ARMY MIL-PRF-49137 6 E-2009 CAPACITORS FIXED ELECTROLYTIC (SOLID ELECTROLYTE) TANTALUM POLAR NONHERMETICALLY SEALED STYLES CX06 AND CX16《CX06型和CX16型非气密性密封 钽(固体电解质)电解固定极性电容器》.pdf

1、INCH-POUND MIL-PRF-49137/6E 19 February 2009 SUPERSEDING MIL-PRF-49137/6D 22 April 2004 PERFORMANCE SPECIFICATION SHEET CAPACITORS, FIXED, ELECTROLYTIC (SOLID ELECTROLYTE), TANTALUM, POLAR, NONHERMETICALLY SEALED, STYLES CX06 AND CX16 This specification is approved for use by all Departments and Age

2、ncies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-49137. CIRCUIT DIAGRAMFIGURE 1. Styles CX06 and CX16 capacitors. AMSC N/A FSC 5910 Copyright Communications - Electronics Command Provided by IHS under lice

3、nse with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-49137/6E 2NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. The positive lead on CX06 shall be at least .125 inch (3.18 mm) longer than the negat

4、ive lead. FIGURE 1. Styles CX06 and CX16 capacitors - Continued. Case Dimensions size T W H M S Max Max Max .002 A .040 .050 .100 .007 .030 .015 B .040 .070 .125 .010 .050 .015 C .070 .120 .165 .010 .100 .020 D .075 .185 .225 .010 .150 .020 E .110 .220 .290 .016 .180 .025 F .130 .230 .310 .016 .200

5、.025 G .150 .375 .475 .016 .300 .025 Inches mm Inches mm Inches mm Inches mm .002 .007 .010 .015 .016 .020 .025 .030 0.05 0.18 0.25 0.38 0.41 0.51 0.64 0.76 .040 .050 .070 .075 .100 .110 .120 .125 1.02 1.27 1.78 1.90 2.54 2.79 3.05 3.18 .130 .150 .165 .180 .185 .200 .220 .225 3.30 3.81 4.19 4.57 4.7

6、0 5.08 5.59 5.72 .230 .290 .300 .310 .375 .475 .750 1.000 5.84 7.37 7.62 7.87 9.52 12.06 19.05 25.40 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-49137/6E 3TABLE I. Sty

7、les CX06 and CX16 characteristics. Type designation 1/ DC rated voltage (85C) Nominal capacitance Dissipation factor (max) DC leakage (max) 25C Case size CX-6A474- CX-6A225- CX-6A106- Volts 2 2 2 F .47 2.2 10.0 % 10 10 10 A .5 .5 .5 A B C CX-6B155- CX-6B685- CX-6B226- CX-6B227- 3 3 3 3 1.5 6.8 22.0

8、220.0 10 10 10 15 .5 .5 1.0 9.0 B C D G CX-6C334- CX-6C105- CX-6C475- CX-6C156- CX-6C476- CX-6C686- 4 4 4 4 4 4 .33 1.0 4.7 15.0 47.0 68.0 10 8 8 8 8 8 .5 .5 .5 1.0 2.0 3.0 A B C D E F CX-6D224- CX-6D684- CX-6D335- CX-6D106- CX-6D336- CX-6D476- CX-6D157- 6 6 6 6 6 6 6 .22 .68 3.3 10.0 33.0 47.0 150.

9、0 10 6 6 6 6 6 10 .5 .5 .5 1.0 2.0 3.0 9.0 A B C D E F G CX-6F154- CX-6F474- CX-6F225- CX-6F685- CX-6F226- CX-6F336- CX-6F107- 10 10 10 10 10 10 10 .15 .47 2.2 6.8 22.0 33.0 100.0 10 6 6 6 6 6 8 .5 .5 .5 1.0 2.0 3.0 9.0 A B C D E F G CX-6H104- CX-6H334- CX-6H155- CX-6H156- CX-6H226- CX-6H686- 15 15

10、15 15 15 15 .10 .33 1.5 15.0 22.0 68.0 10 6 6 6 6 8 .5 .5 .5 2.0 3.0 9.0 A B C E F G CX-6J104- CX-6J154- CX-6J224- CX-6J105- CX-6J335- CX-6J475- CX-6J106 CX-6J156- CX-6J476- 20 20 20 20 20 20 20 20 20 .10 .15 .22 1.0 3.3 4.7 10.0 15.0 47.0 6 6 6 6 6 6 6 6 8 .5 .5 .5 .5 1.0 1.0 2.0 3.0 9.0 B B B C D

11、D E F G CX-6K684- CX-6K225- CX-6K685- CX-6K106- CX-6K336- 25 25 25 25 25 .68 2.2 6.8 10.0 33.0 6 6 6 6 6 .5 1.0 2.0 3.0 9.0. C D E F G See footnote at end of table. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permi

