ASTM C476-2010 Standard Specification for Grout for Masonry《圬工灰浆的标准规范》.pdf

1、Designation: C476 10Standard Specification forGrout for Masonry1This standard is issued under the fixed designation C476; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates

2、the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the Department of Defense.1. Scope*1.1 This specification covers two types of grout, fine andcoarse grout, for use in the co

3、nstruction of masonry structures.Each type (fine and coarse) is further classified as conventionalgrout (requiring mechanical consolidation by puddling orvibration when placed) and self-consolidating grout (not re-quiring mechanical consolidation when placed). Conventionalgrout is specified by (1) p

4、roportions or (2) strength require-ments. Self-consolidating grout is specified by strength re-quirements.1.2 The text of this specification references notes andfootnotes that provide explanatory material. These notes andfootnotes (excluding those in tables and figures) shall not beconsidered as req

5、uirements of this specification.1.3 The values stated in inch-pound units are to be regardedas standard. The values given in parentheses are mathematicalconversions to SI units that are provided for information onlyand are not considered standard.2. Referenced Documents2.1 ASTM Standards:2C5 Specifi

6、cation for Quicklime for Structural PurposesC143/C143M Test Method for Slump of Hydraulic-CementConcreteC150 Specification for Portland CementC207 Specification for Hydrated Lime for Masonry Pur-posesC260 Specification for Air-Entraining Admixtures for Con-creteC404 Specification for Aggregates for

7、Masonry GroutC494/C494M Specification for Chemical Admixtures forConcreteC595 Specification for Blended Hydraulic CementsC618 Specification for Coal Fly Ash and Raw or CalcinedNatural Pozzolan for Use in ConcreteC989 Specification for Slag Cement for Use in Concreteand MortarsC1019 Test Method for S

8、ampling and Testing GroutC1157 Performance Specification for Hydraulic CementC1611/C1611M Test Method for Slump Flow of Self-Consolidating Concrete3. Materials3.1 Materials used as ingredients in grout shall conform tothe requirements specified in 3.1.1-3.1.8.3.1.1 Cementitious MaterialsCementitious

9、 materials shallconform to one of the following specifications:3.1.1.1 Portland CementType I, IA, II, IIA, III, and IIIAof Specification C150.3.1.1.2 Blended CementsType IS, IS(MS), IS-A, IS-A(MS), IP, or IP-A of Specification C595 or types GU, HE,MS, or HS of Specification C1157.3.1.1.3 QuicklimeSp

10、ecification C5.3.1.1.4 Hydrated LimeType S of Specification C207.3.1.1.5 Coal Fly Ash or Raw Calcined Natural PozzolanSpecification C618. Addition rates shall be in an amountgoverned by the portland-pozzolan cement category of Speci-fication C595. The grout produced with blends of portlandcement and

11、 fly ash or raw calcined natural pozzolan shall havethe compressive strength specified (4.2.1.2 or 4.2.2.1).3.1.1.6 Granulated Blast Furnace SlagSpecificationC989. Addition rates shall be as governed by the portland blastfurnace slag cement category of Specification C595. Groutsproduced with blends

12、of portland cement and granulated blastfurnace slag shall have the compressive strength specified(4.2.1.2 or 4.2.2.1).3.1.2 Air-Entraining AdmixturesAir-entraining admix-tures shall conform to Specification C260.3.1.3 AggregatesAggregates shall conform to Specifica-tion C404.1This specification is u

13、nder the jurisdiction of ASTM Committee C12 onMortars and Grouts for Unit Masonry and is the direct responsibility of Subcom-mittee C12.05 on Grout cement; compressive strength; grout; ma-sonry; portland cement; proportions; self-consolidating groutSUMMARY OF CHANGESCommittee C12 has identified the

14、location of selected changes to this standard since the last issue (C476 09)that may impact the use of this standard. (Approved June 1, 2010.)(1) Subsection 1.1 was revised to clarify types of grout.(2) Conformance to C494/C494M Type S for viscosity-modifying admixtures in self-consolidating grout w

15、as added to3.1.5.1.(3) Additional information on C494/C494M Type S specifica-tion was added to Note 1.(4) Subsection 5.2.1.2 was revised to clarify the provisions forjob site mixing of self-consolidating grout.(5) Note 4 was added to provide guidance on the use of the T50value for self-consolidating

16、 grout. Subsequent notes wererenumbered accordingly.C476 103ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such pa

17、tent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited ei

18、ther for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair

19、 hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this stan

20、dard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the ASTM website (www.astm.org/COPYRIGHT/).C476 104