ANSI IEEE C63.18-2014 Recommended Practice for an on-Site Ad Hoc Test Method for Estimating Electrimagnetic Immunity of Medical Devices to Radiated Radio-Frequency (RF) Emissions f.pdf

1、 Accredited Standards Committee C63 Electromagnetic Compatibility C63ANSI C63.18-2014 (Revision of ANSI C63.18-1997) American National Standard Recommended Practice for an On-Site, Ad Hoc Test Method for Estimating Electromagnetic Immunity of Medical Devices to Radiated Radio-Frequency (RF) Emission

2、s from RF Transmitters Accredited Standards Committee C63Electromagnetic Compatibility Accredited by the American National Standards Institute Secretariat Institute of Electrical and Electronics Engineers, Inc. Approved 16 May 2014 American National Standards Institute Table C.1 is adapted with perm

3、ission from RTCA, Inc. from RTCA DO-294, Guidance on Allowing Transmitting Portable Electronic Devices (T-PEDs) on Aircraft, 2007. Abstract: A guide to evaluating electromagnetic immunity of medical devices against radiated radio-frequency (RF) emissions from common RF transmitters is provided in th

4、is recommended practice (e.g., two-way radios; walkie-talkies; mobile phones; wireless-enabled tablets, e-readers, laptop computers, and similar devices; RFID readers; networked mp3 players; two-way pagers; and wireless personal digital assistants PDAs). A comprehensive test or a guarantee is not pr

5、ovided by this protocol but, instead, a basic evaluation is given that can help identify medical devices that might be particularly vulnerable to interference from common RF transmitters. Existing or newly purchased medical devices can be evaluated by this ad hoc test protocol or the protocol can be

6、 implemented for prepurchase evaluation. This recommended practice applies to medical devices used in health-care facilities but can also be adapted to medical devices in home health-care or mobile health-care settings. It does not apply to implantable medical devices (e.g., pacemakers and defibrill

7、ators), transport environments such as ambulances and helicopters, or RF transmitters rated at more than 8 W of output power. Testing with transmitters greater than 8 W in health-care facilities is not recommended because of possible adverse effects on critical-care medical devices that are in use i

8、n nearby areas of the facility. Finally, in-band RF interference where the fundamental frequency of an RF transmitter overlaps with frequencies used by a hospital wireless network or monitoring or other medical device wireless links is not addressed by this recommended practice. Keywords: ad hoc tes

9、ting, American National Standard, ANSI C63.18, electromagnetic compatibility, electromagnetic immunity, electromagnetic interference, EMC, EMI, health-care facilities, in situ testing, medical devices, on-site testing, portable radio frequency transmitters, test method, test procedure, wireless The

10、Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 20 June 2014. Printed in the United States of America. IEEE Bluetooth is a registered trade

11、mark in the U.S. Patent (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Errata Users are encouraged to check the IEEE Errata URL (http:/standards.ieee.org/findstds/errata/index.html

12、), and the one for ASC C63at http:/www.c63.org/explanations_interpretations_request.htm, for errata periodically. Interpretations (ASC C63standards) Current interpretations are essential to the understanding of all ASC C63standards. To assist in the meanings of requirements, informative interpretati

13、ons are available at the following URL: (http:/www.c63.org/standards_development.htm). Users are cautioned that, although interpretations do not and can not change the requirements of a standard, they serve to clarify the meanings of requirements. All interpretations are informative rather than norm

14、ative, until such time as the standard is revised (consistent with ASC C63ANSI-accredited operating procedures) to incorporate the interpretation as a normative requirement. Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject to imp

15、ortant notices and legal disclaimers. These notices and disclaimers, or a reference to this page, appear in all standards and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concerning th

16、e Use of IEEE Standards Documents IEEE Standards documents (standards, recommended practices, and guides), both full-use and trial-use, are developed within IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (“IEEE-SA”) Standards Board. IEEE (“the Institute”)

17、develops its standards through a consensus development process, approved by the American National Standards Institute (“ANSI”), which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and part

18、icipate without compensation from IEEE. While IEEE administers the process and establishes rules to promote fairness in the consensus development process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any judgments contained in its s

19、tandards. IEEE does not warrant or represent the accuracy or content of the material contained in its standards, and expressly disclaims all warranties (express, implied and statutory) not included in this or any other document relating to the standard, including, but not limited to, the warranties

20、of: merchantability; fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WI

21、TH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed

22、at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or

23、 on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as a

24、ppropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR

25、SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF TH

26、E POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered

27、the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or

28、be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE.

29、Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents

30、should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason,

31、IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who

32、 would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards d

33、ocuments should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory require

34、ments. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. The

35、y are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents avail

36、able for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company

37、or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for ed

38、ucational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through t

39、he issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is

40、 more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In or

41、der to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information

42、about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to che

43、ck this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any pate

44、nt rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether

45、the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist f

46、or which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provide

47、d in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their

48、own responsibility. Further information may be obtained from the IEEE Standards Association. vii Copyright 2014 IEEE. All rights reserved. Participants At the time this recommended practice was completed, the Accredited Standards Committee C63Electromagnetic Compatibility had the following membershi

49、p: Daniel Hoolihan, Chair Dan Sigouin, Vice Chair Jerry D. Ramie, Secretary Patricia Roder, Secretariat Organization Represented Name of Representative Alcatel-Lucent . Dheena Moongilan American Council of Independent Laboratories (ACIL) Harry H. Hodes John Repella (Alt.) American Radio Relay League (ARRL) . Edward F. Hare Kermit Carlson (Alt.) Apple, Inc. Manjit Walia Indrandil Sen (Alt.) Blackberry Corporation . Masud Attayi Daoud Attayi (Alt.) Bureau Veritas Jonathan Stewart Mairaj Hussain (Alt.) Cisco Systems . Andy Griffin Dave Case (Alt.) Dell Inc. Richard