ARMY MIL-F-48616 (2)-1985 FILTER (COATINGS) INFRARED INTERFERENCE GENERAL SPECIFICATION FOR《红外干涉滤光片(涂料)一般规格》.pdf

1、MILITARY SPECIFICATION FILTER (COATINGS), INFRATED INTERFERENCE: GENERAL SPECIFICATION FOR “This amendment forms a part of Military Specif i- cation MIL-F-48616 dated 29 July 1977, and is approved for use by all Departments and Agencies of the Department of Defense.“ PAGE 4 3.4.1.3, line 4: Delete “

2、diamter“ and substitute “diameter“. 3.4.1.3.1, line 9: Delete “small“ and sutistitute “smaller“; ADD THE FOLLOWING SENTENCE TO THE END OF PARAGRAPH: The measurement between digs shall not be required for surfaces where digs larger than allowed, PAGE 6 3.4.2.2.1, line 2: Delete “26C“ and substitute f

3、i62OC“. PAGE 7 MIL-F-48616 AMENDMENT 2 28 January 1985 SUPERSEDING AMENDMENT 1 22 August 1980 of the dist size B are anc e 4.1.2, line 2: Insert between the words “component“ and “may“ the following: “and coated in the same evaporation lot.“ PAGE 10 4.3.2.3, line 3: Delete rror“ and substitute “of“.

4、 TABLE V, NOTE: Delete reference to “III“ and substitute lV“. PAGE 11 4.4.2.3.2.2, b. Transmittance (T) accuracy: Under “TRANSMITTING REGION“ insert 111 between “T“ and “1 .O%“; Under “ATTENUATED REGION“ insert - between “T“ and “1 .O%“ PAGE 12 c. Reflectance (R) accuracy: Under “HIGH REFLECTANCE RE

5、GION“ insert “ between “R“ and “8 O. 0%“ ; Under “MID-REFLECTANCE REGION“ insert “ between “5.0%“ and “R“ and “ between “R“ and “8 O. 0%“ ; Under “LOW REFLECTANCE REGION“ insert between “1.5%“ and “R“ and I, between “R“ and “5.0%“. Insert “, between “R“ and “1.5%“. / THIS DOCUMENT CONJA,NS -5- . PAG

6、ES FSC 6650 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-F-LlBb1b (2) bb m 7779706 O137096 MIL-F-48616 AMENDMENT 2 PAGE 13 4.6.4, line 4: Delete “fluorescant“ and insert “fluorescent“. PAGE 17 Section 5, Title: Delete the title “PREPARATION FO

7、R DELIVERY“ and insert “PACKAGING“. PAGE 18 6.2, item k: Delete “approved“ and insert “approval“. 6.4, a., line 2: Delete “standard air“ and insert “standards evaluated either in a vacuum or in standard air“. PAGE 19 6.4, d, line 4: Insert “of“ between “evaluation“ and “visually“. 6.4, e, line 4: Insert “calculating f oca1 length and“ between “when“and “designing“. Custodians: Preparing activity: Army-AR Amy-AR Air Force-99 (Project 6650-0128) 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-