IEEE C62 42 0-2016 en Application of Surge-Protective Components in Surge-Protective Devices and Equipment Ports-Overview.pdf

1、 IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview Sponsored by the Surge Protective Devices Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std C62.42.0-2016 IEEE Std C62.42.0-2016 IEEE G

2、uide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview Sponsor Surge Protective Devices Committee of the IEEE Power and Energy Society Approved 7 December 2016 IEEE-SA Standards Board IEEE Std C62.42.0-2016 IEEE Guide for the Application of Su

3、rge-Protective Components in Surge-Protective Devices and Equipment PortsOverview ii Copyright 2017 IEEE. All rights reserved. Abstract: Surge-protective components (SPCs) used in power and telecom surge-protective devices (SPDs) and equipment ports are covered in the C62.42 guide series. This Overv

4、iew part covers protective functions, both non-linear and linear; component technologies and characteristics; common circuit designs used in SPDs and equipment ports; and information on the impulse (surge) generators used to test SPCs. Additional parts of C62.42 on specific SPC technologies provide

5、details on component construction, characteristics and ratings, and application examples. Keywords: components, electrical protection, equipment ports, IEEE C62.42.0, mitigation, overcurrent, overvoltage, power, surge, surge-protective devices, telecommunication The Institute of Electrical and Elect

6、ronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2017 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 29 September 2017. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a

7、particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE stan

8、dard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved

9、and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity

10、 nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a co

11、mpetent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PRO

12、FITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND RE

13、GARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. IEEE Std C62.42.0-2016 IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview iv Copyright 2017 IEEE. All rights reserved. Translations The IEEE consensus development process involves the

14、review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Op

15、erations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE s

16、tandards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation w

17、ith IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of conc

18、erned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions exce

19、pt in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submi

20、tted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance

21、to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents

22、may not be construed as doing so Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and reg

23、ulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. IEEE Std C62.42.0-201

24、6 IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview v Copyright 2017 IEEE. All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of a

25、ny individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portion

26、s of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be

27、amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least

28、every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest

29、edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Xplore at http:/ieeexplore.ieee.org/ or contact IEEE at the address listed previously. For mor

30、e information about the IEEE-SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are enc

31、ouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validi

32、ty of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may ind

33、icate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Clai

34、ms may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or cond

35、itions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is e

36、ntirely their own responsibility. Further information may be obtained from the IEEE Standards Association. IEEE Std C62.42.0-2016 IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview Copyright 2017 IEEE. All rights reserved. viParticip

37、ants At the time this guide was completed, the 3.6.3 Low Voltage Surge-Protective Components Application Guide Working Group had the following membership: Mick Maytum, Chair William Travis, Vice Chair Tim Ardley Robert Ashton Frank Basciano Nisar Chaudhry Leonard Drewes Bob Fried Ernie Gallo Bogdan

38、Klobassa Peter Kobsa Al Martin Wolfgang Oertel Thomas Tran The following members of the individual balloting committee voted on this guide. Balloters may have voted for approval, disapproval, or abstention. Charles Barest Frank Basciano William Bush Gary Donner Randall Groves Phillip Havens Raymond

39、Hill Werner Hoelzl Ronald Hotchkiss John Kay Yuri Khersonsky Chad Kiger Benjamin Lanz Lawrenc Long Mick Maytum Daleep Mohla Michael Newman Wolfgang Oertel Lorraine Padden Percy Pool Iulian Profir Charles Rogers Thomas Rozek Steven Sano Nikunj Shah Jerry Smith David Tepen James Timperley John Vergis

40、Matthew Wakeham Lanyi Wang Kenneth White When the IEEE-SA Standards Board approved this guide on 7 December 2016, it had the following membership: Jean-Philippe Faure, Chair Ted Burse, Vice Chair John D. Kulick, Past Chair Konstantinos Karachalios, Secretary Chuck Adams Masayuki Ariyoshi Stephen Duk

41、es Jianbin Fan J. Travis Griffith Gary Hoffman Ronald W. Hotchkiss Michael Janezic Joseph L. Koepfinger* Hung Ling Kevin Lu Annette D. Reilly Gary Robinson Mehmet Ulema Yingli Wen Howard Wolfman Don Wright Yu Yuan Daidi Zhong *Member Emeritus IEEE Std C62.42.0-2016 IEEE Guide for the Application of

42、Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview Copyright 2017 IEEE. All rights reserved. viiIntroduction This introduction is not part of IEEE Std C62.42.0-2016, IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipme

43、nt PortsOverview. External electrical events, such as lightning, can couple into a system by the mechanisms of direct coupling, electric fields, magnetic fields, and electromagnetic fields. Depending on the coupling mechanism, the coupling level can be reduced by the use of equipotential bonding, is

44、olation, and shielding. Once the surge is in the system it can be further mitigated by the use of surge-protective components in surge-protective devices and the equipment ports. The surge appearing in the system may be a voltage wave or a current wave or both. At a given location the surge may be c

45、ommon-mode or differential-mode or a combination of both. The choice of protection configuration and components will depend on the type of expected surge and the system parameters. Surge-protection component functions are either non-linear limiting or linear attenuating. Both types of protective fun

46、ctions can be used together to achieve the optimum surge mitigation. For example, an isolation transformer could be used to provide a galvanic break and common-mode voltage surge mitigation together with non-linear voltage limiters connected across the transformer windings to provide differential-mo

47、de voltage surge mitigation. Clause 3 of this document describes the different terms used in protection engineering. Clause 4 describes the mitigation function types. Clause 5 outlines available protection component technologies and characteristics. Clause 6 provides some examples of protection conf

48、igurations and their protection components. Component surge performance is evaluated by testing with a specified impulse generator. Informative Annex B, Annex C, and Annex D describe the various types of impulse generators, their interaction with surge-protective components, and the resultant compon

49、ent electrical stress levels. IEEE Std C62.42.0-2016 IEEE Guide for the Application of Surge-Protective Components in Surge-Protective Devices and Equipment PortsOverview Copyright 2017 IEEE. All rights reserved. viiiContents 1. Scope 1 2. Definitions, acronyms, and abbreviations 2 2.1 Definitions . 2 2.2 Acronyms and abbreviations . 5 3. Protection or mitigation or suppression? 6 4. Surge mitigation functions 7 4.1 Non-linear protective functions . 7 4.2 Linear suppression functions . 7 5. Component technologies and characteristics 7 5.1 Surge mitigation funct