ANSI IEEE N42.38-2015 American National Standard for Performance Criteria for Spectroscopy-Based Portal Monitors Used in Homeland Security.pdf

1、 American National Standard forPerformance Criteria for Spectroscopy-Based Portal Monitors Used in Homeland Security Sponsored by the National Committee on Radiation Instrumentation, N42 IEEE 3 Park Avenue New York, NY 10016-5997 USA Accredited by the American National Standards Institute ANSI N42.3

2、8-2015(Revision of ANSI N42.38-2006) ANSI N42.38-2015 (Revision of ANSI N42.38-2006) American National Standard for Performance Criteria for Spectroscopy-Based Portal Monitors Used for Homeland Security Sponsor National Committee on Radiation Instrumentation, N42 Accredited by the American National

3、Standards Institute Secretariat Institute of Electrical and Electronics Engineers, Inc. Approved 26 June 2015 American National Standards Institute Abstract: The performance requirements for spectroscopy-based portal monitors are described in this standard. The requirements stated are based on porta

4、l monitors used in support of efforts associated with the U.S. Department of Homeland Security. Keywords: ANSI N42.38, portal monitor, spectrometric, spectroscopy The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2016 by The Institute o

5、f Electrical and Electronics Engineers, Inc. All rights reserved. Published 29 January 2016. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also b

6、e obtained through the Copyright Clearance Center. iv Copyright 2016 IEEE. All rights reserved. Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject to important notices and legal disclaimers. These notices and disclaimers, or a refe

7、rence to this page, appear in all standards and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concerning the Use of IEEE Standards Documents IEEE Standards documents (standards, recomme

8、nded practices, and guides), both full-use and trial-use, are developed within IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (“IEEE-SA”) Standards Board. IEEE (“the Institute”) develops its standards through a consensus development process, approved by th

9、e American National Standards Institute (“ANSI”), which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and participate without compensation from IEEE. While IEEE administers the process and

10、 establishes rules to promote fairness in the consensus development process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any judgments contained in its standards. IEEE does not warrant or represent the accuracy or content of the ma

11、terial contained in its standards, and expressly disclaims all warranties (express, implied and statutory) not included in this or any other document relating to the standard, including, but not limited to, the warranties of: merchantability; fitness for a particular purpose; non-infringement; and q

12、uality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of

13、an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought abo

14、ut through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any dut

15、y owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the app

16、ropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAU

17、SED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEE

18、ABLE. v Copyright 2016 IEEE. All rights reserved. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Offici

19、al statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal positi

20、on of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for

21、 revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a propose

22、d change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societ

23、ies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revi

24、sions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applic

25、able laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publi

26、cation of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and a

27、re adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by publi

28、c authorities and private users, IEEE does not waive any rights in copyright to the documents. vi Copyright 2016 IEEE. All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard f

29、or company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual stan

30、dard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to tim

31、e through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a

32、document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE stan

33、dard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more i

34、nformation about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encour

35、aged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity

36、of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indica

37、te whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims

38、may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditi

39、ons provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is enti

40、rely their own responsibility. Further information may be obtained from the IEEE Standards Association. vii Copyright 2016 IEEE. All rights reserved. Participants At the time that ANSI approved this standard, the Accredited Standards Committee on Radiation Instrumentation, N42, had the following mem

41、bership: Michael P. Unterweger, Chair Sue Vogel, Administrative Secretary Organization Represented Name of Representative Canberra Robert Huckins Commerce Dept, U.S. NIST . Leticia Pibida Computer Dependability Associates, LLC . Gary Johnson Consultant Frank X. Masse Department of Homeland Security

42、Peter Shebell Harvard University Joseph Ring Health Physics Society . Sandy Perle Institute of Electrical and Electronics Engineers, Inc Michael P. Unterweger International Medcom . Don Sythe Lawrence Berkeley National Laboratory .Edward J. Lampo Lawrence Livermore National Laboratory . Dave Trombin

43、o NASA, GSFC R. Sachidananda Babu Oak Ridge National Laboratory . Peter J. Chiaro, Jr. Charles Britton (Alt.) ORTEC, Ametek Inc. Frank Sergent Pacific Northwest National Laboratory Richard Kouzes U. S. Army . Chad B. McKee U. S. Nuclear Regulatory Commission Cynthia G. Jones Members-At-Large . Morga

44、n Cox Edward Groeber Ronald M. Keyser Joseph C. McDonald Joseph Stencel At the time this standard was approved, Subcommittee N42.RPI had the following membership: Michael P. Unterweger, Co-Chair Morgan Cox, Co-Chair Peter J. Chiaro, Jr David Gilliam Mark Hoover Cynthia G. Jones Ronald M. Keyser Jose

45、ph C. McDonald Leticia Pibida Peter Shebell David Trombino viii Copyright 2016 IEEE. All rights reserved. At the time this standard was approved, the ANSI 42.38 Working Group had the following membership: Peter J. Chairo, Jr., Chair and Project Leader Chris Blessinger Carl Czajkowski Kenneth Haynes

46、Tom Hazlett Dick Kouzes Achim Kreuels Montserrat Marin-Ferrer Daniel Masi Michael Mayorov Luc Murphy Christopher Oertel Leticia Pibida Alan Proctor Francis Schulcz Adrian Stoian Alice Tomanin Robbie Lynn York ix Copyright 2016 IEEE. All rights reserved. Introduction This introduction is not part of

47、ANSI N42.38-2015, American National Standard for Performance Criteria for Spectroscopy-Based Portal Monitors Used for Homeland Security. This standard is the responsibility of the Accredited American Standards Committee on Radiation Instrumentation, N42. The standard was approved on N42 letter ballo

48、t. x Copyright 2016 IEEE. All rights reserved. Contents 1. Overview 1 1.1 Scope . 1 1.2 Purpose 2 2. Normative references 2 3. Definitions, acronyms, and abbreviations 4 3.1 Definitions . 4 3.2 Acronyms and abbreviations . 6 4. General . 7 4.1 General considerations . 7 4.2 Standard test conditions

49、. 7 4.3 Units and uncertainties 7 4.4 Special word usage 8 5. Design requirements . 8 5.1 General characteristics . 8 5.2 Physical configuration . 10 5.3 Radiological configuration 10 5.4 Indication and alarm features . 12 5.5 Occupancy and speed sensors for vehicle SRPMs . 12 5.6 Markings 13 5.7 Protection of switches 13 5.8 Effective range of measurement 13 5.9 Software and data analysis communications protocol . 14 5.10 User interface . 14 6. Radiation detection and indication performance requirements . 16 6.1 General Test Method . 16 6.2 False alarms/False identificat