ISO 8581-1994 Photography electronic flash equipment connectors to synchro-cord《摄影 电子闪光装置 同步软件连接器》.pdf

1、IS0 8581 94 m 4853903 0563238 287 m I NTER NAT I O NA L STANDARD IS0 8581 First edition 1994-03-1 5 Photography - Electronic flash equipment - Connectors to synchro-cord Photographie - Flashs lectroniques - Connexion au cordon de synchronisa fion Reference number IS0 8581 :1994(E) IS0 8583 L1 m L1d5

2、3903 05632L9 333 m IS0 8581:1994(El Foreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body i

3、nterested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechn

4、ical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.

5、 International Standard IS0 8581 was prepared by Technical Committee ISOTTC 42, Photography. O IS0 1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfi

6、lm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56 CH-1 21 1 Genve 20 Switzerland Printed in Switzerland IS0 8583 94 4853903 05bL220 935 0 IS0 IS0 8581:1994(E) Introduction The rapid increase in demand for electronic flash equipment h

7、as resulted in the enormous production of an unlimited number of types of electronic photoflash equipment, and the lack of International Standards for connec- tors between the flash unit and the synchro-cord to camera shutters has resulted in the proliferation of new designs of connectors which has

8、con- tinued to grow at an alarming rate. In 1973, ISO/TC 42 decided to develop a standard for the above object. The aim of this International Standard is to minimize the faulty connection of plugs by amateur photographers and also to reduce the number of types of connectors used for electronic flash

9、 equipment. IS0 8583 94 4852903 05b3223 873 N INTERNATIONAL STANDARD 0 IS0 IS0 8581:1994(E) Photography - Electronic flash equipment - Connectors to synchro-cord 1 Scope This International Standard specifies the electrical connectors (plugs and sockets) to be used for elec- tronic photoflash equipme

10、nt. It gives a limited number of connectors and the dimensions to be used for the connection between flash unit and flash synchro- cords. It does not cover those connectors which are intended for the connection of a mains supply to the flash equipment (see IEC 83 and IEC 3201, nor those intended for

11、 the connection of hand-held cameras to the flash equipment synchro-cord (see IS0 519). 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publi- cation, the editions indicated

12、were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most re- cent editions of the standards indicated below. Members of IEC and IS0 maintain registers of cur- rently valid Inte

13、rnational Standards. IS0 51 9:1992, Photography - Hand-held cameras - lash-connector dimensions. I EC 83: 1 975, Plugs and socket-outlets for domestic and similar general use - Standards. I EC 320: 1981, Appliance couplers for household and similar general purposes. 3 Types and dimensions The limite

14、d types and dimensions of the connectors are given in figures 1 to 4 and tables 1 to 4. The -k , N and - symbols designate electrical polarity. 1 IS0 8581 74 4851%03 05b1222 708 m IS0 8581:1994(E) M Plug - Y-Y ! + x-x 0 IS0 2 Y T IFI fy 1 Socket Figure 1 - “Type 1“ plug and socket IS0 8583 94 495390

15、3 0561223 644 C D IS0 8581:1994(E) 12.5 C 3,5 4,O -0.1 D 4.2 0. O F G I Dimension I mm 5,5 F 3,5 1,25 G 1,75 I Dimension I mm I O I A I 2.5 -0.05 A I 2,7 0. I O I B I lo -0.05 B I 1,2 +y I H I 0,75 I 3 IS0 8581:1994(E) Plug - x-x t+ c i, I Socket Figure 2 - “Type 2“ plug and socket 4 IS0 8583 94 485

16、3703 0563225 437 Plug Dimension mm A 3r0 -Ob35 B 2,5 f 0,03 +O015 IS0 8581:1994(E) Socket Dimension mm A 3,l +tl B 2,55 f 0,05 Table 2 - Dimensions for “WD 2“ plug and socket c D O 3,4 +y C 3.4 -0.1 05 D 0,6 +: E F 23 E 3.0 min. 7.6 f 02 F 6.0 I G I 2,15 f 0,05 I I I H I O -0,05 0,83 f 0,025 I L J I

17、 1 ,o I K I 1,4 I I I O 1 .o I Q I P I 0.4 I I I 02 I 5 IS0 8581 94 = Li851903 05bl1226 353 W IS0 8581:1994(E) Plug + 0 IS0 6 Socket Figure 3 - ”Type 3” plug and socket IS0 8583 94 4853903 05b3227 29T A IS0 8581:1994(E) O 6135 -0,15 A et5 -0.1 O E F I Dimension I mm I Dimension I mm I 115 -0.1 E 1 ,

18、o O O 2,o f 0,l F l2a5 -0.15 I B I 5,O -0.1 OI B I I I H I 2,o O. I 7 IS0 8581:1994(E) IS0 8581 9Ll 4853903 0561228 L2b = ml F H el Y Plug - Socket Figure 4 - “Type 4“ plug and socket IS0 8581 94 = 4651503 0563229 Ob2 I IS0 8581:1994(E) 0,4 f 0,l Table 4 - Dimensions for “type 4“ plug and socket J I

19、 2,3 f 0,l I G K 0,7 f 0,3 L 45“ M 45“ N o, 1 1) This dimension applies when the plug is inserted into the socket. - A I 3,l f 0,l I I I H I 0.7 f 0.1 I I I 9 IS0 8581:1994(E) IS0 8581 94 W 4453903 0561230 884 W ICs 37.040.1 O Descriptors: photography, photographic equipment, electronic equipment, flash equipment, electric connectors, plug connectors, socket connectors, dimensions. Price based on 9 Dams