1、 AS/NZS 60335.2.17:2004 (Incorporating Amendment No. 1) Australian/New Zealand StandardHousehold and Similar Electrical AppliancesSafety Part 2.17: Particular requirements for blankets, pads and similar flexible heating appliances AS/NZS 60335.2.17:2004Accessed by ISONET - CHINA STATE BUREAU OF TECH
2、NICAL SUPERVIS on 29 Oct 2007AS/NZS 60335.2.17:2004 This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL-002, Safety of Household and Similar Electrical Appliances and Small Power Transformers. It was approved on behalf of the Council of Standards Australia on 18 M
3、arch 2004 and on behalf of the Council of Standards New Zealand on 26 March 2004. This Standard was published on 21 May 2004. The following are represented on Committee EL-002: Australian Industry Group Australian Retailers Association Australian Electrical and Electronic Manufacturers Association B
4、usiness New Zealand Consumer Electronic Suppliers Association, Australia Consumers Federation of Australia Electrical regulatory authorities, Australia Electrical Compliance Testing Association Electrical consultants Electricity Supply Association of Australia Ministry of Consumer Affairs, New Zeala
5、nd Keeping Standards up-to-date Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn.
6、It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased. Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Web Shop at .
7、au or Standards New Zealand web site at www.standards.co.nz and looking up the relevant Standard in the on-line catalogue. Alternatively, both organizations publish an annual printed Catalogue with full details of all current Standards. For more frequent listings or notification of revisions, amendm
8、ents and withdrawals, Standards Australia and Standards New Zealand offer a number of update options. For information about these services, users should contact their respective national Standards organization. We also welcome suggestions for improvement in our Standards, and especially encourage re
9、aders to notify us immediately of any apparent inaccuracies or ambiguities. Please address your comments to the Chief Executive of either Standards Australia or Standards New Zealand at the address shown on the back cover. This Standard was issued in draft form for comment as DR 03936. Accessed by I
10、SONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 2007AS/NZS 60335.2.17:2004 (Incorporating Amendment No. 1) Australian/New Zealand StandardHousehold and Similar Electrical AppliancesSafety Part 2.17: Particular requirements for blankets, pads and similar flexible heating appliances COPYRIG
11、HT Standards Australia/Standards New Zealand All rights are reserved. No part of this work may be reproduced or copied in any form or byany means, electronic or mechanical, including photocopying, without the writtenpermission of the publisher. Jointly published by Standards Australia, GPO Box 476,
12、Sydney, NSW 2001 and StandardsNew Zealand, Private Bag 2439, Wellington 6020 ISBN 0 7337 6143 7 Originated in Australia as AS C1641960. Previous Australian edition as AS 31641960. Originated in New Zealand as NZS 1302-1962. Previous New Zealand edition NZS 6317-1988. Jointly revised and redesignated
13、 AS/NZS 3164:1994. Jointly revised and redesignated in part as AS/NZS 3350.2.17:2000. Jointly revised and redesignated in part as AS/NZS 60335.2.17:2004 Reissued incorporating Amendment No. 1 (October 2006). Accessed by ISONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20072CONTENTS FOREWO
14、RD.4 INTRODUCTION.6 1 Scope 7 2 Normative references .7 3 Definitions8 4 General requirement.10 5 General conditions for the tests 10 6 Classification11 7 Marking and instructions.12 8 Protection against access to live parts 14 9 Starting of motor-operated appliances.14 10 Power input and current14
15、11 Heating 14 12 Void .17 13 Leakage current and electric strength at operating temperature .17 14 Transient overvoltages .17 15 Moisture resistance 17 16 Leakage current and electric strength .18 17 Overload protection of transformers and associated circuits 19 18 Endurance19 19 Abnormal operation
16、19 20 Stability and mechanical hazards 23 21 Mechanical strength .23 22 Construction.29 23 Internal wiring.31 24 Components.32 25 Supply connection and external flexible cords .32 26 Terminals for external conductors .33 27 Provision for earthing33 28 Screws and connections .33 29 Clearances, creepa
17、ge distances and solid insulation .33 30 Resistance to heat and fire .33 31 Resistance to rusting 36 32 Radiation, toxicity and similar hazards 36 Accessed by ISONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20073Annexes .50 Annex A (informative) Routine tests .50 Annex AA (normative) Spe
