

22、ion of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are

23、adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public a

24、uthorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or ind

25、ividual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be o

26、btained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda

27、, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not

28、undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given docu

29、ment is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Xplore at http:/ieeexplore.ieee.org/ or contact IEEE at the address listed previously. For more information about the IEEE-SA or IEEEs standards development process,

30、visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is

31、called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or p

32、atent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses un

33、der patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The

34、IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance,

35、if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained fr

36、om the IEEE Standards Association. Participants At the time this standard was submitted to the IEEE-SA Standards Board for approval, the IEEE 1904 Access Networks Working Group had the following membership: Glen Kramer, Ph.D., Working Group Chair Ken-Ichi Suzuki, Ph.D., Working Group Vice Chair Zhou

37、 Zhen, Ph.D., Executive Secretary Marek Hajduczenia, Ph.D., Chief Editor The following individuals contributed to the development of this revision of the standard: Curtis Knittle, Ph.D. Edwin Mallette Glen Kramer, Ph.D. Lu Yang. Ph.D. Ken-Ichi Suzuki, Ph.D. Marek Hajduczenia, Ph.D. Mark Laubach Moto

38、yuki Takizawa Zhou Zhen, Ph.D. CableLabs Charter Communications (former Bright House Networks) Broadcom Ltd. RITT, CATR NTTCharter Communications (former Bright House Networks) Broadcom Ltd. Fujitsu Telecom Networks Fiberhome vi Copyright 2017 IEEE. All rights reserved. Historical participants The f

39、ollowing individuals dedicated their valuable time, energy, and knowledge to the initial creation of IEEE Std 1904.1TM-2013. Venkat Arunarthi, Cortina Victor Blake, Victor Blake Wang Bo, China Telecommunications Corp. Zhang Boshan, ZTE Corporation Alan M. Brown, Aurora Networks Xiao Chen, Alcatel-Lu

40、cent Shen Chengbin, China Telecom Fumio Daido, Sumitomo Electric Industries Ltd. Peng Du, Broadcom Corporation Hesham ElBakoury, Huawei Technologies Michael Emmendorfer, ARRIS Josh Feinstein, Broadcom Corporation Marek Hajduczenia, ZTE Corporation Ryan Hirth, Broadcom Corporation Takeshi Imai, Mitsu

41、bishi Electric Corporation Ryo Inohara, KDDI R&D Laboratories Inc. Erez Izenberg, Marvell Qiang Jiang, Broadcom Corporation Keisuke Jinen, Sumitomo Electric Industries Ltd. Manabu Kato, PMC-Sierra, Inc. Lior Khermosh, PMC-Sierra, Inc. Mitsunobu Kimura, Hitachi, Ltd. Curtis Knittle, Cable Television

42、Laboratories (CableLabs) Shinichi Kouyama, Sumitomo Electric Industries Ltd. Seiji Kozaki, Mitsubishi Electric Corporation Glen Kramer, Broadcom Corporation Toshihiko Kusano, Oliver Solutions, Ltd. Lowell Lamb, Broadcom Corporation Jeff Lapak, University of New Hampshire-IOL Rick Li, Cortina Xuguang

43、 Li, Qualcomm Wei Lin, Huawei Technologies Eric Lynskey, Broadcom Corporation Bob Mandeville, Iometrix Jeff Mandin, PMC-Sierra, Inc. Makoto Matsuoka, Hitachi, Ltd. Hiroaki Mukai, Mitsubishi Electric Corporation Daisuke Murayama, NTT Corporation Kenichi Nakura, Mitsubishi Electric Corporation Susumu

44、Nishihara, NTT Corporation Kazumi Onishi, Oki Electric Industry Co., Ltd. Liu Qian, RITT, CATR Duane Remein, FiberHome Technologies Shoichiro Seno, Mitsubishi Electric Corporation Kenichi Shimamura, NEC Santanu Sinha, Cortina Oren Spector, Oliver Solutions, Ltd. Jeff Stribling, Hitachi Communication

45、s Technologies America, Inc. Takeshi Suehiro, Mitsubishi Electric Corporation Ken-Ichi Suzuki, NTT Corporation Masashi Tadokoro, NTT Corporation Makoto Taguchi, PMC-Sierra, Inc. Akihiro Takahashi, Oki Electric Industry Co., Ltd. Motoyuki Takizawa, Fujitsu Telecom Networks, Ltd. Kiyoshi Uematsu, Oki

46、Electric Industry Co., Ltd. Chengwei Wang, China Telecommunications Corp. Lu Yang, RITT, CATR Hosung Yoon, KT He Yuanling, ZTE Corporation Meiyan Zang, ZTE Corporation Zhou Zhen, FiberHome Technologies The following members of the entity balloting committee voted on this standard. Balloters may have

47、 voted for approval, disapproval, or abstention. Aurora Networks, Inc. Broadcom Corporation Cable Television Laboratories Inc. (CableLabs) Cortina Systems FiberHome Technologies Group FUJITSU Hitachi, Ltd. KT Corp. Maxim Integrated Products Mitsubishi Electric Corporation Mstar Semiconductor, Inc. N

48、EC Corporation Nippon Telegraph and Telephone Corporation (NTT) Nokia Oki Electric Industry Co., Ltd. Oliver Solutions PMC-Sierra, Inc. Qualcomm Incorporated Research Institute of Telecommunications Transmission of Ministry of Industry and Information Technology (RITT) (MITT) Sumitomo Electric Indus

49、tries, LTD UNH-IOL Xilinx ZTE Corporation vii Copyright 2017 IEEE. All rights reserved. When the IEEE-SA Standards Board approved this standard on 14 February 2017, it had the following membership: Jean-Philippe Faure, Chair Vacant Position, Vice Chair John D. Kulick, Past Chair Konstantinos Karachalios, Secretary Chuck Adams Masayuki Ariyoshi Ted Burse Stephen Dukes Doug Edwards J. Travis Griffith Gary HoffmanMichael Janezic Thomas Koshy Joseph L. Koepfinger* Kevin Lu Daleep Mohla Damir Novosel Ronald C. Petersen Annette D. Reilly Robby Robson Dorothy Stanley Adrian