1、MI GT- 62087E - SUPERSEDING MIGT-62087D 28 September 1984 MILITARY SPECIFICATION TRUCK: CUMPACT FRWARD CNTRoG VAN. RECRUITER, 5.400 POUNDS GVW, 4x2, CQMMERCIAL This specification is approved for use by all Departmenta and Agencies of the Department of Defense. 1. SCOPE 1-1 SCON. This specification c
2、overs a forward control, gasoline engine driven, four-wheel, two-rear wheel drive, commercial integral cab-van-body compact type truck (recruiter) having a minimum gross vehicle weight (GVW) of 5.400 pounds- The vehicle ia equipped with an elevating or atationary raised mf section. Vehicles procured
3、 under this epecification are commercial items which are warranted by the manufacturer as specified in acquisition documents. . The following * 2.1.1 SDecifica.tionS. Flt-ds. specifications. standards. and handbooks form a part of this document to the extent specified herein. Unless otherwise specif
4、ied, the ismet3 of these Uocwnenta are those listed in the issue of the Department of Defense Index of Specifications and Standards (WDISS) and supplement thereto, cited in the solicitation (see 6.2). Beneficial comments (recomendationa, additions, deletions) and any wrtinent data which may be of ua
5、e in improving this document should be addressed to: US Army Tank-Automotive Command, Am: AMSTA-UED, Warren, MI 48397-5000, by using the self-addressed Standardization Document Improvement Propasa1 (DD Form 14261 appearing at the end of t or bv letter. AMSC N/A IpscaJml /. Approved for public releas
6、e; distribution is Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SPECIFICATIONS FEDEML W-B-131 MIL-T-b2087E 23 m 7797706 0437727 5 m c * MIL-T-62087K - Battery, Storage: Vehicular, Ignition, Lighting and Starting. MILITARY MIL-B-46176 - Brake Fluid
7、, Silicone. CTbADAFXJS FEDEFSL PEP-STD-297 - Rustproofing, Commercial (Nontactical) Vehic.les. MILITARY MIL-STD-1223 - Nontactical Wheeled Vehicles Treatment, Painting, Identification Marking, and Data Plate Standards. X (Unless otherwise indicated, copies of federal and military specifications, sta
8、ndards and handbooks are available from the Naval Publications and Forms Center, Military Specifications and Standards, Bldg. 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.5 - The .Y y#, 2-1.2 Uther bnvermt dncuents. dpap.tn. and itjnm following other Government documents, drawings, and public
9、ations form a part of this document to the extent specified herein. the issues are those cited in the solicitation- Unless otherwise specified, :#, DEPARTMENT OF DEFENCE Department of Defense Index of Specifications and Standards (WDISC). Copies of the DODISS are available on a yearly subscription b
10、asis either from the Government Printing Office for hard copy, or microfiche copies are available from the Director, Navy Publication and Printing Service Office, 700 Robbins Avenue, Philadelphia, PA 19111-5093.) DF$!W I NG5 MI LITPAY 7722352 - Receptacle Assy, Size 22, Wall type. DEPARTMENT OP TRAN
11、SWRTATION (DOT) Federal Motor Carrier Safety Regulations. Federal Motor Vehicle Safety Standards. (Application for copies of DOT publications should reference the Code of Federal Regulations, 49 CPR, and the Federal iiegister, and should be addressed to the Superintendent of Documents, U. S. Governm
12、ent Printing Office, Washington D.C. 204oL). 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ENVIE0NMk”lNTAL PROTECTION AGENCY (EPA) Control of Air Pollution front New Motor Vehicles and New Motor Vehicle Enninas. (Application for copies of EPA pub
13、lications should reference the Code of Federal Regulations, 40 CFR, and the Federal Reaister and should be addressed to the Superintendent of Documents. U.S. Government Printing Office, Washington, D- C. 20402 1 * 2.2 Bm-Government -nati- - The following documents form a part of this document to the
14、 extent specified herein- the issues of the documents which are WD adopted are those listed in the issue of the DODISS cited in the solicitation. the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2). Unless otherwise specified, Unless o
15、therwise specified, * THE EUROPEAN TYRE AND RIM TECHNICAL ORGANISATION (?TRT) Standards Manual (Application for copies of the ETRm publications should be addressed to the European !$me and Rim Technical Organisation. 32, Avenue Brumm, 1060 Bmiasels, Belgium.) NATIONAL FIRG PROTECTION ASSXIATION (NFP
16、A) No, 70 - National Electrical Code. Application for copies of NFPA publications ahould be addressed to National Fire Protection Association International, Batterymarch Park, Buincy. MA 02269 1. . SAE. INC. SAE Standards and Recommended Practices, 5537 - Storage Batteries. J551 - Performance Levels
