Automatic control of the traffic flow.ppt

1、Automatic control of the traffic flow,Aurel Vlaicu University of Arad, Romania, e-mail: balasdrbalas.ro,Valentina E. Balas,CONTENT INTRODUCTION. THE ADAPTIVE CRUISE CONTROL TRAFFIC INDICATORS THE CONSTANT TIME TO COLLISION CRITERION THE PD FUZZY-INTERPOLATIVE CRUISE CONTROLLER CONSTANT TIME TO COLLI

2、SION PLATOONS CONCLUDING REMARKS,1. Introduction. The Adaptive Cruise Control,Logistics is the management of the flow of goods, information and other resources, including energy and people, between the point of origin and the point of consumption, in order to meet the requirements of consumers. Logi

3、stics involves the integration of information, transportation, material-handling, and packaging. This lecture is dealing with a new method for the management of the traffic flow on highways.,The Intelligent Transportation Systems allow cars to “think.” A set of facilities with different degrees of i

4、mplication in the driving action is proposed by the Advance Driver Assistance Systems (ADAS), etc. ADAS are systems to help the driver in its driving process. When designed with a safe Human-Machine Interface it should increase car safety and road safety.,Adaptive cruise control (ACC) or the Intelli

5、gent Cruise Control (ICC) uses either a radar or laser setup to allow the vehicle to slow when approaching another vehicle and accelerate again to the preset speed when traffic allows. Collision warning system, a system of sensors that is warning the driver of any dangers that may lie ahead on the r

6、oad. Some of the dangers that these sensors can pick up on include how close the car is to other cars surrounding it, how much its speed needs to be reduced while going around a curve, and how close the car is to going off the road.,Following ACC cars on highway,Intelligent speed adaptation or intel

7、ligent speed ad-vice (ISA) are systems that constantly monitor the local speed limit and the vehicle speed and imple-ments an advice or an action when the vehicle is found to be exceeding the speed limit. In-vehicle navigation systems with GPS and TMC (Traffic Message Channel) for providing up-to-da

8、te traffic information. Lane/road departure detection/warning system Lane change assistance Night vision Adaptive light control,Pedestrian protection system Automatic parking Traffic sign recognition Blind spot detection Driver drowsiness detection Car to car communication Hill descent control etc.,

9、ACC (Adaptive Cruise Control) signal processing architecture,Despite the safety benefits: enhanced driving performance and minimization of crash risks, reduced driver stress and fatigue, reduced conflicts and vari-ance in behavior, etc. the effective put in practice of these developments will have t

10、o wait. The causes are economic, but also technical. Automate driving is likely to produce at its turn safety risks by the driver distraction and reduced situation awareness, causing in time the reducing of the driving skill. But above all, any automate inter-vention into the cars operation can caus

11、e instinctive and inopportune reactions of the driver.,ACC (Adaptice Cruise Control) human-machine interface,2. Traffic Indicators,In the car following case, several indicators were introduced in order to measure the characteristics of the traffic flow: the time-to-collision (TTC) the time-to-accide

12、nt (TTA) the post-encroachment-time (PET) the deceleration-to-safety-time (DTS) the number of shockwaves, etc.,The Time-to-Collision (TTC) is the time that it takes before Car2 collide with Car1, assuming unchanged speeds of both vehicles during this approach:(1)Negative TTC imply that Car1 drives f

13、aster, i.e. there is no danger. Positive TTC express a certain unsafe approach. TTC is linked to the longitudinal driving task and supports a set of safety techniques as the Intelligent Speed Adapter (ISA) limiting the speed to the prevailing speed limit of the current road section.,The Time to Coll

14、ision indicator,The Inverse Time to Collision,Due to the annulations of its denominator when v2 = v1, TTC is presenting frequent commutations between . That is why TTC is often replaced by the d(v1 - v2) trajectory.However d(v1 - v2) is not very suggesting when evalu-ating the collision risk. That i

15、s why in a previous paper we introduced the Inverse Time to Collision TTC-1, which is pro-portional to the collision risk : (2),A simulation scenario,A d(v2-v1) diagram,The evolutions of TTC and TTC-1,Fig. 2.,A TTC-1(v2 v1) trajectory and a corresponding fuzzy partition assisting the driver,Among ot

