ARMY MIL-DTL-41819 50-2012 RIBBON ATTACHMENT FEDERAL LAW ENFORCEMENT CONGRESSIONAL BADGE OF BRAVERY U S DEPARTMENT OF JUSTICE.pdf

1、 AMSC N/A Page 1 of 3 FSC 8455 INCH - POUND MIL-DTL-41819/50 14 May 2012 DETAIL SPECIFICATION SHEET RIBBON ATTACHMENT, FEDERAL LAW ENFORCEMENT, CONGRESSIONAL BADGE OF BRAVERY, U.S. DEPARTMENT OF JUSTICE This specification is approved for use by all Departments and Agencies of the Department of Defen

2、se. The requirements for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-41819. MATERIAL: Red Brass 85/15 (UNS Alloy No. C-230) DIMENSIONS: HEIGHT: 11/32 inch (REF) WIDTH: 11/32 inch (REF) THICKNESS (across designation band): 0.076 inc

3、h 0.010 inch Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-41819/50 Page 2 of 3 FINISH: NICKEL: Center disc and outer scalloped area shall be Nickel Plated, Matte Finish, and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Nu

4、mber 17. GOLD: Borders of designation band and the Congressional Seal (including stars) on center disc shall be 24K Gold Plated, Matte Finish, Polished Highlights, and shall match TIOH Metal Finish Chip Number 8. EPOXY: Hard epoxy enamel shall be applied as indicated below, and shall match TIOH Hard

5、 Enamel Color Chip Number listed: TIOH HARD ENAMEL COLOR CHIP NUMBER LOCATION Blue #20 Designation Band ATTACHING DEVICE: Attaching device shall be a staple type prong (see illustration below). The prong shall be located on the horizontal center line and at least 1/16 inch 1/64 inch from either end

6、of the ribbon attachment, and either fused or hard soldered to the attaching device. The arms of the prong shall be of suitable length for bending across the back of the service ribbon bar to secure the ribbon attachment in place. NOTES: 1. The term (REF) refers to the measurements taken from the ob

7、verse Government furnished hub or die. 2. The manufacturer may deviate from MIL-DTL-3943 by using nickel underplating prior to plating with 24K gold. 3. Hard cloisonn enamel may be used in lieu of epoxy. If hard cloisonn enamel is used, the required base material for -1 and -2 is Gilding Metal 95/5

8、(UNS Alloy C-210). 4. This item is not authorized for commercial sale, and may be produced only under Government contract and at the request of the U.S. Department of Justice. Figure 1 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-41819/50

9、Page 3 of 3 Custodian: Preparing activity: Army - IH Army - IH Civil agency: (Project No. 8455-2012-030) DOJ - BJA NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-