ImageVerifierCode 换一换
格式:PDF , 页数:5 ,大小:50.02KB ,
资源ID:418139      下载积分:2000 积分
快捷下载
登录下载
邮箱/手机:
温馨提示:
如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
如填写123,账号就是123,密码也是123。
特别说明:
请自助下载,系统不会自动发送文件的哦; 如果您已付费,想二次下载,请登录后访问:我的下载记录
支付方式: 支付宝扫码支付 微信扫码支付   
注意:如需开发票,请勿充值!
验证码:   换一换

加入VIP,免费下载
 

温馨提示:由于个人手机设置不同,如果发现不能下载,请复制以下地址【http://www.mydoc123.com/d-418139.html】到电脑端继续下载(重复下载不扣费)。

已注册用户请登录:
账号:
密码:
验证码:   换一换
  忘记密码?
三方登录: 微信登录  

下载须知

1: 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。
2: 试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。
3: 文件的所有权益归上传用户所有。
4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
5. 本站仅提供交流平台,并不能对任何下载内容负责。
6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

版权提示 | 免责声明

本文(AASHTO T 194-1997 Standard Method of Test for Determination of Organic Matter in Soils by Wet Combustion《湿法燃烧测定土壤中有机物》.pdf)为本站会员(hopesteam270)主动上传,麦多课文库仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文库(发送邮件至master@mydoc123.com或直接QQ联系客服),我们立即给予删除!

AASHTO T 194-1997 Standard Method of Test for Determination of Organic Matter in Soils by Wet Combustion《湿法燃烧测定土壤中有机物》.pdf

1、Standard Method of Test for Determination of Organic Matter in Soils by Wet Combustion AASHTO Designation: T 194-97 (2013) American Association of State Highway and Transportation Officials 444 North Capitol Street N.W., Suite 249 Washington, D.C. 20001 TS-1a T 194-1 AASHTO Standard Method of Test f

2、or Determination of Organic Matter in Soils by Wet Combustion AASHTO Designation: T 194-97 (2013) 1. SCOPE 1.1. The Wet Combustion method for the determination of soil organic matter is most applicable when it is desired to determine the humus-like, easily oxidized organic material to provide inform

3、ation relating to the suitability of the soil for plant growth. The method provides a good estimate of this type of organic matter, and, when the soil contains only this type, it can also provide a good estimate of the total organic content. However, the reagents used react only very slightly with f

4、resh plant materials such as wood, roots, grass, and weed tops, etc., or with hydrocarbons, charcoal, lignite, coal, and the organic remains in ancient sediments. If such materials are present and the total organic matter is to be determined, the Loss on Ignition method found in T 267 must be used.

5、1.2. The following applies to all specified limits in this standard: For the purposes of determining conformance with these specifications, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand place of figures used in expressing the limiting value

6、, in accordance with ASTM E29, Using Significant Digits in Test Data to Determine Conformance with Specifications. 1.3. The values stated in SI units are to be regarded as the standard. 1.4. Refer to R 16 for regulatory information for chemicals. 2. REFERENCED DOCUMENTS 2.1. AASHTO Standards: R 16,

7、Regulatory Information for Chemicals Used in AASHTO Tests T 267, Determination of Organic Content in Soils by Loss on Ignition 2.2. ASTM Standard: E29, Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications 3. REAGENTS 3.1. 1 Normal Potassium Dichrom

8、ateDissolve 49.04 g of dry reagent K2Cr2O7in distilled or deionized water and dilute to 1 L. 3.2. 0.5 Normal Ferrous SulfateDissolve 140 g of reagent grade FeSO47H2O in distilled water, add 40 mL of concentrated sulfuric acid, cool, and dilute to 1 L. Standardize this reagent each day by a “blank” t

9、itration against exactly 10.5 mL of 1 Normal potassium dichromate, as described in the method given below, but without a soil sample. 2015 by the American Association of State Highway and Transportation Officials.All rights reserved. Duplication is a violation of applicable law.TS-1a T 194-2 AASHTO

10、3.3. Barium Diphenylamine-SulfonateDissolve 0.16 g of reagent grade barium diphenylamine-sulfonate in 100 mL of distilled water. 3.4. Sulfuric AcidConcentrated (not less than 96 percent), reagent grade. 3.5. Phosphoric Acid85 percent, reagent grade. 4. APPARATUS 4.1. BalanceThe balance shall conform

11、 to M 231, Class B. 4.2. Erlenmeyer flasks, 400 mL. 4.3. Volumetric flasks, 1000 mL. 4.4. Transfer pipettes, 10 mL and 20 mL (or burettes). 4.5. Heat resistant pad. 4.6. Graduated cylinders, 250 mL and 25 mL. 4.7. Dropping bottles for indicator solutions. For barium diphenylamine-sulfonate solution,

12、 add 0.80 mL, which equals 15 drops from a dropping bottle. 4.8. Burettes, 50 mL (two required). 4.9. Burette holder and laboratory stand. 4.10. Washing bottle, for distilled water. 4.11. Glass or polyethylene bottle, minimum capacity, 1 L, for storage of potassium dichromate and ferrous sulfate sol

13、utions (two required). 4.12. Oven, capable of maintaining 110 5C (230 9F). 5. PROCEDURE 5.1. Weigh 0.750 to 1.0 g (Note 1) of oven-dried soil passing the 0.425-mm sieve (No. 40), to the nearest 0.001 g, transfer quantitatively to a 400-mL Erlenmeyer flask, and add from a burette or pipette exactly 1

14、0 mL of the potassium dichromate solution. Immediately add from a graduated cylinder or a pipette 20 mL of concentrated sulfuric acid, directing the stream into the solution. Immediately swirl the flask vigorously to mix thoroughly and then allow it to stand on a sheet of asbestos for about 30 min.

