ASD-STAN PREN 3841-402-2003 Aerospace Series Circuit Breakers Test Methods Part 402 Corrosion (Edition P 3)《航空航天系列 断路器 试验方法 第402部分 腐蚀 第P3版》.pdf

1、AECMA STANDARD NORME AECMA AECMA NORM Edition approved for publication 14 March 2003 prEN 3841-402 Edition P 3 March 2003 Comments should be sent within six months after the date of publication to Electrical Domain AECMA-STAN ICs: 49.060 Descriptors: Srie arospatiale Disjoncteurs Mthodes dessais Par

2、tie 402 : Corrosion Supersedes edition P 2 September 1998 ENGLISH VERSION Aerospace series Circuit breakers Test methods Part 402: Corrosion Luft- und Raumfahrt Schutzschalter Prfverfahren Teil 402: Korrosion This “Aerospace Series“ Prestandard has been drawn up under the responsibility of AECMA-STA

3、N (The European Association of Aerospace Industries - Standardization). It is published on green paper for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequent to the publication of this Prestandar

4、d, the technical content shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard. After examination and review by users and formal agreement of AECMA-STAN it will be submitted as a draft European Standard to CEN (Eu

5、ropean Committee for Standardization) for formal vote. I I Copyright 2003 O by AECMA-STA1 Page 2 prEN 3841-402: 2003 Foreword This standard was reviewed by the Domain Technical Coordinator of AECMA-STANS Electrical Domain. After inquiries and votes carried out in accordance with the rules of AECMA-S

6、TAN defined in AECMA- STANS General Process Manual, this standard has received approval for Publication. Page 3 prEN 3841-402: 2003 1 Scope This standard specifies a method of verifying the ability of circuit breakers to withstand a corrosion test. It shall be used together with EN 3841-100. 2 Norma

7、tive references This European Standard incorporates by dated or undated reference provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of a

8、ny of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. IS0 7137, EN 3841-100, Aircraft - Environmental conditions and test procedures for airborne equipment) Aer

9、ospace series - Circuit breakers - Test methods - Patt 700: General 2) 3 Method 3.1 Mounting The circuit breakers shall be placed in the chamber preferably without a support (or on a non-metallic support). 3.2 Procedure The circuit breakers shall be tested in the ON position. The salt spray test sha

10、ll be carried out according to test procedure 1.9 of IS0 7137. The technical specification shall specify the category. 3.3 Requirement Requirements in accordance with technical specification and product standard. 1) Endorsement of EUROCAEIED-14C and RTCNDO-160C 2) Published as AECMA Prestandard at the date of publication of this standard