ARMY MIL-C-13863-1954 CASE CS-144《CS-144箱》.pdf

1、Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-3.1 Preproduation samp1.e.- Whsn specified, before production $8 begun, a sample of the finished odimod2

2、ty Eshall be subdtted to the contracrting off her for appdval. speaificatlons and draw3.ngs listed in aeation 2, and as specified herein. texture, omforming .Eo type f of: Speoifisation KCfFD-10861. 3.2 Matexdais.- The, materials shall. aonform, in all respects, to-the -3.2.1 Duck aotton.- The duBk

3、shall be before finishing, No, 10, hard 3.2.4.3 _y- Golar and treat;mer and .dpw-resistamt $meted webbing Lhong, vst-dyed olive drab shade No, 7 (me 6*3), effective length Q-lncheei afber attaohmenk to pull, I- - _ Provided by IHSNot for ResaleNo reproduction or networking permitted without license

4、from IHS-,-,-MIL-C-13863 (QMC) 3,2,l2 .Fasteners, snap, brass, bronze finish, style 1, female and male, with single stpado- The snap fasteners shall COOZIII to class 2 of Specifi- cation MIL-F-10884, 3.2J.3 Loops, slide, l-3/4-fnehesS style 1,- The slide loops shall con- form to type 11 of Specifica

5、tion ML-H-l5e 302p31c Loops, triangular, 1-3/4 inches,.- The triangular loops shall oon- form to type IV of Speeifioation MIL-H-t1O05Qe 3,2,15 Snaps, flanged tongue, loop eye, l-3/4-inchese- The snaps shall con- fomii-to type V of Speeifbation MIL-H-10050, 3e3 Construction.- The eonstmotion shall co

6、nfom, in all respects to the drawings listed in sest5on 2, and as specified herein, 3*3,1 Stitching, machine,- 303.1e1 Type of stitchiwe- Stituhing, except baptacking, shall conform to Specification DDD-S-751L, as follows: Fos all stitching - Type 301, 7 to 8 stitches to the incho 30305-el-.1 Type 3

7、01 stitching,- Thread breaks in stftchirg shall he back- stjitched not less than 1-inch at each break. at the ends to prevent, raveling, except where ends are turned under in a hem or held down by other stitching, so that there WS11 be no loose stitch- and that the look will be embedded in the cente

8、r of the materials sewed. Stitching shall be backstitehed Thread tension shall be maantained properly . AU thread ends shall be trhed. 393e.,2t Baptacking shall be 3/4-fnoh in length with 1/80 incn eight, and shall contain not less than 6 stay, 27 cover, and 3 ty-ing stitches, Bar-tacking shall be f

9、ree of thread breaks and loose stitchiwe 3e302 Lubrication of threado- If it is found that in production sewing added lubrication of the thfead is. necessary in order to reduce thmad breakage, use of the lubricating compound specified in 30205 wfll be permittede 3e3Q2e1 Application of lubricating co

10、mpound.- The thread may be lubricated durhg the seIr%ng operation by running it agahst a felt pad saturated wlth Che lubricating aompound, or the full package of thread may be immersed in the same oompomd before sewing o 303e3 Setting of end o1ips,- The webbing shall be inserted the fu3. depth of th

11、e clips. and the webbing shall be flat at the point of entrancee The clips shall be securely attached without cutting Che webbing 5 c Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Provided by IHSNot for ResaleNo reproduction or networking permitted

12、 without license from IHS-,-,-5,2 For domestic shipment (Immediate use) P Subject cases shall be prepared for delivery En such a manner as to be acceptable by common or other carriers for safe transportation to point of destination specified in shipping instruc- taons at the lowest transportation ra

13、te for such supplies, 53 Fos domestic shipment (storage)+- 593,1 Packaging+- Each case shall be assembled with the slide Isops and snaps attached to the straps, much as possible, inslde the case end, 4 hches frm the end The straps with attached hardware shall be placed, as Close the slide fasteney t

14、o approemately Fasten the billet 532 Packing,- Twenty easesI packaged as specified in 5Je1, shall be arranged The last or fifth layer shall be packed v.6th the four in length, one in width and five in depth within a shipping container as here- inafter specifled, triangular loops -packed face up, att

15、ached triangular loops face down, be apmoximately 29b inches in length, 19 inches in width and 18-3/4. inches in depth, Exact dmerisfons must be determined by the contractor to insure that contents fi% snugly in the shipping containers of Specification LLL-B-631 or LU-3-636 and shall be fitted with

16、a one piece doubLs= wall corrugated fiberboard liner as specified for Army requirements+ the fiberboard containers shall be securey sealed with an adhesive commercially used for the specific product being packed by application thmughout; the entire area of contact between the flaps, Alternatively, s

17、hipping containers may be used that csnfom to style A or B of Specification MN-43-591 or PPP-B-601 (domestic type); BF style 2 or k9 kype 2 load of Specification NN-B-621, exeept that the requirements for increased lumber thickness and additional cleats or battens shall not; apply, Each shfming cont

18、ainer, other than fiberboard, shall be provided wth a sealed case $iner mada o% grade B kraft paper hevirtg a basis weight of 40 pounds per ream 2k by 36 - 500) conforming to Specification VU-P-268, overlap not less than 2 inches and shall be sealed with a good quality adhesive, Each layer of cases

19、shall have the side with the atbched Inside dimensions of shipping containers shall %j,3,2,1 Shipping containers,- Shipping containers chal1 conform to style RSC Ai1 flaps af All Seams, joints and fsPbs shali 5,4 For overseas shipment,- 5 or style 2 03 4 sf Specification JAN-P-106, eseepl that requi

20、rements for additional cleats or battens shall not apply, each shipping container shall be provided with a type 1 or II, grade 3 or C, class 2, L-2 or M material:oase liner conforming to Specification MIL-L-10547. In addition, Provided by IHSNot for ResaleNo reproduction or networking permitted with

21、out license from IHS-,-,-Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-le I l :., I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-li P P Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-P- fi9 4 i . pl . - P- 9 I 4 5 4 .- .i Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-r- I 1 I i I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-