16、her specifications referring to speed, acceleration and deceleration limitations, AICC (Adaptive Intelligent Cruise Control) is introducing a particular di(v2) law: di(v2) = z0 + z1 v2 + z2 v22 = 3 + z1 v2 + 0.01 v22 (3)Several settings are recommended, for example z1 = 0.8s or z1 = 0.6s. Two object

17、ions can be drawn against (3): - no adaptation to the traffic intensity is provided: if (3) is tuned for the highest possible traffic, when the traffic is de-creasing, the following cars will continue to maintain the same short distance-gaps between them; - z1 and z2 are artificially introduced para

18、meters, a polynomial design has no significance for humans.,3. The Constant Time to Collision criterion,We will replace (3) by an optimal di(v2) issued by a particular criterion: the Constant Time To Collision (CTTC). Since the on-line control of TTC is impossible because of the evolution of v2 v1,

19、CTTC must be implemented off-line, with the help of the di(v2) mappings. The initial assumption: a distance gap planner build with TTC will produce CTTC. The method can be applied by computer simulations. Accurate knowledge about the parameters of each specific car (traction, brakes, weight, aerodyn

20、amic coefficient, etc.) can be such way taken into account, which is not possible to the simplified and leveling analytic representation (3).,Applying CTTC brings two obvious advantages: - a constant collision risk for each vehicle; - the possibility to control the traffic flow on extended road sect

21、ions, if each vehicle will apply the same TTC that is currently recommended by the Traffic Management Center: a long TTC means low traffic flow and higher safety while a short TTC means high traffic flow and higher risk.,4. The planned fuzzy-interpolative distance controller,The planned distance-gap

22、 controller consists of:A PD distance controllerThe input variables are the distance-gap error = di d, between the imposed and the realized distance between the cars, and its derivate . The output variable is the force F, positive for traction and negative for braking b) A di(v2) mapping that is ada

23、pting the imposed distance di to the current velocity of the following car v2.,We are using a specific tool: the Fuzzy-Interpolative Con-troller (FIC). A FIC is a fuzzy controller that can be equaled with an interpolative network with linear interpolation, each fuzzy control rule having a correspond

24、ing interpolation node. This way the linguistic fuzzy inferences can be implemented by look-up-tables.,The PD fuzzy-interpolative cruise controller,Such simple controllers can stand for the best possible control solution, if provided with relevant knowledge about the specific controlled process and

25、about the way we want the system to perform. This knowledge becomes compatible with control-lers if it can be modeled. Models can be used either directly (as internal models included into the con-trol algorithm) or indirectly, by assisting the design of the Planning Systems. In this case the essenti

26、al knowledge about the car following system is represented by the di(v2) mapping.,The Traffic Management by CTTC !,CTTC is opening the perspective of managing the traffic flow by means of appropriate TTC values, imposed by the highways administrations to all the participants of the traffic, accordin

27、g to the driving con-ditions. This procedure is creating an even distribution of the collision risk of all the automobiles that are form-ing a CTTC platoon. Thanks to the fact that di(v2,TTC) planners can be designed for any automobile type the big differences existing among the technical data of th

28、e highway cars will not affect the flow.,5. Constant Time to Collision Platoons,The CTTC platoons are highway cars formations composed by automobiles provided with CCTC cruise controllers. One can imagine such large platoons leaded by “safety cars.”,Each car has its own technical parameters: weights

29、 between 1000 and 1400kg (M), engine powers between 100% and 180% of the generic Car1 power (Gain) and its own CTTC planner (Di(V2,TTC) look-up-tables). The initial speed Vo and position Xo of each car can be as well adjusted.,Simulation Results,The scenario,The platoons length dependence with the s

30、peed, for TTC=7s,The positions of the cars during the aggregation of the platoon,The Constant Time to Collision Criterion CTTC is an optimization criterion that in the case of two following cars is imposing a particular distance gap, such way that the time to collision between cars is constant for a

31、ny speed of the following car. When each car is equipped with a CTTC cruise controller the traffic management center can impose the same TTC to all the cars. The smaller the imposed TTC is, the smaller the distance gaps between cars will be, and the higher the traffic flow and the collision risk (th

32、at is evenly distributed over all the highway section) will be. The highway system becomes distributed, each car trying to reach and to maintain an optimized position. Besides the simplicity and the advantageous interpolative implemen-tation, all the TTC based tools have a common feature: they are embed-ding precise knowledge about the technical data of the automobiles thanks to the functional computer model that stands behind their design.,Conclusions,Thank you for your attention!,