ARMY MIL-T-43150 C-1991 TABLE PARACHUTE PACKING《降落伞装填台》.pdf

1、- MIL-T-43150C 71 I 999990b 049540L 9 H r: MIL-T-43150C SUPERSEDING MIL-T-43150B 27 April 1984 25 October 1991 MILITARY SPECIFICATION TABLE, Pm PACKING This specification is approved for use by all Departments and Agencies of the Department of Defense. 1. SCOPE 1.1 Scope. This specification covers t

2、he requirement for a parachute packing table. 2. APPLICABLE 2.1 Government documents. 2.1.1 Specifications, standards, and hancboks, The following specifica- Unless otherwise specified, the issues of these d0C;uments tions, standards, and hancboks form a part of this document to the extent specified

3、 herein. are those listed in the issue of the Department of Defense Index of Specifications and Standards (DODISS) and supplement thereto, cited in the solicitation (see 6.2). SPECIFICATIONS PPP-B-636 - Mxes, Shipping, Fiberboard PPP-T-4 5 - Tape, Gumned, Paper, Reinforced and Plain for Sealing and

4、Securing Beneficial comnents (recomnendations, additions, deletions) and any pertinent data which my be used in improving this document should be addressed to: Center, Natick, MA 01760-5017 by using the Standardization Document Improvemmt Proposal (DD Form 1426) appearing at the end of this document

5、 or by letter. U.S. Army Natick Research, Developnt, and Engineering AMSC N/A FSC 7195 DISTRIWION STATEMENT A. Approved for public release; distribution is unlimited. a Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-T-43150C MILITARY MIL-C-52950

6、 - Crate, Wood, Open and Covered STANDARDS MILITARY MIL-STD-105 - Sampling Procedures and Tables for Inspection by Attributes MIL-STD-129 - Marking for Shipnt and Storage MIL-STD-130 - Identification Marking of U.S. Military Property (Unless otherwise indicated, copies of federal and military specif

7、ications, standards, and handbooks are available from the Standardization Documents Order Desk, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.) 2.1.2 other Govemnt documents, drawinqs, and publications. The following other Government documents, drawings, and publications form a part o

8、f this document to the extent specified herein. the issues are those cited in the solicitation. Unless otherwise specified, DRAWINGS U.S. ARMY NATICK RES-, DEWEXDPME“, AND ENGINEERING CEIVIER 11-1-3179 - Table, Parachute Packing, Assembly 11-1-3181 - Table Top, Assembly (Copies of drawings are avail

9、able from the U.S. Army Natick Research, Developnt, and Engineering Center, Am: STRNC-UX, Natick, MA 01760- 5017. ) 2.2 Non-Government publications. The following documents form a part of Unless otherwise specified, this document to the extent specified herein. the issues of the documents which are

10、DOD adopted are those listed in the issue of the DODISS cited in the solicitation. the issues of do-129 or ASTM D 3951, as applicable. 6. NYlES (This section contains information of a general or explanatory nature that may be helpful, but is not mdatory.) 6.1 Intended use. The parachute packing tabl

11、e is intended for use in packing parachutes. multiples to accoMllodate length requirements. The design provides for the tables to be used in 6.2 Acquisition requirements. Acquisition documents must specify the following: a. Title, number, and date of this specification. b. Issue of DODISS to be cite

12、d in the solicitation, and if required, the specific issue of individual documents referenced (see 2.1.1 and 2.2). c. d. When a first article is required (see 3.1, 4.3, and 6.3). Levels of preservation and packing (see 5.1 and 5.2). 7 Provided by IHSNot for ResaleNo reproduction or networking permit

13、ted without license from IHS-,-,-MIL-T-4315QC 6.3 First article. When a first article is reyir&, it shall be inspect- ed and approved under the appropriate provisions of Federal Acquisition Regulation (FAR) 52.209-4. The first asticle should be a preprductien sample. The contracting officer should s

14、pecify the appropriate type o first article and the number of units to bc furnished. should also include specific instructions in acquisition documnts regding arrangements for selection, inspection, and approval of the first article. The contracting officer 6.4 Subject tem (kevwordl listinq. . I Aid

15、, assembly 6.5 Chanqes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue, due to the extensiveness of the changes. Custodians: Amiy-a Navy - As Air Force - 99 Preparing activity: Amry-a (Project 7195-0099) Review activities: Navy - K Air Force - 84 DIA-GS User activity: 8 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-