ARMY MIL-F-51163 A-1981 FILTER UNIT GAS-PARTICULATE GED OR EMD 300 CFM ABCA-M6A1《GED或EMD 300 CFM ABCA-M6A1毒气微粒过滤器机组》.pdf

1、/ - - . MIL-F-SLLb3A L12 W 7777706 023L1573 L m A -I MIL-F-51163A(EA) 17 December 1981 SUPERSEDING MIL-F-51163(MU) 30 August 1963 MILITARY SPECIFICATION FILTER UNIT, GAS-PARTICULATE, GED OR EMD, 300 CFM, ABCA-M6A1 This specification is approved- for use by US Army Armament Research and Development C

2、ommand, Department of the Army, and is available for use by all Depart- ments and Agencies of the Department of Defense. 1. SCOPE This specification covers one type of filter unit used to remove chemical The filter unit is either gasoline agents from air for supply to shelters. engine driven (GED) o

3、r electric motor driven (EMD) (see 6.2). 2. APPLICABLE DOCUMENTS 2.1 Government documents. 2.1.1 Specifications and standards. Unless otherwise specified (see 6.2), , the following specifications and standards of the issue listed in that issue of the Department of Defense Index of Specifications and

4、 Standards (DoDISS) speci- fied in the solicitation, form a part of this specification to the extent speci- fied herein. SPECIFICATIONS FEDERAL P-D-680 - Dry-cleaning Solvent. NN-P-530 - Plywood, Flat Panel. QQ-S-781 - -Steel Strapping, Flat. TT-W-572 - Wood Preservation, Water-Repellen PPP-B-636 -

5、Box, Fiberboard. PPP-C-843 - Cushioning Material, Cellulosic. -0 FSC 4240 : Beneficial comments (recommendations, additions, deletions) and any perti- : : nent data which may be of use in improving this document should be addressed: : to: Commander, US Army Armament Research and Development Command,

6、 ATTN: : DRDAR-TSC-S, Aberdeen Proving Ground, MD 21010 by using the self-addressed r : Standardization Document Improvement Proposal (DD Form 1426) appearing at : : the end of this document or by letter. - Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS

7、-,-,-MIL-F-5LZ63A 42 9777906 0234572 3 MIL-F-5 1 16 3A( EA) MILITARY MIL-C-1.04 MIL-P-116 MIL-B- 12 1 MIL-B-131 MIL-T-704 MIL-E-10062 MIL-C-17 504 MIL-T-22085 Crates, Wood; Lumber and Plywood Sheathed, Nailed and Preservation, Methods of. Barrier Material, Greaseproofed, Waterproofed, Flexible. Barr

8、ier Materials, Water Vaporproof, Flexible, Heat- Treatment and Painting of Materiel. Engines, Spare or Installed (Other than Aircraft), Pre- Coating Compound, Acrylic, Clear. Tapes, Pressure-Sensitive Adhesive, Preservation and Bolted. Sealable. .paration for Shipment and Storage of. Sealing. STANDA

9、RDS MILITARY MIL-STD-105 - Sampling Procedures and Tables for Inspection by MIL-STD-129 - Marking for Shipment and Storage. Attributes. 2.1.2 Other Government documents. The following documents form a part of this specification to the extent specified herein. DRAWINGS AND TECHNICAL DATA PACKAGE LIST

10、 (TDPL) US ARMY ARMAMENT RESEARCH AND DEVELOPMENT COMMAND CHEMICAL SYSTEMS LABORATORY D136-14-152 - Tester, Air Flow, 454, Assembly. D150-2-1 - Marking Diagram for Shipping Containers. TDPL 5-19-1801 - Filter Unit, Gas-Particulate, GED or EMD, 300 CFM, ABCA-M6A1 , Assembly. (Copies of specifications

11、, standards, drawings, and publications required by manufacturers in connection with specific acquisition functions should be obtained from the procuring activity or as directed by the contracting officer. ) 2.2 Other publications. The following documents form a part of this speci- The issues of the

12、 documents that are fication to the extent specified herein. indicated as DoD adopted shall be the issue listed in the current DoDISS and the supplement thereto, if applicable. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-F-SLL63A 42 = 77777

13、06 0234573 5 - - NATION or these items may be secured to the equipment with tape in a location that will not cause damage to any of the mounted components on the filter unit. Tape used to secure these packaged items to the equipment shall be minimum 1-1/2 inches wide, conforming to type IV of PPP-T-

14、97, and shall not be overcoated. The filter unit shall be placed on the wood skid base in the manner 7 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-8 U c B a B E Provided by IHSNot for ResaleNo reproduction or networking permitted without license

15、from IHS-,-,-5.2.2 Level C. MIL-F-5 1163A( EA) 5.2.2.1 GED and EMD filter units. Each filter unit and its respective components, repair parts, and technical publications, preserved and packaged as specified in 5.1.3, shall be packed to insure carrier acceptance and safe delivery at the first destina

16、tion for immediate use. Containers shall be in compliance with Uniform Freight Classification Rules or National Motor Freight Classification Rules. The crate or the finished wood parts thereof shall be completely immersed for a minimum of three minutes in a water-repellent, wood preservative, confor

17、ming to type II, composition A of TT-W-572. 5.3 Marking. In addition to any special marking required by the contract or order, unit packages shall be marked in accordance with MIL-STD-129. containers shall be marked in accordance with D150-2-1. Shipping 6. NOTES 6.1 Intended use. The filter unit cov

18、ered by this specification is intended for use in providing filtered air to pressurized protective shelters. 6.2 Ordering data. Acquisition documents should specify: (a) Title, number and date of this specification. (b) (c) Gasoline engine driven or electric motor driven. Level of packaging and pack

19、ing. 6.3 International interest. Certain provisions of this specification are the subject of international standardization agreement, QSTAG - 296. When amendment, revision, or cancellation of the specification is proposed that will modify the international agreement concerned, the preparing activity

20、 will take appropriate action through international standardization channels, including departmental standardization offices, to change the agreement or make other appropriate accommodations. a 6.4 Component specifications. Component specifications for the ABCA-M6A1 filter unit are: Title Filter, Pa

21、rticulate, 150 cfm, M9A1 Filter, Gas, 150 cfm, M10 Number MIL-F-51165 MIL-F-11137 Custodian: Preparing activity: Army - EA Army - EA Project No. 4240-A657 *U.S. GOVERNMENT PRINTING OFFICE: 1982-505-022/1267 9 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-