IEEE C37 98-2013 en Seismic Qualification Testing of Protective Relays and Auxiliaries for Nuclear Facilities.pdf

1、 IEEE Standard for SeismicQualification Testing of Protective Relays and Auxiliaries for Nuclear Facilities Sponsored by the Power System Relaying Committee and the Nuclear Power Engineering Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std C37.98-2013(R

2、evision ofIEEE Std C37.98-1987) IEEE Std C37.98-2013 (Revision of IEEE Std C37.98-1987) IEEE Standard for Seismic Qualification Testing of Protective Relays and Auxiliaries for Nuclear Facilities Sponsor Power System Relaying Committee and the Nuclear Power Engineering Committee of the IEEE Power an

3、d Energy Society Approved 11 December 2013 IEEE-SA Standards Board Abstract: The methods and conditions for seismic qualification of protective relays and auxiliaries such as test and control switches, terminal blocks, and indicating lamps for use in nuclear facilities are described in this standard

4、. The primary intent of this standard is to focus on fragility testing and seismic qualification, also known as proof testing (either to generic levels or specific levels). This standard covers relays used in nuclear facilities, but may also be applied to any area in which the seismic response of re

5、lays is a design consideration. The prerequisites for the seismic test are defined in IEEE Std C37.105. Keywords: auxiliaries, chatter, fragility, generic testing, IEEE C37.98, nuclear, operating basis earthquake, proof testing, protective, qualification, relay, required response spectrum, response

6、spectra, safe shutdown earthquake, safety function, seismic, seismic test, test, test response spectrum The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights res

7、erved. Published 30 April 2014. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditio

8、ns relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide oth

9、er goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and maki

10、ng its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his

11、or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, E

12、XEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) A

13、RISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event

14、 that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferr

15、ed to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her view

16、s should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulti

17、ng information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any respons

18、es to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously

19、 been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA

20、 Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implem

21、enters of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE

22、 draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, st

23、andardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will gran

24、t users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danv

25、ers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may b

26、e superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata t

27、hen in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. U

28、sers are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexpl

29、ore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website

30、at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of

31、 this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website

32、at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unf

33、air discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal

34、 validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination

35、 of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2014 IEEE. All rights reserved. vi Participants At the time this IEEE standard was completed, t

36、he Standard Seismic Testing of Relays Working Group had the following membership: Suresh Channarasappa, Chair Marie Nemier, Co-chair Roy Ball Melanie Hamner Brown Jeffrey Burnworth Thomas Koshy Daniel Mikow Arnold Offner Mario Ranieri Sheila Ray At the time this standard was balloted, Subcommittee 2

37、 had the following membership: John White, Chair Robert Konnik, Vice Chair Ed Mohtashemi, Secretary Chris Abernathy Saleem Akhtar Michiaki Akiyama Steve Benson Tom Brewington Nissen M. Burstein Steve Casadevall Suresh Channarasappa Garry Chapman Jake Chilek* Jonathan Cornelius James Dean Dennis Dell

38、inger Phil DiBenedetto* Yikang Dou Mike Dougherty Frank Drumm Yasutaka Eguchi Walter Emerson Wells Fargo* Sean Foley Robert Francis James Gleason Patrick Gleason Patrick Gove Bill Hadovski* Jang Hong-Seok* Dirk-Christian Hopp Kuniyasu Ichiki Ken Kettle Bok Ryul Kim Kyoung-Pyo Kim Kofi Korsah Thomas

39、Koshy Serena Krause Bruce Lory Huaxing Lu* Tania Marinez-Navedo* Ikeda Masaaki Mathew McConnel Daniel Mikow* Asif Mohiuddin Ed Mohtashemi Rie Nakamura Marie Nemier Bill Newell* Sven-Olof Palm James Parello Janez Pavsek Chris Pegge Jan Pirrong Robert Queenan Sheila Ray Fred Roy Steve Sandberg Glen Sc

40、hinzel* Kjell Spang Rebecca Steinman Marek Tengler Ippei Ueyama Ying Wang Carl Weber* John Wheless John White Richard Wood*Corresponding member This standard was completed in partnership with the IEEE Power System Relaying Committee, which had the following membership: Roger Hedding, Chair Mike McDo