12、tted without license from IHS-,-,-MIL-PRF-49137/6E 4TABLE I. Styles CX06 and CX16 characteristics. Continued. Type Designation 1/ DC rated voltage (85C) Nominal capacitance Dissipation factor (max) DC leakage (max) 25C Case size CX-6M104- CX-6M154- CX-6M224- CX-6M334- CX-6M474- CX-6M684- CX-6M105- C

13、X-6M155- CX-6M225- CX-6M335- CX-6M475- CX-6M685- CX-6M106- CX-6M156- CX-6M226- 35 35 35 35 35 35 35 35 35 35 35 35 35 35 35 .10 .15 .22 .33 .47 .68 1.0 1.5 2.2 3.3 4.7 6.8 10.0 15.0 22.0 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 .5 .5 .5 .5 .5 1.0 1.0 1.0 2.0 2.0 2.0 3.0 9.0 9.0 9.0 C C C C C D D D E E E F G G

14、G 1/ Complete type designation will include additional symbols to indicate style and capacitance tolerance. REQUIREMENTS: Dimensions and configuration: See figure 1. Case: Polyester sleeve and epoxy end filled or plastic encapsulated. Leads: Solder-coated metal. DC rated voltage: See table I. Operat

15、ing temperature: -55 to +85C. DC leakage (DCL): See table I. Capacitance (cap.): See table I. Capacitance tolerance: 10 percent (K), or 20 percent (M). Dissipation factor (DF): See table I. Terminal strength: In accordance with method 211 of MIL-STD-202. Test condition A: One-half pound for case siz

16、es A and B, 1 pound for case sizes C and D, and 2 pounds for case sizes E, F, and G. Test condition C: One-half pound applied force - 3 bends. Stability at low and high temperature: In accordance with MIL-PRF-49137. Step 1 (+25C): DCL - See table I. Cap. - Within tolerance specified in table I. DF -

17、 See table I. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-49137/6E 5Step 2 (-55C): Cap. - Within -15 percent of step 1 measured value. DF - 200 percent of table I. Ste

18、p 3 (+25C): DCL - See table I. Cap. - Within 10 percent of step 1 measured value. DF - See table I. Step 4 (+85C): DCL - 10 times 25C limit (see table I). Cap. - Within +15 percent of step 1 measured value. DF - 150 percent of table I. Step 5 (+25C): DCL - See table I. Cap. - Within 10 percent of st

19、ep 1 measured value. DF - See table I. Surge voltage: In accordance with MIL-PRF-49137. DCL - See table I. Cap. - Within 10 percent of initial value. DF - See table I. Life: Method 108 of MIL-STD-202. 1,000 hours: At 25C: DCL - 200 percent of table I. Cap. - Within 10 percent of initial measured val

20、ue. DF - See table I. Resistance to solvents: Not applicable. Marking: In accordance with MIL-PRF-49137, except that case sizes A and B, shall be marked as shown in example 1. The front shall be marked with the capacitance value coded in picofarads and the reverse shall be marked with the dc voltage

21、 and the manufacturers trademark. Case sizes C and D shall be marked as shown in example 2. The first line will contain the capacitance in picofarads and the capacitance tolerance. The second line will contain the dc voltage and the manufacturers trademark. Case sizes E, F, and G shall be marked as

22、shown in example 3. The first line will contain the part number and the second shall contain the date code (year and week), lot code, and manufacturers trademark. At the option of the manufacturer, color coding may be used to mark the capacitance, dc rated voltage, and the manufacturers trademark on

23、 case sizes A and B. The use of two lines, the first line to identify the capacitance, and tolerance, and the second line, the dc voltage and manufacturers trademark for case sizes C and D. The use of three lines to mark the date, lot code, and manufacturers trademark on case sizes E, F, and G, as l

24、ong as it is the same order as shown in the example. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-49137/6E 6Voltage groups (85C rated voltage): I-2 to 10 V inclusive II

25、-15 to 35 V inclusive NOTES: Reference documents. In addition to MIL-PRF-49137, this specification sheet references the following documents. MIL-STD-202 (Copies of these documents are available online at http:/assist.daps.dla.mil/quicksearch or http:/assist.daps.dla.mil or from the Standardization D

26、ocument Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094). Changes from previous issues. The margins of this specification are marked with asterisks to indicate where changes from previous issue were made. This was done as a convenience only and the Government assumes no liab

27、ility whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Army - CR Army

28、 - CR Navy - EC Air Force - 85 DLA - CC Agent: DLA - CC Review activities: Navy - AS, MC, OS, SH (Project 5910-2009-018) Air Force - 19 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-