BS ISO 8783-2015 Alpine skis Guidelines for conducting slope performance tests《高山滑雪 斜坡性能试验指南》.pdf

1、BSI Standards Publication BS ISO 8783:2015 Alpine skis Guidelines for conducting slope performance testsBS ISO 8783:2015 BRITISH STANDARD National foreword This British Standard is the UK implementation of ISO 8783:2015. The UK participation in its preparation was entrusted to Technical Committee SW

2、/136, Sports, playground and other recreational equipment. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Th

3、e British Standards Institution 2015. Published by BSI Standards Limited 2015 ISBN 978 0 580 85644 0 ICS 97.220.20 Compliance with a British Standard cannot confer immunity from legal obligations. This British Standard was published under the authority of the Standards Policy and Strategy Committee

4、on 31 July 2015. Amendments issued since publication Date Text affectedBS ISO 8783:2015 ISO 2015 Alpine skis Guidelines for conducting slope performance tests Skis alpins Principes directeurs pour la ralisation dessais de performance sur piste INTERNATIONAL STANDARD ISO 8783 Second edition 2015-08-0

5、1 Reference number ISO 8783:2015(E)BS ISO 8783:2015ISO 8783:2015(E)ii ISO 2015 All rights reserved COPYRIGHT PROTECTED DOCUMENT ISO 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by an

6、y means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 CP 40

7、1 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyrightiso.org www.iso.orgBS ISO 8783:2015ISO 8783:2015(E)Foreword iv 1 Scope . 1 2 Normative reference . 1 3 T erms and definitions . 1 4 Principle 2 5 Test conditions . 2 6 Test personnel . 2 6.1 Requirements . 2 6

8、.2 Skiing ability 2 6.3 Assessment ability . 2 7 Test committee . 2 8 Test skis 2 9 Rating . 3 9.1 Criteria . 3 9.2 Classification . 3 10 Preparation 3 11 Additional elements and tuning (binding and damping elements) 3 12 Binding and binding systems 4 13 Test report . 4 14 Publication of test result

9、s . 4 ISO 2015 All rights reserved iii Contents PageBS ISO 8783:2015ISO 8783:2015(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out thr

10、ough ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collabo

11、rates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval

12、 criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subj

13、ect of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents). Any trad

14、e name used in this document is information given for the convenience of users and does not constitute an endorsement. For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISOs adherence to the WTO principles in the Te

15、chnical Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information The committee responsible for this document is ISO/TC 83, Sports and other recreational facilities and equipment, Subcommittee SC 4, Snowsports equipment. This second edition cancels and replaces the first ed

16、ition (ISO 8783:1999), which has been technically revised.iv ISO 2015 All rights reservedBS ISO 8783:2015INTERNATIONAL ST ANDARD ISO 8783:2015(E) Alpine skis Guidelines for conducting slope performance tests 1 Scope This International Standard provides guidelines for carrying out comparative testing

17、 of alpine skis with the objective of evaluating the performance characteristics. It is applicable to alpine skis in accordance with ISO 6289. 2 Normative reference The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. Fo

18、r dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 6289, Skis Vocabulary 3 T erms a nd definiti ons For the purposes of this document, the terms and definitions given in ISO 6289 and the fo

19、llowing apply. 3.1 turnability ski characteristic relating to ease of turning Note 1 to entry: The less force and movement required, the greater the turnability. 3.2 edge grip ski characteristic pertaining to the ability of the ski to hold on hard surfaces 3.3 steering behaviour ski characteristic p

20、ertaining to the execution and completion of a turn to change direction 3.4 stability ski characteristic pertaining to maintaining direction at a given speed when turning 3.5 quietness ski characteristic pertaining to dampening behaviour, anti-shock, ability to absorb shock 3.6 skier friendly ski ch

21、aracter ski characteristic pertaining to the ease of use or exaggerated control actions of the skier 3.7 total score sum of all ratings ISO 2015 All rights reserved 1BS ISO 8783:2015ISO 8783:2015(E) 4 Principle Evaluation of ski performance through subjective and comparative rating by competent test

22、 personnel based on the test criteria provided, and statistical support by using sufficient individual results with regard to test personnel, terrain conditions and test skis. 5 Test conditions The test run shall provide terrain on which all skiing manoeuvres can be carried out. The site shall permi

23、t every tester to conduct the same manoeuvres at the same place on the slope. The test shall be carried out in hard and well-prepared snow conditions. Each tester shall test every ski of a predetermined group of skis. Skis belonging to the same category of test skis shall be tested within one day, p

24、rovided that snow conditions do not change considerably during the course of the day. If snow conditions do change considerably within the course of the day, the test shall be interrupted and be continued, provided snow conditions are comparable, on the next day. 6 Test personnel 6.1 Requirements Th

25、e test personnel shall be independent, neutral, and discreet, as responsible experts. 6.2 Skiing ability The skiing ability of personnel shall be such that a representative evaluation of the skis in accordance with the test run is ensured. The physical condition of personnel shall be adequate for th

26、e tasks of the test. The physical condition and the skiing ability should not change significantly during the course of the test. The tester shall be capable and shall be trained to use ski techniques according to the test criteria and also to perform skiing motions treated as single movements. 6.3

27、Assessment ability The tester shall be completely informed about all evaluation criteria and about the system rating scale. 7 Test committee Tests shall be supervised by a test committee consisting of at least three technical experts and the test supervisor. The test committee shall determine, by ma

