ASTM D3897-2017 Standard Practice for Calculation of Basicity of Chrome Tanning Liquors《铬鞣液碱度计算的标准实施规程》.pdf

1、Designation: D3897 17Standard Practice forCalculation of Basicity of Chrome Tanning Liquors1This standard is issued under the fixed designation D3897; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A num

2、ber in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This practice is intended to show how the results of thechromium analysis (Test Methods D3898 or D6019) and theacidity determination (Test

3、 Method D3913) can be combinedto permit calculation of the basicity of a chrome tanning liquor.1.2 The values stated in SI units are to be regarded asstandard. No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns, if any,

4、associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety, health, and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accor-dance with internationall

5、y recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade (TBT) Committee.2. Referenced Documents2.1 ASTM Standards:2D3898 Test Met

6、hod for Chromic Oxide in Basic ChromiumTanning LiquorsD3913 Test Method for Acidity in Basic Chromium TanningLiquorsD6019 Test Method for Determination of Chromic Oxide inBasic Chromium Tanning Liquors (Ammonium PersulfateOxidation)3. Significance and Use3.1 Basicity is a ratio. In any chromic salt

7、solution, theelectrovalence of the chromium (+3) is satisfied by the hy-droxyl ions and by acid ions. The extent to which thiselectravalence is satisfied by the hydroxyl ions, expressed as apercentage, is the basicity. The basicity of a chrome tanningliquid is closely related to the tanning behavior

8、 of the solution.4. Procedure4.1 Determine the chromic oxide as described in TestMethod D3898 or D6019. Determine the acid as described inTest Method D3913.5. Results5.1 The basicity of the liquor shall be expressed accordingto the Schorlemmer system. In this system, the basicity is theper cent of t

9、he total chromic oxide that is combined withhydroxyl and is calculated as follows:Basicity, % 5A 2 BA3100 (1)where:A = the amount of thiosulfate, as mL of 0.1 N solutionrequired to titrate the 25 mL aliquot as the specimen inTest Methods D3898 or D6019,B = the amount of sodium hydroxide, as mL of 0.

10、1 Nsolution required to titrate the 25 mL aliquot of thespecimen in Test Method D3913.6. Precision and Bias6.1 Because basicity is in effect a ratio, the precisionindexes are transmitted by the laws governing ratios. If theprecision of accuracy of the chromic oxide determination or ofthe titratable

11、acidity is expressed in the same relative units; forexample, percent of value being determined, the precision withwhich the basicity is known will be:PB5 =PCR21PA2(2)where:PA= precision of acidity in basic chromium tanning liquors,PCR= precision of chromic oxide in basic chromium tanningliquors,PB=

12、precision of basicity in basic chromium tanning li-quors.6.2 For the reported reproducibility figures for the chromicoxide from Test Method D3898 ( = 0.90 %) and for acidity1This practice is under the jurisdiction ofASTM Committee D31 on Leather andis the direct responsibility of Subcommittee D31.06

13、 on Chemical Analysis.Current edition approved Sept. 1, 2017. Published October 2017. Originallyapproved in 1991. Last previous edition approved in 2012 as D3897 - 91(2012).DOI: 10.1520/D3897-17.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at

14、serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United StatesThis international standard was developed in accordan

15、ce with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.1from Test Method D3913 (Procedure I

16、, = 1.84 %), Bis givenas 2.05 %. This number has the units of basicity. Similarly,repeatability has = 0.52 % basicity. Caution should be em-ployed in insisting on extremely close agreements betweenlaboratories or replicates unless a background of high precisionhas been established.37. Keywords7.1 ba

17、sicity; chrome tanning liquor; SchorlemmerASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and t

18、he riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision

19、of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shoul

20、dmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtain

21、ed by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ W. H., The Journal of the Leather Chemists Assoc., Vol 56, 1961, p.568.D3897 172