15、(See Note 2.) Add 200 mL of distilled or deionized water from a graduated cylinder, 10 mL of phosphoric acid from a graduated cylinder (Note 3), and 0.80 mL (15 drops) of barium diphenylamine-sulfonate indicator and swirl the flask to ensure thorough mixing. While still swirling the flask, add ferro

16、us sulfate solution quantitatively from a burette. The solution will first turn purple, then from dark blue to light blue, after which the ferrous sulfate should be added slowly until the color changeswith little warningto brilliant green. Add 0.5 mL (10 drops) more of the dichromate solution to res

17、tore an excess of dichromate, wash down the inside walls of the flask with a few mL of water from a wash bottle, and complete the titration to a one-drop, light green end-point by adding the ferrous sulfate drop by drop to the swirling flask. If less than 5 mL of the ferrous sulfate solution has bee

18、n used in the titration, repeat the 2015 by the American Association of State Highway and Transportation Officials.All rights reserved. Duplication is a violation of applicable law.TS-1a T 194-3 AASHTO determination with less soil. Make a standardizing “blank” run without a soil sample, but using ex

19、actly 10.5 mL of dichromate and otherwise following the procedure given above. Note 1For peat, use the Loss on Ignition method (T 267). It may be necessary to decrease the amount of soil below the minimum specified under Section 4.1 for soils greater than approximately 10-percent organic. The Loss o

20、n Ignition method (T 267) must be used if the soil sample is less than 0.200 g. Note 2Because the action of chromic acid on organic matter is considerably affected by temperature, the flask should be kept in a relatively draft-free place at room temperature, 20 to 30C (68 to 86F) for the 30-min peri

21、od. 6. CALCULATIONS 6.1. Determine the amount of dichromate solution that was reduced by the soil organic matter. This requires (1) standardization of the ferrous sulfate solution so the amount of dichromate equivalent to the ferrous sulfate actually used in the test may be determined and subtracted

22、 from the total dichromate used in the test; and (2) correction for the small amount of dichromate reduced by impurities in the reagents used. Both of these requirements are satisfied by the “blank” determination described in the procedure. For example, in a blank determination, 10.50 mL of the dich

23、romate solution might require 20.75 mL of ferrous sulfate. In the test procedure for a hypothetical 1.000 g soil sample, 10.50 mL of dichromate would have been used; and the subsequent titration might require 6.80 mL of ferrous sulfate. The amount of dichromate actually reduced by the organic matter

24、 of this soil sample would therefore be 10.50 (1 6.80/20.75), or 7.06 mL; and since the dichromate is a 1 Normal solution, this corresponds to 7.06 milliequivalents of dichromate reduced. 6.2. A milliequivalent of carbon in the oxidation reaction involved in this test method is 0.003 g. The amount o

25、f carbon occurring in easily oxidized carbon would therefore be 7.06 0.003, or 0.021 g, and the percentage of easily oxidized carbon would be 0.021 100/1.000= 2.1 percent. 6.3. It is widely accepted that humus-like soil organic matter contains about 58 percent carbon. Therefore, to convert the perce

26、ntage of easily oxidized carbon to the percentage of easily oxidized organic matter, multiply by 100/58or 1.72. The percentage of easily oxidized organic matter in the example soil would accordingly be 2.1 1.72, or 3.6 percent. 6.4. It has been found for many agricultural soils that the amount of or

27、ganic carbon indicated by the Wet Combustion method is about 77 percent of the total organic content, as determined by the Loss on Ignition method (T 267). Therefore, to approximate the total carbon or total organic matter percentage, the percentage of easily oxidized carbon or organic matter is mul

28、tiplied by 100/77or 1.3. In the example soil, the percentage of total carbon would be 2.1 1.3, or 2.7 percent, and the percentage of total organic matter would be 3.6 1.3, or 4.7 percent. 6.5. The information given above in this section may be summarized in the following equations: sample titre, mLE

29、asily oxidized carbon, percent 10.5 1 0.3 mass of soilblank titre, mL= (1) Total carbon, percent = Equation (1) 1.3. (2) Easily oxidized matter, percent = Equation (1) 1.72. (3) Total organic matter, percent = Equation (1) 1.3 1.72, (4) or Equation (1) 2.236. 2015 by the American Association of Stat

30、e Highway and Transportation Officials.All rights reserved. Duplication is a violation of applicable law.TS-1a T 194-4 AASHTO Note 3It is possible that a color change during titration with ferrous sulfate solution may be impossible to observe with certain types and/or colors of soil. If this occurs, filter the sample through No. 54 filter paper prior to the addition of the barium diphenylamine-sulfonate and then continue with the standard method. 2015 by the American Association of State Highway and Transportation Officials.All rights reserved. Duplication is a violation of applicable law.

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1