ANSI IEEE 11073-30200A-2011 Health informatics - Point-of-care medical device communication - Part 30200 Transport profile - Cable connected - Amendment 1.pdf

1、 Part 30200: Transport profile Cable connected Amendment 1 Sponsored by the IEEE 11073 Standards Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA 16 September 2011 IEEE Engineering in Medicine and Biology Society IEEE Std 11073-30200a-2011(Amendment toISO/IEEE 11073-30200:2004)Health informa

2、ticsPoint-of-care medical device communication IEEE Std 11073-30200aTM-2011 (Amendment to ISO/IEEE Std 11073-30200:2004) Health informaticsPoint-of-care medical device communication Part 30200: Transport profile Cable connected Amendment 1 Sponsor IEEE 11073TMStandards Committee of the IEEE Engineer

3、ing in Medicine and Biology Society Approved 16 June 2011 IEEE-SA Standards Board Approved 27 November 2012 American National Standards Institute Abstract: ISO/IEEE Std 11073-30200:2004 is extended in this amendment to include IEEE 802.3 100BASE-T and analysis of the compatibility of cable connectio

4、ns between ISO/IEEE Std 11073-30200:2004 and IEEE Std 802.3TM-2008. Keywords: bedside, IEEE 11073, IEEE Std 802.3-2008, Infrared Data Association (IrDA), legacy device, medical device, medical device communications, MIB, patient, SNTP The Institute of Electrical and Electronics Engineers, Inc. 3 Par

5、k Avenue, New York, NY 10016-5997, USA Copyright 2011 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 16 September 2011. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy p

6、ortions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. iv Copyright 2011 IEEE. All rights reserved. Introduction This introduction is not part of IEEE Std 11073-30200a-2011, Health informaticsPoint-of-care medical device communic

7、ationPart 30200: Transport profileCable connectedAmendment 1. This amendment extends ISO/IEEE Std 11073-30200:2004 to include IEEE 802.3 100BASE-T, and it includes analysis of the compatibility of cable connections between ISO/IEEE Std 11073-30200:2004 and IEEE Std 802.3-2008 B10.aNotice to users La

8、ws and regulations Users of these documents should consult all applicable laws and regulations. Compliance with the provisions of this standard does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicab

9、le regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights This document is copyrighted by the IEEE. It is made available for a wide variety of

10、both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making this document available for use and adoption by public authorities and private users, th

11、e IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE standards should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or

12、 errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of am

13、endments, corrigenda, or errata, visit the IEEE Standards Association web site at http:/ieeexplore.ieee.org/xpl/standards.jsp, or contact the IEEE at the address listed previously. For more information about the IEEE Standards Association or the IEEE standards development process, visit the IEEE-SA

14、web site at http:/standards.ieee.org. aThe numbers in brackets correspond to those of the bibliography in Annex P. v Copyright 2011 IEEE. All rights reserved. Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/updates/e

15、rrata/index.html. Users are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is called to the possibility that implementation of this standar

16、d may require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be r

17、equired, for conducting inquiries into the legal validity or scope of Patents Claims or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this st

18、andard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. vi Copyright 2011 IEEE. All rights reserved. Participants

19、At the time this standard was submitted to the IEEE-SA Standards Board for approval, the InterLAN Working Group had the following membership: Malcolm Clarke, Chair Mark Schnell, Vice Chair Chuck Baker Douglas P. Bogia Jon Camp Thomas Canup Randy Carroll Tony Chan Todd Cooper Mark Craig Jr. Juergen F

20、ischbach Nicolae Goga Kai Hassing Stuart Higgins Nandu Kushalnagar Mike Miller Melvin Reynolds Shekar Roa Judi Romijn Paul Schluter Rick Schrenker Seith Seidman Mazen Shihabi Lars Steubesand Stan Wiley Jan Wittenber Tetsuya Yuda Honggang Zhang The following members of the individual balloting commit

21、tee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Hugh Barrass Christopher Biernacki Keith Chow Malcolm Clarke Randall Groves Kai Hassing Werner Hoelzl Atsushi Ito Raj Jain Piotr Karocki Randall Krohn William Lumpkins Greg Luri Wayne W. Manges Melvin Reyn

