AIR FORCE A-A-59930-2013 VOLTAGE STANDARD DC.pdf

1、 Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: WR-ALC/404 SCMS/GUEEA, Robins AFB GA 31098-1670. Since contact information can change, you may want to verify the currency of this address information usin

2、g the ASSIST Online database at https:/assist.dla.mil . AMSC N/A FSC 6625 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. INCH-POUND A-A-59930 29 July 2013 COMMERCIAL ITEM DESCRIPTION VOLTAGE STANDARD, DC The General Services Administration has authorized the use of

3、 this Commercial Item Description as a replacement for PD13WRGUEEA13 for all federal agencies. 1. SCOPE. This commercial item description (CID) describes a DC Voltage Standard, hereinafter referred to as a Voltage Reference and DC Standard. The Voltage Reference and DC Standard provides accurate ref

4、erence values of voltage for the calibration of test measurement and diagnostic equipment used in support and or development, repair and maintenance of navigational aids, radio frequency communications equipment and other measurement equipment. This CID lists the minimum performance, design, functio

5、nal, environmental, reliability requirements and quality assurance provisions for the electronic calibrator. 2. CLASSIFICATION. The Voltage Reference and DC Standard covered by this CID will be commercially available equipment that has factory installed options and/or may be modified to the extent n

6、ecessary to meet the following description. The test set shall be Class 3, in accordance with MIL-PRF-28800, except as specified herein. 3. SALIENT CHARACTERISTICS. 3.1 Item Description. The Voltage Reference and DC Standard shall provide accurate direct current voltage reference values for the cali

7、bration, development, service b) meet appropriate performance standards, or c) at a reasonable price. The prime contractor is responsible for ensuring that all subcontractors comply with this requirement. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,

8、-,-A-A-59930 5 5. PRODUCT CONFORMANCE PROVISIONS. 5.1 Contractor certification. The contractor shall certify and maintain substantiating evidence that the product offered meets the salient characteristics of this commercial item description, and the product conforms to the producers engineering draw

9、ings, specifications, standards, and quality assurance practices. The government reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract. 5.2. Verification. Verification of the delivered elec

10、tronic calibrator will be performed at the delivery point by the end user. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES. 7.1 Source of documents. 7.1.1 Military Specifications, Standards, and Handbooks referenced herein may be obtained onl

11、ine at https:/assist.dla.mil/ or from the Standardization Documents Order Desk, 700 Robbins Ave, Bldg 4, Section D, Philadelphia, PA 19111-5094. 7.1.2 ISO documents may be obtained online at http:/www.iso.org/ or from American National Standards Institute, 1899 L St NW, 11thFloor US-Washington, DC 2

12、0036. 7.1.3 FAR documents may be obtained from the Superintendent of Documents, P.O. Box 371954, Pittsburgh, PA 15250-7954. Electronic copies of the FAR may be obtained online from https:/www.acquisition.gov/far/ . 7.1.4 IEC documents may be obtained online at http:/www.iec.ch/ or from IEC Regional

13、Centre for North American (IEC-ReCNA) 446 Main Street, 16thFloor, Worcester, MA 01608. 7.1.5 EIA/ECA documents may be obtained online at http:/ or from IHS Customer Care 15 Inverness Way East, Englewood CO. 80112. 7.16 FCC documents may be obtained online at http:/www.ecfr.gov/ or from the Federal C

14、ommunications Commission 445 12thStreet SW, Washington DC 20554. 7.2 National Stock Number (NSN). The following NSN corresponds to this CID. The NSN may not be indicative of all possible NSNs associated with this CID. (For reference only) NSN: 6625-01-393-4087 Provided by IHSNot for ResaleNo reprodu

15、ction or networking permitted without license from IHS-,-,-A-A-59930 6 7.3 Key words. Accurate Reference Direct Current, Stable Electric Current Electronic Calibration NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsi

16、bilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil/ . Custodians: Preparing Activity: Air Force 84 Air Force 84 Reviewers: Agent: Air Force 99 Air Force 99 (Project 6625-2013-042)Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-