18、cification for the thermal insulation.49 Annex BB (normative) Equipment for the mechanical strength test for blankets .52 Annex ZZ (informative) Variations to IEC 60335-2-17:2002 for application in Australia and New Zealand56 Bibliography .55 Figure 101 Symbol for “Do not use folded or rucked“ 37 Fi
19、gure 102 Symbol for “Do not insert pins“37 Figure 103 Void .38 Figure 104 Arrangement for measuring leakage current and electric strength of the flexible part 39 Figure 105 Arrangement for the three-thickness fold test 40 Figure 106 Examples showing the position of the thermal insulation on ruck-res
20、istant blankets and mattresses .41 Figure 107 Examples of folds and the position of the thermal insulation on pads .42 Figure 108 Tumbling barrel for testing the mechanical strength of pads.43 Figure 110 Shape of the sample for the tear resistance test45 Figure 111 Equipment for flexing heating elem
21、ents and internal wiring 46 Figure 112 Arrangement for the rigidity test of ruck-resistant blankets.47 Figure 113 Equipment for the spark ignition test .48 Figure 113a Details of the mask .49 Figure BB.1 Equipment for the mechanical strength test of blankets53 Figure BB.2 Detail of the drum and cyli
22、nders 54 Figure BB.3 Detail of the clamping bar .54 Table 101 Maximum temperatures15 Table 102 Maximum temperature rises .16 Table A.101 Test voltages50 Accessed by ISONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20074AUSTRALIA/NEW ZEALAND STANDARD _ HOUSEHOLD AND SIMILAR ELECTRICAL APPL
23、IANCES SAFETY Part 2.17: Particular requirements for blankets, pads and similar flexible heating appliances FOREWORD This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee EL-002 - Safety of Household and Similar Electrical Appliances and Small Power Transformers
24、 to supersede AS/NZS 3350.2.17:2000, seven years from the date of publication. During this seven year period either AS/NZS 3350.2.17:2000 or AS/NZS 60335.2.17:2004 may be used for regulatory purposes in both Australia and New Zealand. This Standard incorporates Amendment No. 1 (October 2006). The ch
25、anges required by the amendments are indicated in the text by a marginal bar and amendment number against the clause, note, table, figure or part thereof affected. Where an application date other than immediate is applicable to an amendment the date of application (DOA) is indicated by the marginal
26、bar against the part affected. The objective of this Standard is to provide manufacturers, designers, regulatory authorities, testing laboratories and similar organizations with safety requirements designed to give the user protection against hazards that might occur during normal operation and abno
27、rmal operation of the appliance and which may be used as the basis for approval for sale or for connection to the electricity supply mains in Australia and New Zealand. This Standard is an adoption with national modifications and contains the full text of the second edition of IEC 60335-2-17:2002, H
28、ousehold and similar electrical appliances Safety Part 2-17: Particular requirements for blankets, pads and similar flexible heating appliances and its amendment 1 and has been varied as indicated to take account of Australian and New Zealand conditions. It is to be used in conjunction with the late
29、st edition of AS/NZS 60335.1, Household and similar electrical appliances Safety Part 1: General requirements and its Amendments. It was established on the basis of AS/NZS 60335.1:2002. This part 2 supplements or modifies the corresponding clauses of AS/NZS 60335.1 (referred to as part 1 in this par
30、t 2) so as to convert it into the Australian/New Zealand Standard: Safety of blankets, pads and similar flexible heating appliances. NOTE 1 When “Part 1” is mentioned in this standard, it refers to AS/NZS 60335.1. When a particular subclause of Part 1 is not mentioned in this Part 2, that subclause
31、applies as far as is reasonable. When this standard states “addition“, “modification“, or “replacement“, the relevant text in Part 1 is to be adapted accordingly. NOTE 2 The following numbering system is used: subclauses, tables and figures that are numbered starting from 101 are additional to those
32、 in Part 1; unless notes are in a new subclause or involve notes in Part 1, they are numbered starting from 101, including those in a replaced clause or subclause; additional annexes are lettered AA, BB, etc. NOTE 3 The following print types are used: requirements: in roman type; Accessed by ISONET