41、nald, Vice Chair Pratap Mysore, Secretary Mark Adamiak Eric Allen Barbara Anderson Galina Antonova Alex Apostolov Roy Ball George Bartok Matt Basler Tom Beckwith Miroslav Begovic Gabriel Benmouyal Marc Benou Robert Beresh Oscar Bolado John Boyle Gustavo Brunello Christoph Brunner Dac-Phuoc Bui Zeeky

42、 Bukhala John Burger Jeff Burnworth Mark Carpenter Patrick Carroll T. W. Cease Arvind Chaudhary Steve Conrad Rick Cornelison Randy Crellin Randy Cunico Ratan Das Bob Dempsey Alla Deronja Bill Dickerson Hyder DoCarmo Paul Elkin Everett Fennell Dale Finney Normann Fischer Ken Fodero Dominick Fontana D

43、ale Fredrickson Fred Friend Rafael Garcia Jon Gardell Didier Giarratano Harley Gilleland Jim Hackett Wayne Hartmann Gene Henneberg Charlie Henville Juergen Holbach Stan Horowitz Yi Hu Rich Hunt Chris Huntley Sinichi Imai Jerry Jodice Gerald Johnson Meyer Kao Bogdan Kasztenny Patrick Kerrigan Mladen

44、Kezunovic Sungsoo Kim Gary Kobet Ljubomir Kojovic Prem Kumar Steven Kunsman Raluca Lascu Don Lukach Vahid Madani Amir Makki Aaron Martin Kenneth Martin Pierre Martin Walter McCannon Mark McDonald Peter McLaren Mike Meisinger Rene Midence Dean Miller George Moskos Chuck Mozina Brian Mugalian Adi Mula

45、warman Mukesh Nagpal Marie Nemier Damir Novosel Jim OBrien Russ Patterson Robert Pettigrew Arun Phadke Bruce Pickett Jeff Pond Elmo Price Farnoosh Rahmatian Mario Ranieri Roger Ray Mike Reichard Mohindar Sachdev Sam Sambasivan Miriam Sanders Mark Schroeder Sam Sciacca Tony Seegers Don Sevcik Tarloch

46、an Sidhu Mark Simon Veselin Skendzic Kevin Stephan Bill Strang Charlie Sufana Mal Swanson Jon Sykes Rick Taylor John Tengdin Sudhir Thakur Michael Thompson Demetrios Tziouvaras Joe Uchiyama Eric Udren Benton Vandiver Mani Venkata Ilia Voloh Solveig Ward Phil Waudby Del Weers Roger Whittaker Tom Wied

47、man Philip Winston Murty Yalla Ray Young Rich Young Zhiying Zhang Karl Zimmerman At the time this standard was balloted, I Subcommittee, Relaying Practices, had the following membership: Jeffrey Pond, Chair Brian Mugalian, Co-chair Tom Beckwith Bob Beresh Oscar Bolado John Boyle Jeff Burnworth Mark

48、Carpenter Suresh Channarasappa Kevin Donahoe Fred Friend Rafael Garcia Harley Gielleland Jim Hackett Juergen Holbach Jerry Jodice Gary Kobet Will Knapek Alex Lee Jeff Long Bruce Mackie Bruce Magruder Amir Makki Peter McLaren Mike Meisinger George Moskos Jim Niemira Robert Pettigrew Bruce Pickett Mar

49、io Ranieri Don Sevick Mal Swanson John Tengdin Demetrios Tziouvaras Eric Udren Andre Uribe Del Wheers Roger Whittaker Ray Young Rich Young At the time this IEEE standard was balloted, the Nuclear Power Engineering Committee had the following membership: George A. Ballassi, Chair James Parello, Vice Chair Stephen A. Fleger, Secretary Thomas Koshy, Secretary Elect Satish Aggerwal Ijaz Ahmad Dheya Al-Othmany George Attarian Farouk D. Baxter* Royce Beacom Mark D. Bowman Daniel F. Brosnan* Nissen M. Burstein Keith Bush Robert C. Carruth John P. Carter Suresh Channarasappa Dennis