22、olds Bartien Sayogo Gil Shultz James Smith Lars Steubesand Walter Struppler Jan Wittenber Oren Yuen When the IEEE-SA Standards Board approved this standard on 16 June 2011, it had the following membership: Richard H. Hulett, Chair John Kulick, Vice Chair Robert Grow, Past Chair Judith Gorman, Secret

23、ary Masayuki Ariyoshi William Bartley Ted Burse Clint Chaplin Wael Diab Jean-Philippe Faure Alex Gelman Paul Houz Jim Hughes Joseph L. Koepfinger* David Law Thomas Lee Hung Ling Oleg Logvinov Ted Olsen Gary Robinson Jon Rosdahl Sam Sciacca Mike Seavey Curtis Siller Phil Winston Howard Wolfman Don Wr

24、ight *Member Emeritus vii Copyright 2011 IEEE. All rights reserved. Also included are the following nonvoting IEEE-SA Standards Board liaisons: Satish Aggarwal, NRC Representative Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Don Messina IEEE Standards Program Manager, Do

25、cument Development Kathryn M. Bennett IEEE Standards Program Manager, Technical Program Development viii Copyright 2011 IEEE. All rights reserved. Contents 1. Overview 2 3.1 Definitions . 3 3.2 Acronyms and abbreviations . 5 4. Goals for this standard 5 4.1 Compliance with other standards . 5 6. Phy

26、sical layer . 5 Annex A (normative) Phyiscal layer 6 Annex E (informative) Detailed rationale for pin assignments 8 Annex F (informative) IEEE Std 802.3-2008 10BASE-T/100BASE-TX 9 Annex O (informative) Analysis of compatibility between ISO/IEEE Std 11073-30200:2004 and 10BASE-T/100BASE-TX of IEEE St

27、d 802.3-2008 10 Annex OP (informative) Bibliography . 36 1 Copyright 2011 IEEE. All rights reserved. Health informaticsPoint-of-care medical device communication Part 30200: Transport profile Cable connected Amendment 1 IMPORTANT NOTICE: This standard is not intended to ensure safety, security, heal

28、th, or environmental protection. Implementers of the standard are responsible for determining appropriate safety, security, environmental, and health practices or regulatory requirements. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices a

29、nd disclaimers appear in all publications containing this document and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Documents.” They can also be obtained on request from IEEE or viewed at http:/standards.ieee.org/IPR/disclaimers.html. NOTETh

30、e editing instructions contained in this corrigendum define how to merge the material contained therein into the existing base standard and its amendments to form the comprehensive standard. The editing instructions are shown in bold italic. Four editing instructions are used: change, delete, insert

31、, and replace. Change is used to make corrections in existing text or tables. The editing instruction specifies the location of the change and describes what is being changed by using strikethrough (to remove old material) and underscore (to add new material). Delete removes existing material. Inser

32、t adds new material without disturbing the existing material. Insertions may require renumbering. If so, renumbering instructions are given in the editing instruction. Replace is used to make changes in figures or equations by removing the existing figure or equation and replacing it with a new one.

33、 Editing instructions, change markings, and this NOTE will not be carried over into future editions because the changes will be incorporated into the base standard.11Notes in text, tables, and figures are given for information only and do not contain requirements needed to implement the standard. IE

34、EE Std 11073-30200a-2011 Health informaticsPoint-of-care medical device communication Part 30200: Transport profileCable connectedAmendment 1 2 Copyright 2011 IEEE. All rights reserved. 1. Overview Change text as shown: This standard is divided into 11 clauses, as follows: Clause 1 provides an overv

35、iew of this standard. Clause 2 lists references to other standards that are useful in applying this standard. Clause 3 provides definitions and abbreviations. Clause 4 provides goals for this standard. Clause 5 provides an overview of network topology and layering. Clause 6 provides a profile of the

36、 physical layer. Clause 7 provides a profile of the data link layer. Clause 8 provides a profile of the network layer. Clause 9 provides a profile of the transport layer. Clause 10 describes the optional time synchronization service. Clause 11 provides labeling and conformance requirements. This sta