33、- CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20075 test specifications: in italic type; notes: in small roman type. Words in bold in the text are defined in clause 3. When a definition concerns an adjective, the adjective and the associated noun are also in bold. The numbering of clauses, su
34、bclauses, notes, tables, figures and annexes follows that of IEC 60335-2-17 Ed 2.1. To allow for the introduction of additional material by the IEC, the numbers 101 to 200 have been reserved. To allow for additional material to be introduced by Australia and New Zealand, the numbers 201 to 300 are u
35、sed to number further clauses, subclauses, notes, tables and figures in part 1. The numbers 301 to 400 are used to number further clauses, subclauses, notes, tables and figures in this part 2. Additional annexes are lettered ZA, ZB and so on. This scheme has been introduced to reduce the likelihood
36、of the IEC and Australia and New Zealand using the same identifier for different purposes. The use of the word VOID indicates that the IEC text is not used in Australia or New Zealand. The use of this word also avoids the need to renumber, clauses, notes, tables and figure if an earlier clause, note
37、, table or figure is not used. Clause 2 and the bibliography have been reformatted to indicate the Australia/New Zealand standard that is equivalent to the IEC standard or ISO standard to which normative reference is made. As this Standard is reproduced from an International Standard, the following
38、applies: (a) Its number does not appear on each page of text and its identity is shown on the cover and title page only. (b) In the source text “this International Standard“ should read “this Australian/New Zealand Standard“. A full point substitutes for a comma when referring to a decimal marker. V
39、ariations to IEC 60335-2-17 Ed 2.1 are indicated at the appropriate places throughout this standard. Strikethrough (example) identifies IEC tables, figures and passages of text which, for the purposes of this Australian/New Zealand standard are deleted. Where Australian/New Zealand tables, figures o
40、r passages of text are added, each is set in its proper place and identified by shading (example). Added figures are not themselves shaded, but are identified by a shaded border. Variations made to IEC 60335-2-17 Ed 2.1 form the Australian variations for the purposes of the IECEE scheme for recognit
41、ion of testing to standards for safety of electrical equipment (the CB scheme). These variations have been incorporated in the body of the standard. They are listed in Annex ZZ for easy reference. Accessed by ISONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20076INTRODUCTION It has been a
42、ssumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radi
43、ation of appliances when operated as in normal use taking into account the manufacturers instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard take
44、s into account the requirements of AS/NZS 3000 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules may differ. If an appliance within the scope of this standard also incorporates functions that ar
45、e covered by another part 2 of AS/NZS 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one function on the other is taken into account. This standard is a product family standard dealing with the safety of appliances and take
46、s precedence over horizontal and generic standards covering the same subject. An appliance that complies with the text of this standard will not necessarily be considered to comply with the safety principles of the standard if, when examined and tested, it is found to have other features that impair
47、 the level of safety covered by these requirements. An appliance employing materials or having forms of construction differing from those detailed in the requirements of this standard may be examined and tested according to the intent of the requirements and, if found to be substantially equivalent,
48、 may be considered to comply with the standard. The essential safety requirements in AS/NZS 3820 that could be applicable to blankets, pads and similar flexible heating appliances are covered by this standard. Accessed by ISONET - CHINA STATE BUREAU OF TECHNICAL SUPERVIS on 29 Oct 20077COPYRIGHT STA
49、NDARDS AUSTRALIA/STANDARDS NEW ZEALAND HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES SAFETY Part 2.17: Particular requirements for blankets, pads and similar flexible heating appliances 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric blankets, pads and other flexible appliances that heat the bed or human body, for household and similar purposes, their rated voltage being not more than 250 V. This standard also applies to
copyright@ 2008-2019 麦多课文库（www.mydoc123.com）网站版权所有
备案/许可证编号：苏ICP备17064731号-1