17、 and Methods of Measurement of Electromagnetic Radiation from Vehicles and Devices (30-1000 MHz). .- Engine Power Test Code - Spark Ignition and Diesel, 51349 (Application for copies of CAE: publications should be addressed to SAE, Inc, 400 Commonwealth Drive, Warrendale. PA 15096.) STATE OF CALIFOR
18、NIA Vehicle Code of California (Application for copies of State of California mblications should be addressed to the Department of Motor Vehicles. 2570 24th Street, Sacramenta, CA 95809.) 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MI L-T-62087
19、E THE TIRE AND RIM ASSOCIATION, INC. Year Eoolr:. (Application for copies of Tire and Rim Association publications should be addressed to The Tire and Rim Association, Inc., 3200 W. Market Street, Akron OH 44313.) *. from the organizations that prepare or distribute the documents. documents also may
20、 be available in or through libraries or other informational services.) (Non-Government standards and other publications are normally available These :#. this document and the references cited herein, th text of this document takes precedence. Nothing in this document, however, supersedes applicable
21、 laws and regulations unless a specific exemption has been obtained. 2.3 body; and ful cDmpiernent, 3f kel. iubricants , an coolam . . 1 p - .-I-rrn i c.nna 1- The vehicle shall comply with EPA regulations governing Control of Air ?olhticn from New Motor Vehicles and New Mumr Vehicle Engines in effe
22、ct on the date of manufacture. -reE,iclrs destineci ior Caiiforaia snail comply with State of California -re,suiatians governing zlir pollution control i-L effect on the date of manuiELctilre In addition. - 3,Z-s ceve 1. The interior sound 3.evel shall conform to Ferlerai Motor Carrier Safety Regula
23、tion 393.94. snail not excee the noise limits established by the California Vehicle PAranslucent reservoir shall be provided in a position readily visible for checking the coolant level. sy 8 tem I A The translucent reservoir shall be part of the coolant recovery Provided by IHSNot for ResaleNo repr
24、oduction or networking permitted without license from IHS-,-,-e. e e MIL-T-62087E 23 M 7777906 0437734 7 M MIIrT-62087E * 3-4.1.2 -h. A fan clutch shall be provided. The fan clutch lili grab kmdles in addition to xhe :*oar Qgerattng hardies, shall be provided for the driver and assistant rfrher. Spl
25、it type double doors or a sliding door, with windows capable of -x-ing awned, shail be furnishe on the curbside of the cargo space. Split type double doors. with windows capable of being opened, shall be furnisherj at the rear of %he cargo space- t.0 curbsirle door windows shall be capable of being
26、opened. aoidings shall be provided above the doors and windows that own. double doors or the sliding door shall be capable o being opened from the inside. .=rangement, An assistant drivers seat shall be furnished. Two pairs of lap type seat belts shail be installed. of %he driver-s seat, shall Me no
27、t less than 100 inches in length, 53 irlcnes in width (exclusive of wheeihousingsj, and 52 inches in height. Street and The windows an the street side correspnciing Full length drip (=urbsirle Ali doors shall incorporate manufacuurer *s standard key locking Cargo space, immediately to the rear Provi
28、ded by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-_I_- - NIL-T-6207E 23 m 7777706 04177.37 4 m MIL-T-62087E 3.5.1 LIQ . Anti-slip vinyl tile flsoring, harmonizing with interior color, with aluminum bead border shall be furnished in the cargo epace. Manufact
29、urers standard harmonizing color board paneling shall be installed on a11 interior surfaces except an the curbside ioading doors. The raiscd portion of the roof shall The roof material shall The top shall be provided with fiper board molding on side roof sills The interior surface of the top shall b
30、e painted. The vent shall be . - 3-5-21 Bbzh. A wooden frame bench, covered with a harmonizing vinyl upholstered cushion, shall be furnished across the rear of the cargo space. Seat belts and seat belt anchors are not required for the bench- The bench anci seat back shall be securely attached to pre
31、vent movement when the vehicle is in transit. 3.5.4 Desk . A light weight, table-top type desk and a castered, upholstered secretarial stool with back rest shall be furaished. The desk shall be approximately 54 inches long by 24 inches wide by 30 inches high, and shall be equipwd with two drawers on
