ANSI IEEE C63.7-2015 American National Standard Guide for Construction of Test Sites for Performing Radiated Emission Measurements.pdf

1、 American National Standard Guide for Construction of Test Sites for Performing Radiated Emission Measurements Accredited by the American National Standards Institute IEEE 3 Park Avenue New York, NY 10016-5997 USA Accredited Standards Committee C63Electromagnetic Compatibility ANSI C63.7-2015 (Revis

2、ion of ANSI C63.7-2005) C63ANSI C63.7-2015 (Revision of ANSI C63.7-2005) American National Standard Guide for Construction of Test Sites for Performing Radiated Emission Measurements Accredited Standards Committee C63Electromagnetic Compatibility accredited by the American National Standards Institu

3、te Secretariat Institute of Electrical and Electronics Engineers, Inc. Approved 29 January 2015 American National Standards Institute Abstract: Information that is useful in constructing test sites used to perform radiated emission measurements in the frequency range of 30 MHz to 18 GHz is provided.

4、 Final validity of a test site can only be determined by performing normalized site attenuation and/or site voltage standing-wave ratio measurements as described in ANSI C63.4. Keywords: ANSI C63.7, emission measurement, fully anechoic room, open-area test site, radiated emission measurement, semi-a

5、nechoic chamber 1No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher.The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2015 by

6、The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 9 March 2015. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom us

7、e can also be obtained through the Copyright Clearance Center. Errata Users are encouraged to check the IEEE Errata URL (http:/standards.ieee.org/findstds/errata/index.html), and the one for ASC C63at http:/www.c63.org/explanations_interpretations_request.htm, for errata periodically. Interpretation

8、s (ASC C63standards) Current interpretations are essential to the understanding of all ASC C63standards. To assist in the meanings of requirements, informative interpretations are available at the following URL: http:/www.c63.org/documents/misc/posting/new_interpretations.htm. Users are cautioned th

9、at, although interpretations do not and cannot change the requirements of a standard, they serve to clarify the meanings of requirements. All interpretations are informative rather than normative, until such time as the standard is revised (consistent with ASC C63ANSI-accredited operating procedures

10、) to incorporate the interpretation as a normative requirement. Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject to important notices and legal disclaimers. These notices and disclaimers, or a reference to this page, appear in al

11、l standards and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concerning the Use of IEEE Standards Documents IEEE Standards documents (standards, recommended practices, and guides), bot

12、h full-use and trial-use, are developed within IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (“IEEE-SA”) Standards Board. IEEE (“the Institute”) develops its standards through a consensus development process, approved by the American National Standards In

13、stitute (“ANSI”), which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and participate without compensation from IEEE. While IEEE administers the process and establishes rules to promote fa

14、irness in the consensus development process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any judgments contained in its standards. IEEE does not warrant or represent the accuracy or content of the material contained in its standard

15、s, and expressly disclaims all warranties (express, implied and statutory) not included in this or any other document relating to the standard, including, but not limited to, the warranties of: merchantability; fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness,

16、 currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply

17、that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the s

18、tate of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or en

19、tity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE sta

20、ndard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILI

21、TY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE cons

22、ensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accorda

23、nce with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an indi

24、vidual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party,

25、 regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE

26、standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant

27、 response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group

28、. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standa

29、rds document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance wit

30、h applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include

31、 both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright

32、 to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fee

33、s, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standard

34、s documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of t

35、he current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its conte

36、nts, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the i

37、ssuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.or

38、g. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of thi

39、s standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance v

40、ia an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reas

41、onable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Pa

42、tent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonabl

43、e or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Participants At t

44、he time this guide was published, Accredited Standards Committee C63Electromagnetic Compatibility had the following membership: Daniel Hoolihan, Chair Dan Sigouin, Vice Chair Jerry D. Ramie, Secretary Patricia Roder, Secretariat Organization Represented Name of Representative AlcatelLucent Dheena Mo

45、ongilan American Council of Independent Laboratories (ACIL) . Harry H. Hodes . John Repella (Alt.) American Radio Relay League (ARRL) Edward F. Hare . Kermit Carlson (Alt.) Apple, Inc. Manjit Walia Indrandil Sen (Alt.) Blackberry Corporation . Masud Attayi Daoud Attayi (Alt.) Bureau Veritas . Jonath

46、an Stewart . Mairaj Hussain (Alt.) Cisco Systems . Andy Griffin Dave Case (Alt.) Dell Inc. . Richard Worley ETS-Lindgren Zhong Chen Michael Foegelle (Alt.) Federal Communications Commission (FCC) William Hurst Food and Drug Administration (FDA) Jeffrey L. Silberberg Donald M. Witters (Alt.) Industry

47、 Canada . Dan Sigouin Information Technology Industry Council (ITIC) John Hirvela . Joshua Rosenberg (Alt.) IEEE-Electromagnetic Compatibility Society (EMCS) . Andy Drozd Liberty Labs Mike Howard Brandt Langer (Alt.) Motorola Mobility Tom Knipple Motorola Solutions William (Mac) Elliot Deanna Zakhar

48、ia (Alt.) National Institute of Standards and Technology (NIST) Dennis Camell . William Young (Alt.) Northwest EMC Dean Ghizzone . Greg Kiemel (Alt.) PCTEST Engineering Laboratory Greg Snyder Dennis Ward (Alt.) Society of Automotive Engineers (SAE) . Poul Andersen . Gary Fenical (Alt.) Sony Ericsson

49、 Mobile Communications . Mats Hansson Telecommunication Certification Body (TCB) Council Art Wall William Stumpf (Alt.) Telecommunications Industry Association (TIA) . Stephen Whitesell TUV SUD America, Inc. . Chip Fleury . David Schaefer (Alt.) Underwriters Laboratories (UL) . Robert DeLisi . Jeffrey Moser (Alt.) U.S. Department of DefenseJoint Spectrum Center . Marcus Shellman Michael Duncanson (Alt.) U.S. Department of the NavySPAWAR . Chris Dilay Tom Wojtaszek (Alt.) Copyright 2015 IEEE. All rights reserved. vii Copyright 2015 IEEE. All rights reserved. viiiInd