28、jority vote, when the conditions are adequate for testing. 8 Test skis The test skis shall be typical of the model to be tested and shall be tested as delivered by the manufacturer. The test skis shall be inspected and if, in the course of the test, retuning is deemed to be necessary, this shall be

29、done in accordance with manufacturers instructions. The running surfaces shall be cleaned and uniformly waxed in accordance with the snow conditions at the time of the test.2 ISO 2015 All rights reservedBS ISO 8783:2015ISO 8783:2015(E) For each tester, the boot and binding shall be fitted correctly

30、in relation to the mounting point of the ski, for example by the use of bindings with a movable toe-piece. 9 Rating 9.1 Criteria The criteria to be tested are listed below: a) movement; b) edge grip; c) steering behaviour; d) stability; e) quietness; f) skier friendly/ski character. 9.2 Classificati

31、on For proper comparative rating, it is necessary to use reference skis. These reference skis shall be used repeatedly by all testers. Test skis are rated by comparison with the performance of the reference skis. To assess the required criteria, a rating scale of five grades should be used: a) very

32、good; b) good; c) satisfactory (no special positive or negative characteristics); d) poor; e) very poor. 10 Preparation The test ski shall be tested in an undamaged condition only (free of burrs). When the running surface is damaged considerably, the ski shall be withdrawn from the test for refurbis

33、hment of the damaged area. There shall be no tests prior to the official test and nobody shall be allowed to ski on the test skis prior to the official test. 11 Additional elements and tuning (binding and damping elements) If a ski model is sold exclusively with such additional attached/mounted elem

34、ents, this ski model may be tested in its category together with comparable skis which do not feature this kind of element. If a ski model can be tuned by means of optional elements in order to alter its performance, then it should be possible to test this particular function as well, or it should b

35、e possible to conduct a separate test for the ski with the tuning elements. ISO 2015 All rights reserved 3BS ISO 8783:2015ISO 8783:2015(E) 12 Binding and binding systems The ski shall be tested with the bindings or binding systems which are recommended by the manufacturer. 13 Test report The test re

36、port shall include at least the following information: a) a reference to this International Standard, i.e. ISO 8783; b) an indication of whether the skis are tested as delivered or whether they have been treated for the test; c) a description of the skis tested and their lengths; d) individual ratin

37、gs given; e) total scores and standard deviations; f) any significant deviation from the average of the skis and testers (e.g. testers weight or height, skis length, width, side cuts). 14 Publication of test results Published test results shall provide information on all test and snow conditions. If

38、 ski characteristics are described verbally, only clearly defined technical terms should be used. If the publication provides information in the form of an overall score, the weight of individual ratings and the reasoning for this weighting system shall be explained. All considerations which have le

39、d to the overall score shall be published. An appropriate person or body shall take legal responsibility for carrying out tests and publication of the test results.4 ISO 2015 All rights reservedBS ISO 8783:2015BS ISO 8783:2015ISO 8783:2015(E) ISO 2015 All rights reserved IC S 97.220.20 Price based o

40、n 4 pagesThis page deliberately left blankBSI is the national body responsible for preparing British Standards and other standards-related publications, information and services. BSI is incorporated by Royal Charter. British Standards and other standardization products are published by BSI Standards

41、 Limited. British Standards Institution (BSI) BSI Group Headquarters 389 Chiswick High Road London W4 4AL UK About us We bring together business, industry, government, consumers, innovators and others to shape their combined experience and expertise into standards -based solutions. The knowledge emb

42、odied in our standards has been carefully assembled in a dependable format and refined through our open consultation process. Organizations of all sizes and across all sectors choose standards to help them achieve their goals. Information on standards We can provide you with the knowledge that your

43、organization needs to succeed. Find out more about British Standards by visiting our website at or contacting our Customer Services team or Knowledge Centre. Buying standards You can buy and download PDF versions of BSI publications, including British and adopted European and international standard

44、s, through our website at where hard copies can also be purchased. If you need international and foreign standards from other Standards Development Organizations, hard copies can be ordered from our Customer Services team. Subscriptions Our range of subscription services are designed to make using

45、standards easier for you. For further information on our subscription products go to With British Standards Online (BSOL) youll have instant access to over 55,000 British and adopted European and international standards from your desktop. Its available 24/7 and is refreshed daily so youll always be

46、 up to date. You can keep in touch with standards developments and receive substantial discounts on the purchase price of standards, both in single copy and subscription format, by becoming a BSI Subscribing Member. PLUS is an updating service exclusive to BSI Subscribing Members. You will automatic

47、ally receive the latest hard copy of your standards when theyre revised or replaced. To find out more about becoming a BSI Subscribing Member and the benefits of membership, please visit With a Multi-User Network Licence (MUNL) you are able to host standards publications on your intranet. Licences

48、can cover as few or as many users as you wish. With updates supplied as soon as theyre available, you can be sure your documentation is current. For further information, email . Revisions Our British Standards and other publications are updated by amendment or revision. We continually improve the qu

49、ality of our products and services to benefit your business. If you find an inaccuracy or ambiguity within a British Standard or other BSI publication please inform the Knowledge Centre. Copyright All the data, software and documentation set out in all British Standards and other BSI publications are the property of and copyrighted by BSI, or some person or entity that owns copyright in the information used (such as the inter