32、 the right hand side. The top drawer shall be approximately 13 inches wide by 6 inches high and full desk width in length. The bottom drawer shall be approximately 13 inches wide by i2 inches high and full desk width in length- The desk drawers shall be equipped with lunreme- . Three UO-volt ac, 20-
33、watt fluorescent lights shall be provided. of the vehicle. ne unit shall be located on each side of the vehicle. mrxinted to the side of center, and spaced to give even illumination. unit shall be located near the desk. A light switch shall- be provided, operable from the drivers seat. The fixtures
34、shall be alined parallel to the sides One Lights and fixtures shali not project more - th 4 inches below the original vehicle roof. 6.2). an auxiliary 24-volt system with a shielded wiring harness and radio outlet shall be-furnished. and shall be marked with pressure sensitive tape: “24 VOLT RADIO O
35、UTLET,“ The rceptacle shall be located on the side opposite the driver on the instrument panel in the cab. to the receptacle and the 24-volt system. The auxiliary 24-volt system output capacity shall be not less than 20 amperes. supply, operable from the vehicle electrical system, shall be furnished
36、. - . When specified (see Auxillamr 24 volt svfitem with radin ou 3.5.6 The receptacle shall conform to Drawing 7722352, The shielded wiring harness shall be connected A converter type power 3.5.7 J filling and charging of battery; alinement of front wheels; inflation of all tires; complete lubricat
37、ion of chassis, sngine and running gear with gradas of lubricants recommended for the ambient air temperature at the delivery point; servicing of cooling system with a solution of ethylene glycol ty-pe antifreeze and water in equal parts by volume; and servicing of windshield washer reservoir with w
38、ater and appropriate additives. alinement of lights; 3.7 WorkmanshiD . Defective components or parts and assemblies which have been repaired or modified to overcome deficiencies sh1.l not be furnished. Welded, bolted, and riveted construction utilized shall be in accordance with the highest standard
39、s of the industry. . 4. QUALITY ASSURANCE PROVISIONS 4.1 -tv for insre ctla . Unless otherwise specified in the 44, contract, the contractor is responsible for the performance of all inspection requirements (examinations and tests) as specified herein. otherwise specified in the contract, the contra
40、ctor may use his own or my other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government - reserves the right to perform any of the inspections set forth in the spcification where such inspections are deemed necessary to assure su
41、pplies anci services conform to prescribed requirements. Except as The Government . All items must meet all * 4.1.1 -tv for comdhzam requirements of sections 3 and 5. syecification shall become a part of the contractors overall inspection system or quality program. specification shall not relieve th
42、e contractor of the responsibility for ensuring that all products or supplies submitted to the Government for acceptance comply with all requirements of the contract. inspection, as part of manufacturing operations, is an acceptable practice to ascertain conformance requirements, however, this does
43、not authorize submission of known defectiw material, either indicated or actual, nor does it commit the Government to acceptance of defective material. 4.1 The inspection set forth in this The absence of any inspection requirements in the Sampling Provided by IHSNot for ResaleNo reproduction or netw
44、orking permitted without license from IHS-,-,-I. 4-2 -I t. . Quality assmaice operations performed by the contracxor will .be subject to Government verification at unscheduled intervals- determine zhat practices. methods, and procedures of the contractors inspection are being properly zpplied. corre
45、ct product deficiencies diseavered shall be cause for suspension of acceptance .until correction has been made or until conformance of product to sxecification criteria has been demonstrated, Verification will consist of cabsemation of the oprations to Failure of the contractor to proaptly 4.3 Erst
46、Dro of its rights under the provisions of the contract, The purpose * 4-3.1 rion vehicle with payload where such inspections are deemed necessary to assure the vehicle will operate in accordance with the contractual requirements. The Government a. ncv s-ress ion verLtlQn The vehicle manufacturer shall indicate on the military questionnaire (commercial vehic.le engineering datal if the vehicle will be suppressed to limit electromagnetic r - MC Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1