HD 22 2 S2 A6-1992 AMD 6 Rubber Insulated Cables of Rated Voltages up to and Including 450 750 V Part 2 Test Methods《修改件6 额定电压450 750 V及以下的橡胶绝缘电缆 第2部分 试验方法》.pdf

1、CENELEC INFORMATION SHEET Issue 1 1992-04-03 Rue dc: Staseart. 35 - 1050 Bruxelles Tbl.: (+ 32 2) 519.68.71 - Fax: (+ 32 2) 519.69.19 Teletex 206 2210097 * CENCEL - Tx 172210097 HD 22.2 S2lA6 April 1992 Rubber insulated cables of rated voltages up to and including 5501750 V Part 2: Test methods . Co

2、nducteurs et cibles isols au Isolierte Starkstromleitungen mit caoutchouc, de tension nominale au einer Isolierung aus Gummi mit plus gale a 4501750 V Nennspannungen bis 4501750 V Deuxime partie: Mthodes dessais Teil 2: Prfverfahren RD: IEC 265-2:1980 Related to Directive: 73123iEEC This amendment c

3、onsists of the following: - Title Page - Endorsement notice - Common modifications prepared by CENELEC technical committee TC 20 date of ratification : 1992-03-24 date of announcement : 1993-01-01 date of withdrawal : 1993-07-01 date of latest publication : 1993-07-01 LIST OF NATIONAL STANDARDS IS G

4、IVEN OVERLEAF HARMONIZED NATIONAL STANDARDS B 3404583 0037027 4 HO 22.2 S2:1982/A6:1992 . AT : BE : CH : DE : OK : ES : FI : FR : GB : GR : IE : IS : IT : LU : NL : NO : PT : SE : NOS No *standard SP Standard in preparation NR Standard under revision 3404583 0037028 b t HARMONIZATION DOCUMENT DOCUME

5、NT DHARMONISATION HARMONISIERUNGSDOKUMENT HO 22.2 S2/A6 April 1992 UDC 621.315.211.2.02-7.475.001.4 Descriptors: see overleaf ENGLISH VERSION RUBBER INSULATED CABLES OF RATED VOLTAGES UP TO AND INCLUDING 450/750 V PART 2: TEST METHODS Conducteurs et cbles isols Isolierte Starkstromleitungen au caout

6、chouc, de tension mit einer Isolierung aus Gummi nominale au plus egale 450/750 V mit Nennspannungen bis 4501750 V Deuxime partie: Mthodes Teil 2: Prfverfahren dessais This amendment modifies the Harmonization Document HO 22.2 S2:1982. It was approved by CENELEC on 1992-03-24. CENELEC members are bo

7、und to comply with the CENICENELEC Inernal Regulations which stipulate the conditions for implementation of this amendment on a national level. Up-to-date lists and bibliographical references concerning national implementation may be obtained on application to the Central Secretariat or to any CENEL

8、EC member. This amendment exists in three official versions (English, French and German). CENELEC members are the national electrotechnical committees of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Sw

9、itzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardization Comite Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: rue de Stassart 35, 8-1050 Brussels a1992 Copyright reserved to CENELEC members Ref. No

10、 HO 22.2 S2:1982/A6:1992 E lal 3484583 0037829 8 Page 2 HD 22.2 S2:1982/A6:1992 Descriptors: Conductor, cable, flexible cable, rigid cable, single core cable, multicore cable, conductor material, flat cable, compound, polychloroprene, rubber, elastomer, insulation compound, type test, sample test,

11、routine test, nominal voltage, mark, common marking, identification, colour scheme, construction, insulation, separator, filler, sheath, braid, inner layer, outer layer, thickness, mean value, specified value, electrical resistance, test, tensile strength, elongation at break, ageing, air oven, oxyg

12、en bomb, hot set, complete cable, overall dimensions, bending, flexing, voltage test, absence of short circuits, spark (test), insulation resistance, wear resistance, test (under) ire (conditions), guide to use, solderability test FOREWORD Following a decision taken by CENELEC Technical Committee TC

13、 20 at their meeting in Vienna in November 1990 some supplementary common modifications to the International Standard IEC 245-2:1980 were submitted to the CENELEC Unique Acceptance Procedure (UAP) in July 1991 for acceptance as an amendment to HD 22.2 S2:1982. The text of the draft was approved by C

14、ENELEC as amendment A6 to HD 22.2 S2:1982 on 24 March 1992. The following dates were fixed: - latest date o announcement of the amendment at national level (doa) 1993-01-01 - latest date of publication of an identical national standard (dop) 1993-07-01 - latest date of withdrawal of conflicting nati

15、onal standards (dow) 1993-07-01 For products which have complied with HD 22.2 S2:1982 and its amendments before 1993-07-01, as shown by the manufacturer or by a certification body, this previous standard may continue to apply or production until 1994-07-01. Page 3 HI) 22.2 S2:1982/A6:1992 Amendment A6 to HD 22.2 S2 3.2 (as given in A2 to 1 HD 22.2 S2) Replace the table by: Nominal cross-sectional area (mmz 1 10 16 25 35 50 70 95 120 150 185 Maximum distance il(cm) Class D Conductors Class E Conductors 65 65 65 75 75 80 90 110 130 150 45 45 45 50 50 55 60 75 90 95