ASD-STAN PREN 4165-016-2003 Aerospace series Connectors electrical rectangular modular Operating temperature 175 Degrees C continuous Part 016 Double oval chimney for accessory (1 .pdf

1、AECMA STANDARD NORME AECMA AECMA NORM Edition approved for publication 28 February 2003 prEN 41 65-01 6 Edition P 1 February 2003 Comments should be sent within six months after the date of publication to Electrical Domain AECMA-STAN ICs: 49.060 Descriptors: ENGLISH VERSION Aerospace series Connecto

2、rs, electrical, rectangular, modular Operating temperature 175 OC continuous Part O1 6: Double oval chimney for accessory (1 per 2 modules) Product standard Srie arospatiale Connecteurs lectriques rectangulaires modulaires Temprature dutilisation 175 OC continu Partie 016 : Chemines ovales pour acce

3、ssoires (1 pour 2 modules) Norme de produit Luft- und Raumfahrt Elektrischer Rechtecksteckverbinder in modularer Bauweise Betriebstemperatur 175 OC konstant Teil 016: Zugentlastung, ovale, fr zwei Module Produktnorm This “Aerospace Series“ Prestandard has been drawn up under the responsibility of AE

4、CMA-STAN (The European Association of Aerospace Industries - Standardization). It is published on green paper for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequent to the publication of this Pre

5、standard, the technical content shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard. After examination and review by users and formal agreement of AECMA-STAN it will be submitted as a draft European Standard to

6、CEN (European Committee for Standardization) for formal vote. Page 2 prEN 4165-016: 2003 Foreword This standard was reviewed by the Domain Technical Coordinator of AECMA-STANS Electrical Domain. After inquiries and votes carried out in accordance with the rules of AECMA-STAN defined in AECMA- STANS

7、General Process Manual, this standard has received approval for Publication. Contents Page 1 Scope 2 Normative references . 3 Terminology 4 Required characteristics 5 Double oval chimney for accessories . 6 Designation . 7 Marking . 8 Technical specification Page 3 prEN 41 65-01 6: 2003 1 Scope This

8、 standard defines the double oval chimney for accessories (1 per 2 modules) used in the family of rectangular electrical connectors. The connector accessory body corresponding to those oval chimneys are defined in EN 4165-014. 2 Normative references This European Standard incorporates by dated or un

9、dated reference provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when

10、 incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to apply. EN 2424, EN 41 65-001, EN 41 65-002, EN 41 65-01 4, Aerospace series - Marking of aerospace products Aerospace series - Connectors, electrical, rectangular, modular - Operati

11、ng temperature I75 “C continuous - Part 001: Technical specification - Product standard 1 ) Aerospace series - Connectors, electrical, rectangular, modular - Operating temperature I75 “C continuous - Part 002: Specification of performance and contact arrangements 1) Aerospace series - Connectors, el

12、ectrical, rectangular, modular - Operating temperature 175 “C continuous - Part 014: Shielded accessory body, 2 and 4 modules for connectors, series 2 and series 3 - Product standard 1) 3 Term in ol ogy See EN 4165-001. 4 Required characteristics Dimensions are in millimetres. 1) Published as AECMA

13、standard at the date of publication of this standard Page 4 prEN 4165-016: 2003 5 See Figure 1. Double oval chimney for accessories Key 1 inside section 70,8 mm2 2 hexagonal clip, thread 0 0,6 3 inside section 190,6 rnm2 Figure 1 Page 5 prEN 41 65-01 6: 2003 Table 1 - Oval chimney for accessory clas

14、s I I I Class I Description I I W F Oval chimney for accessory with housing (shell) olive drab cadmium plated, aluminium alloy, conducting finish, 500 hours resistance to salt mist, maximum operating temperature 175 “C continuous Oval chimney for accessory with housing (shell) black nickel plated, aluminium alloy, 96 hours resistance to salt mist, maximum operating temperature 175 “C continuous 6 Designation EXAMPLE: 7 Marking Unless there are other specific contractual requirements, the marking shall be in accordance with EN 2424, category P. 8 Technical specification See EN 4165-001.