37、ndard also contains 1516 annexes, as follows: Annex A describes the physical layer. Annex B provides information on the maximum cable length. Annex C provides examples of physical link media. Annex D provides example schematics for modular adapters. Annex E provides a detailed rationale for pin assi

38、gnments. Annex F describes the use of IEEE 802.3 10BASE-T/100BASE-TX with this standard. Annex G provides a discussion of power delivery considerations. Annex H provides examples of simple bedside communications controller (BCC) and device communications controller (DCC) designs. Annex I provides an

39、 example of an isolated BCC design. Annex J provides an optical isolator design example. Annex K provides marking guidelines. Annex L provides protocol examples, particularly of connection establishment. Annex M defines the Infrared Data Association (IrDA) profile specifications adapted from the IrD

40、A implementation guidelines. Annex N provides guidelines for using the SNTP time synchronization protocol. Annex O provides an analysis of compatibility between ISO/IEEE Std 11073-30200:2004 and 10BASE-T/100BASE-TX of IEEE Std 802.3-2008 B10. Annex OP provides bibliographical references. IEEE Std 11

41、073-30200a-2011 Health informaticsPoint-of-care medical device communication Part 30200: Transport profileCable connectedAmendment 1 3 Copyright 2011 IEEE. All rights reserved. 3. Definitions, acronyms, and abbreviations 3.1 Definitions Change the first paragraph and insert new footnote as shown. De

42、lete B2 from Annex O and renumber subsequent references in Annex O: For the purposes of this document, the following terms and definitions apply. The Authoritative Dictionary of IEEE Standards Terms, Seventh Edition, B2The IEEE Standards Dictionary: Glossary of Terms also called a frame check sequen

43、ce. The CRC is appended to the transmitted frame. At the receiver, the calculation creating the CRC may be repeated, and the result compared to that encoded in the signal. Syn: frame check sequence. 3.1.7 device communications controller (DCC): A communications interface associated with a medical de

44、vice. A DCC may support one or more physically distinct devices acting as a single network communications unit. Its purpose is to provide a point-to-point serial communication link to a BCC. 2The IEEE Standards Dictionary: Glossary of Terms 20 mil: benign. IEEE Std 11073-30200a-2011 Health informati

45、csPoint-of-care medical device communication Part 30200: Transport profileCable connectedAmendment 1 16 Copyright 2011 IEEE. All rights reserved. NOTE 1 Surface mount resistor maximum power dissipation 020150 mW 040263 mW 0603100 mW 0805125 mW 1206250 mW NOTE 2 PCB trace current capacity: http:/ htt

46、p:/ http:/ O.3 Analysis of compatibility of ISO/IEEE Std 11073-30200:2004 and 10BASE-T/100BASE-TX of IEEE Std 802.3-2008 O.3.1 Analysis conclusion Power over Ethernet, alternative A, is functionality compatible with the pin out, signaling, and powering definitions of ISO/IEEE Std 11073-30200:2004. P

47、ower over Ethernet, alternative B, is incompatible with the pin out, signaling, and powering definitions of ISO/IEEE Std 11073-30200:2004. A summary of the analysis is given in Table O.3 in O.3.2, and a full analysis of all the scenarios is given in O.3.3. O.3.2 Analysis summary Table O.3Analysis su

48、mmary Scenario group Scenario Upstream Downstream Conclusion DCC “straight” cabled to an Ethernet wall receptacle A 1 Standard Ethernet DCC Nonoperational, benign 2 Power over Ethernet, alt A DCC Nonoperational, benign 3 Power over Ethernet, alt B DCC Nonoperational, damage potential: 3 conditionsBC

49、C “straight” cabled to an Ethernet wall receptacle B 4 Standard Ethernet BCC Nonoperational, damage potential: 3 conditions5 Power over Ethernet, alt A BCC Nonoperational, damage potential: 3 conditions6 Power over Ethernet, alt B BCC Nonoperational, damage potential: 4 conditionsBCC “straight” cabled to an Etherne